Ryobi RY60512 manual Service Model NO. and Serial no, California Proposition

Page 22

OPERATOR’S MANUAL

CULTIVATOR

RY60512

WARNING:

The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm.

CALIFORNIA PROPOSITION 65

• SERVICE

Now that you have purchased your tool, should a need ever exist for repair parts or service, simply contact your nearest Authorized Service Center. Be sure to provide all pertinent facts when you call or visit. Please call 1-800-860-4050 for your nearest Authorized Service Center. You can also check our web site at www.ryobitools.com for a complete list of Authorized Service Centers.

• MODEL NO. AND SERIAL NO.

The model number of this tool will be found on a plate attached to the motor housing. Please record the model number and serial number in the space provided below.

• HOW TO ORDER REPAIR PARTS

When ordering repair parts, always give the following information:

MODEL NUMBER

RY65012

SERIAL NUMBER

 

Ryobi® is a registered trademark of Ryobi Limited used under license.

TECHTRONIC INDUSTRIES NORTH AMERICA, INC.

1428 Pearman Dairy Road

Anderson, SC 29625

Phone 1-800-860-4050

www.ryobitools.com

987000-124

2-23-07 (REV:00)

Image 22
Contents OPERATOR’S Manual Save this Manual for Future ReferenceTable of Contents IntroductionGeneral Safety Rules Service Specific Safety RulesRefueling Symbols Symbol Name ExplanationSymbol Signal Meaning Know Your Cultivator Recoil Starter Product SpecificationsEngine Switch Primer BulbPacking List AssemblyUnpacking Positioning the HandlebarInstalling the Tines Installing the Wheel Assembly AccessorySee Figures 3 To add fuel to the cultivator Mixing the FuelAdding Fuel to Cultivator Fuel Tank CAPApplications OperationAdding Sand STARTING/STOPPING CultivatorPrimer Bulb Start Startlever Lever Preparing the Seed BEDTo stop the cultivator Recoil StarterTo remove the two outer tines General CultivatingHitch PIN Adjusting Drag BAR Position AdjustmentsAdjusting Wheel Position To adjust the height of the drag barGeneral Maintenance MaintenanceCleaning the AIR Filter Spark Plug Replacing the Spark PlugReplacing the Spark Arrestor Cover ScrewsStoring the Product Cleaning the Exhaust Port and MufflerPreparing for USE After Storage Troubleshooting Problem Cause RemedyWarranty Limited Warranty StatementMANUFACTURER’S Warranty Coverage Emissions Maintenance Schedule and Warranted Parts List Service Model NO. and Serial no California Proposition