Installing the Wheel Assembly Accessory

ASSEMBLY

INSTALLING THE WHEEL ASSEMBLY ACCESSORY

See Figures 3 - 4.

Use the wheel assembly accessory to transport the unit to and from the work area. To install:

 Raise the adjustment knob located at the back of the tine

shield. Twist slightly to secure in the raised position.

 Insert the wheel assembly support rod into the opening

beneath the adjustment knob. To place the wheels in a

high position, insert the rod to the first hole. For a lower

wheel position, insert the rod to the second hole.

ADJUSTMENT

KNOB OPENING

WHEEL

ASSEMBLY

SUPPORT

 Rotate the adjustment knob in the opposite direction to

return it to the seated position, which will secure the wheel

assembly in place.

 Insert the drag bar into the open slot in the wheel as-

sembly support rod.

 Insert pull pin through holes in support rod, passing

through desired hole in drag bar, to secure drag bar at

desired height.

DRAG

BAR

ROD

Fig. 3

INSTALLING THE TINES

See Figure 5.

The cultivator has four tines —two inner tines labeled B and C, and two outer tines labeled A and D. For correct opera- tion of the unit, the tines must be installed in the correct orientation.

Lean the unit back on its wheels so that the handlebar rests on the ground.

Place tine C on the tine shaft to the left of the gear box. The stamped side of the tine should face away from the gear box.

Place tine B on the tine shaft to the right of the gear box. The stamped side of the tine should face away from the gear box.

Place a felt washer on each side of the tine shaft, and slide to rest against the inner tines.

Place the outer tine labeled D on the left side of the tine shaft. The stamped side should face in toward tine C.

Place the outer tine labeled A on the right side of the tine shaft. The stamped side should face in toward tine B.

FELT FLAT EDGE

WASHER

TINE D

	WHEEL	DRAG
	ASSEMBLY	DRAG
	ASSEMBLY	BAR
	SUPPORT	BAR
	SUPPORT
	ROD
	PULL PIN

Fig. 4

NOTE: When installed correctly, the angled edge of the tine blades should face the ground.

To secure the tines to the tine shaft, insert the hitch pin into the holes located on either side of the tine shaft.

NOTE: The unit will not operate properly if the tines are in- stalled incorrectly. If you notice a problem with the cultivating operation of the unit, check for proper tine positioning.

GEAR	FELT	TINE A
BOX	WASHER

HITCH	ANGLED EDGE			HITCH
PIN	ANGLED EDGE	TINE C TINE SHAFT	TINE B	PIN	Fig. 5
					Fig. 5

ASSEMBLY