Ryobi P540B manual Starting and Stopping the Chain SAW, Preparation for Cutting

Page 12

OPERATION

STARTING AND STOPPING THE CHAIN SAW

See Figure 8.

WARNING:

Keep body to the left of the chain line. Never straddle the saw or chain, or lean over past the chain line.

Starting the chain saw:

Place the chain saw on a flat bare surface and make sure no objects or obstructions are in immediate vicinity which could come in contact with the bar and chain.

Press and hold the trigger release button. This makes the trigger operational.

Press and hold the trigger, release the trigger release button and continue to squeeze the trigger for continued operation.

Stopping the chain saw:

Release the trigger to stop the chain saw.

Upon release of the trigger, the trigger release button will be automatically reset to the lock position.

This cordless chain saw is not designed for cutting trees larger than 5 in. in diameter.

This cordless chain saw is designed for limbing and pruning type cutting, as well as cutting trees up to 5 in. in diameter only.

Do not attempt to make any cut that would require removal of the SAFE-T-TIP®.

Preparation for Cutting

Proper Grip on Handles

See Figures 9 - 11.

Refer to Important Safety Instructions earlier in this manual for appropriate safety equipment.

Wear non-slip gloves for maximum grip and protection.

Hold the saw firmly with both hands. Always keep your left hand on the front handle and your right hand on the rear handle so that your body is to the left of the chain line.

trigger release

button

trigger

trigger release

button

trigger

Fig. 8

12

Image 12
Contents OPERATOR’S Manual Save this Manual for Future ReferenceTable of Contents IntroductionBasic Safety Precautions Safety ApparelRead ALL Instructions Kickback See Figures 1Understanding Your Chain Saw Safety Devices Cutting/Work AreaSAFE-T-TIPAnti-Kickback Nose Guard Low Kickback Saw ChainSpecific Safety Rules Battery SafetyP100 Ni-Cd 1423701 130255004 140237023 Symbols Symbol Name DESIGNATION/EXPLANATIONService Authorized Service Center for repair. When servicFeatures Product SpecificationsAssembly OperationUnpacking Packing ListTo Install Battery Pack To Remove Battery PackBattery port Battery pack Latches Chain Oil SystemStarting and Stopping the Chain SAW Preparation for CuttingChain Line Basic Cutting Procedure Work Area PrecautionsProper Cutting Stance Tree FellingPlanned Line of fall 135 Safe Retreat In. or 1/10 DIABucking See Figures 17Wedge Kickback Bucking Logs Under Stress Types of Cutting UsedSee Figures 19 Limbing PruningSpringpoles SpringpoleMaintenance General MaintenanceBattery Pack Removal and Preparation for Recycling BatteriesREPLACing Bar and Chain Recommended Bar and Chain CombinationsSee Figures 24 Chain Tension See Figures 29Chain Maintenance How to Sharpen the CuttersSee Figures 31 See Figures 33Top Plate Filing Angle Side Plate AngleDepth Gauge Clearance SeeGuide BAR Maintenance Reversing the guide barSee Figures 40 FrontSAFE-T-TIPNose Guard Maintenance Mounting SAFE-T-TIPNose GuardTransporting and Storing See Figures 41Troubleshooting Problem CAUSE SolutionWarranty Limited Warranty StatementParts and Service