Ryobi UT15518F manual Replacing the Debris Flap, Attaching the Storage Hanger

Page 11

MAINTENANCE

REPLACING THE DEBRIS FLAP

See Figure 9.

Replace the debris flap if it is worn.

Using a 10 mm wrench or socket, remove the hex nuts, washers, and debris flap.

Install the new debris flap. This replacement part is available from the place of purchase, or by calling 1-800-242-4672.

Replace washers and hex nuts.

Tighten securely.

ATTACHING THE STORAGE HANGER

See Figure 10.

There are two ways to hang the attachment for storage.

To use the hanger cap, push in the button and place the hanger cap over end of the lower end attachment shaft. Slightly rotate the cap from side to side until the button locks into place.

The secondary hole in the attachment shaft can be used for hanging purposes as well.

STORING THE EDGER ATTACHMENT

Store the edger attachment in a well-ventilated place that is inaccessible to children. Keep away from corrosive agents such as garden chemicals and de-icing salts.

HEX NUT

WASHER

DEBRIS FLAP

HOLE

SECONDARY

HOLE

BUTTON

EDGER GUARD

Fig. 9

HANGER

CAP

Fig. 10

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Save this Manual for Future Reference OPERATOR’S ManualIntroduction Table of ContentsGeneral Safety Rules Specific Safety Rules Symbolname SymbolsKnow Your Edger Attachment FeaturesProduct Specifications Unpacking AssemblyJoining the Power Head to the Edger Attachment Removing the Attachment from the Power HeadOperating Tips Using the Edger AttachmentOperation ApplicationsSee Figures 4 Adjusting Depth of CUTReplacing the Blade MaintenanceGeneral Maintenance Storing the Edger Attachment Replacing the Debris FlapAttaching the Storage Hanger Exploded VIEW/PARTS List Standard Hardware Item MAY be Purchased Locally Page Limited Warranty Statement WarrantyTechtronic Industries North AMERICA, INC
Top Page Image Contents