Ryobi RY60512 manual Troubleshooting, Problem Cause Remedy

Page 18

TROUBLESHOOTING

PROBLEM

CAUSE

REMEDY

Engine fails to start.

Engine switch is in the off position.

Move switch to start.

 

No fuel in tank.

Fill tank.

 

Spark plug shorted or fouled.

Replace spark plug.

 

Spark plug is broken (cracked

Replace spark plug.

 

porcelain or electrodes broken).

 

 

Ignition lead wire shorted, broken, or

Replace lead wire or attach to spark

 

disconnected from spark plug.

plug.

 

Ignition inoperative.

Contact authorized service center.

 

 

 

Engine hard to start.

Water in gasoline or stale fuel mixture.

Drain entire system and refill with fresh

 

 

fuel.

 

Too much oil in fuel mixture.

Drain and refill with correct mixture.

 

Engine is under or over choked.

Adjust choke as necessary.

 

Weak spark at spark plug.

Contact authorized service center.

 

 

 

Engine lacks power.

Air filter clogged.

Clean or replace air filter.

 

 

 

Engine overheats.

Insufficient oil in fuel mixture.

Mix fuel as described in starting

 

 

instructions.

 

 

 

 

L

 

 

 

CAL

-4050

 

 

 

-860

.com

800

 

1-

.ryobitools

www

 

 

MAKE THE MOST OF YOUR PURCHASE!

Go to www.ryobitools.com and register your new tool on-line.

Your product has been fully tested prior to shipment

to ensure your complete satisfaction.

For any questions about operating or maintaining

your product, call the Ryobi Help Line!

To register your Ryobi product or set up your eBoxaccount by regular mail, please print the following informa- tion on a 3 in. x 5 in. card or standard postcard: your name, mailing address, phone numbers, email address, Ryobi product(s) purchased with item number from package, and serial number for each product. Mail the card to: Techtronic Industries North America, Inc., Attn. Ryobi Registration, 1428 Pearman Dairy Road, Anderson, SC 29625. To receive information on our company and products, please include the following statement on your registration card: “Send me information on your products and company using the contact information I am providing with this product registration.”

18

Image 18
Contents OPERATOR’S Manual Save this Manual for Future ReferenceTable of Contents IntroductionGeneral Safety Rules Specific Safety Rules ServiceRefueling Symbols Symbol Name ExplanationSymbol Signal Meaning Know Your Cultivator Recoil Starter Product SpecificationsEngine Switch Primer BulbPacking List AssemblyUnpacking Positioning the HandlebarInstalling the Wheel Assembly Accessory Installing the TinesSee Figures 3 To add fuel to the cultivator Mixing the FuelAdding Fuel to Cultivator Fuel Tank CAPApplications OperationAdding Sand STARTING/STOPPING CultivatorPrimer Bulb Start Startlever Lever Preparing the Seed BEDTo stop the cultivator Recoil StarterGeneral Cultivating To remove the two outer tinesHitch PIN Adjusting Drag BAR Position AdjustmentsAdjusting Wheel Position To adjust the height of the drag barMaintenance General MaintenanceCleaning the AIR Filter Spark Plug Replacing the Spark PlugReplacing the Spark Arrestor Cover ScrewsCleaning the Exhaust Port and Muffler Storing the ProductPreparing for USE After Storage Troubleshooting Problem Cause RemedyWarranty Limited Warranty StatementMANUFACTURER’S Warranty Coverage Emissions Maintenance Schedule and Warranted Parts List Service Model NO. and Serial no California Proposition