Ryobi Outdoor PBC3046E, RY70105 Starting and Stopping, To Start a Cold Engine, To Stop the Engine

Page 15

OPERATION

STARTING AND STOPPING

See Figures 16 and 17.

NOTE: The unit is equipped with an automatic choke feature. The starting instructions for this feature are different from units with a manual choke. Be sure to read and follow the starting instructions below.

WARNING

Never start or run the engine inside a closed or poorly ventilated area; breathing exhaust fumes can kill.

TO START A COLD ENGINE:

1Lay trimmer on a flat, bare surface.

2Push primer bulb 8 to 10 times.

NOTE: Do not squeeze the throttle trigger before engine starts. Squeezing the throttle trigger at this time will prevent the unit from starting.

3Move the lever to the “COLD START” position. See Figure 17.

4Pull the starter rope until engine runs.

5Allow the engine to warm up for 4-10 seconds.

6Depress the throttle interlock, then squeeze and release the throttle trigger. This allows the choke to automati- cally set to the “WARM START” position. Your unit is now ready for use.

NOTE: The lever will automatically set to the “WARM START” position after the throttle trigger is squeezed for the first time.

TO START A WARM ENGINE:

1.Lay trimmer on a flat, bare surface.

2.Choke lever should already be in the “WARM START” position. If not, squeeze and release throttle trigger. Pull the starter rope until unit runs.

TO STOP THE ENGINE:

To stop the engine, depress the switch to the “O” position.

IGNITION SWITCH

I= ON TO RUN O = OFF TO STOP

THROTTLE

TRIGGER

PRIMER BULB

THROTTLE

INTERLOCK

Fig. 16

WARM START

POSITION

COLD START

POSITION

LEVER

Fig. 17

15

Image 15
Contents OPERATOR’S Manual Safety Table of ContentsSpecific Safety Rules for Brushcutter and Blade USE Specific Safety Rules for Trimmer USESymbol Name Explanation SymbolsVibration level racing Technical DataPacking List for OWNER’S KIT FeaturesUnpacking InstructionsAttaching the Storage Hanger AssemblyAttaching the Power Head to the Trimmer Attachment Removing the Attachment from the Power HeadAttaching the Handle Silencer Guard Attaching the Shoulder StrapConverting from Trimmer to Brushcutter Drive Connector Spool RetainerBlade Guard Grass DeflectorRemoving the Blade Installing the BladeInstalling the String Head Converting from Brushcutter to TrimmerOperation Fuel and RefuellingOperating the Trimmer Advancing the String Cutting TipsGrass Deflector Line Trimming CUT- OFF Blade Operating the Brushcutter TRI-ARC BladeCutting Technique Blade To Start a Warm Engine Ignition SwitchStarting and Stopping To Start a Cold EngineSee Figures 18 MaintenanceSpool Replacement EZ Line TAP Advance System NEW PRE-WOUND SpoolBlade Protector See Figures 25 Cleaning the Exhaust Port and SilencerReplacing and Cleaning AIR Filter Spark ArresterFuel CAP Sparking PlugStorage 1 Month or Longer Troubleshooting Idle Speed Screw Needle Sound Pressure Sound Power Vibration Model Model no WarrantySafety Directive Guarantee Statement Rtsa / Rtuk / RTGPage Ryobi Technologies GmbH