Ryobi Outdoor ZRRY41002 manual Troubleshooting, Solution

Page 16

Page 16

Grass wraps around the at- tachment shaft and the trim- mer head assembly

Screw threads are dirty or dam- aged.

Cutting tall grass at ground level.

Retaining cap is hard to turn

Line will not advance when tap 1. Line is welded to itself.

retaining cap2. Not enough line on spool. 3. Line is worn too short.

4. Line is tangled on spool.

POSSIBLE CAUSE

PROBLEM

TROUBLESHOOTING

1.Lubricate with a silicone spray.

2.Install more line (Refer to “Replacing the Cut- ting Line” earlier in this manual).

3.Pull lines while alternately pressing down on and releasing spool retainer.

4.Remove line from spool and rewind (Refer to “Replacing the Cutting Line” earlier in this manual).

Clean threads and lubricate with grease. If no improvement, replace spool retainer.

Cut tall grass from the top down.

Image 16

Contents Operators Manual Table of Contents IntroductionGeneral Safety Rules Specific Safety RulesSpecific Trimmer Safety Rules Read ALL InstructionsElectrical Safety Rules Maintenance RulesService Rules Storage and Transportation RulesSymbols Symbol Name ExplanationService Specifications UnpackingDrive Shaft and Cutting Head InstructionsFeatures Assembly Connecting the Attachment to the Upper ShaftRemoving the Attachment from the Upper Shaft Attaching the Front HandleExtension Cord Retainer Attaching the Grass DeflectorMethod of Securing Extensioncord Operation Starting and Stopping the TrimmerOperating the Trimmer Cutting TipsAdvancing the Cutting Line Manually Advancing the Cutting Line AUTO- MaticallyRetaining CAP Line CUT OFF Blade Grass Deflector Line Trimming CUT- OFF BladeMaintenance Cleaning the TrimmerServicing the Trimmer Replacing the Cutting LineReplacing the Spool Drive Shaft Trimmer Head SpoolTroubleshooting SolutionReplacement Parts AccessoriesOptional Attachments Warranty Limited Warranty StatementPage Service Ryobi Technologies INC