ASSEMBLY INSTRUCTIONS
ADJUSTING THE D-HANDLE
1. Hold the unit in the operating position (Fig. 1).
Fig. 1
2.Loosen the wing nut (Fig. 2). It is not necessary to remove the wing nut, washer or bolt.
3.Position the
D Handle 
Wing Nut
Fig. 2
MOUNTING THE CHARGING STATION
NOTE: Mount the charging unit and allow the unit to charge for at least 36 hours prior to first use.
This unit may stay on the charging station continuously without overcharging. Place the charging station where the unit is intended to be stored. This should be a cool, dry and well ventilated place, where the unit can be
The unit should be stored and charged in a location where the temperature is between 50˚F (10˚C) and 100˚F (38˚C).
1.Locate a place for the charging station near a wall outlet and high enough to keep the unit off the floor.
2.Locate the wall stud and mount the charging station to the wall using the three (3) screws provided
(Fig 3). Make sure that the screws enter the wall stud to provide a secure mount.
Charging Station |
|
Screws |
|
| Wall |
Wall Outlet | Stud |
Charger
Cord Wrap
Charging
Indicator Light
Fig. 3
CAUTION: To prevent injury or damage to the unit, the charging station must be mounted securely to the wall.
3.Plug the charger into the wall outlet and wrap any excess wire onto the cord wrap on the charging station (Fig. 3).
7