Ryobi UT15518F manual Adjusting Depth of CUT, See Figures 4

Page 9

OPERATION

ADJUSTING DEPTH OF CUT

See Figures 4 - 5.

The depth of cut is determined by the distance from the bottom of the wheel to the tip of blade.

To adjust the blade depth:

Stop the engine and remove the spark plug wire or dis- connect from the power source.

Loosen the adjusting knob and move the wheel arm up to increase the depth or down to decrease the depth.

After adjustment is complete, tighten the adjusting knob securely.

Replace the spark plug wire or connect to the power supply and start the unit.

NOTE: Adjust the blade depth from 1/2 in. to 1 in. deep initially. Make a shallow cut to test the cutting depth. If the cutting depth needs adjusting, this should be done progres- sively until the desired depth is reached.

ADJUSTING

KNOB

WHEEL ARM

TO DECREASE

DEPTH

BLADE

DEPTH

CURB GUIDE

TO INCREASE

DEPTH

Fig. 4

BLADE

Fig. 5

9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Save this Manual for Future Reference OPERATOR’S ManualIntroduction Table of ContentsGeneral Safety Rules Specific Safety Rules Symbolname SymbolsFeatures Product SpecificationsKnow Your Edger Attachment Joining the Power Head to the Edger Attachment AssemblyRemoving the Attachment from the Power Head UnpackingOperation Using the Edger AttachmentApplications Operating TipsSee Figures 4 Adjusting Depth of CUTMaintenance General MaintenanceReplacing the Blade Replacing the Debris Flap Attaching the Storage HangerStoring the Edger Attachment Exploded VIEW/PARTS List Standard Hardware Item MAY be Purchased Locally Page Limited Warranty Statement WarrantyTechtronic Industries North AMERICA, INC
Top Page Image Contents