ASSEMBLY
UNPACKING
This product requires assembly.
Carefully remove the items from the box. Make sure that all items listed in the packing list are included.
Inspect the product carefully to make sure no breakage or damage occurred during shipping.
Do not discard the packing material until you have care- fully inspected and satisfactorily operated the tool.
If any parts are damaged or missing, please call
PACKING LIST
Holding Pin
Hanger Cap
Operator’s Manual
WARNING:
If any parts are damaged or missing, do not operate this tool until the parts are replaced. Failure to heed this warning could result in serious personal injury.
WARNING:
Do not attempt to modify this tool or create accesso- ries not recommended for use with this tool. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury.
JOINING THE POWER HEAD TO THE EDGER ATTACHMENT
See Figure 2.
WARNING:
Never attach or adjust any attachment while power head is running. Failure to stop the engine and disconnect the spark plug wire or disconnect from power supply may cause serious personal injury.
The edger attachment connects to the power head by means of a coupler device.
Loosen the knob on the coupler of the power head shaft and remove the end cap from the attachment shaft.
POWER HEAD SHAFT
GUIDE RECESS
COUPLER
KNOB
POSITIONING
HOLE
EDGER
ATTACHMENT
SHAFT
Fig. 2
Push in the button located on the edger attachment. Align the button with the guide recess on the power head cou- pler and slide the two shafts together. Rotate attachment shaft until button locks into the positioning hole.
NOTE: If the button does not release completely in the positioning hole, the shafts are not locked into place. Slightly rotate from side to side until the button is locked into place.
Tighten the knob securely.
WARNING:
Be certain the knob is fully tightened before operating equipment. Check it periodically for tightness during use to avoid serious injury.
REMOVING THE ATTACHMENT FROM THE POWER HEAD
To remove or change the attachment:
Loosen the knob.
Push in the button and twist the shafts to remove and separate ends.
7