Ryobi Outdoor PBC3046E, RY70105 Converting from Brushcutter to Trimmer, Installing the Blade

Page 11

ASSEMBLY

INSTALLING THE BLADE

See Figure 10.

1.Place the upper flange washer over the gear shaft with the hollow side towards the blade guard.

2.Centre the blade on the upper flange, making sure the blade sits flat. Install the cupped washer with the raised centre away from the blade. Install the blade nut. The blade turns anticlockwise from the operator’s position.

3.Place the holding pin through the slot in the upper flange washer and the hole in the gear head. Using the 13 mm (1/2 in) spanner supplied, turn the blade nut anticlockwise.

4.Tighten nut securely.

CONVERTING FROM BRUSHCUTTER TO TRIMMER

REMOVING THE BLADE

See Figure 10.

1.Place the holding pin through the slot in the upper flange washer and the gear head. Turn the blade nut clockwise to remove.

2.Remove the cupped washer and the blade.

3.Remove the upper flange washer from the gear shaft and retain for the string head installation.

4.Attach the grass deflector to the blade guard by placing the three locking tabs into the three notches.

5.Snap the blade guard and grass deflector together to lock into place.

NOTE: Store the brushcutter parts together for later use.

INSTALLING THE STRING HEAD

See Figure 9.

1.Install the upper flange washer onto the gear shaft with the hollow side towards the gear head.

2.Place the holding pin through the slot in the upper flange washer and the hole in the gear head. Using the 16 mm (5/8 in) spanner supplied, turn the drive connector anticlockwise to install. Tighten securely.

3.Place the string head on the drive connector.

4.Place the holding pin through the slot in the upper flange washer and the hole in the gear head. Install the spool retainer and turn anticlockwise to tighten securely.

GEAR HEAD

BLADE

GUARD

HOLDING PIN

CUPPED

WASHER

BLADE NUT

UPPER FLANGE

WASHER

BLADE

SPANNER

(13 mm)

Fig. 10

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents OPERATOR’S Manual Safety Table of ContentsSpecific Safety Rules for Brushcutter and Blade USE Specific Safety Rules for Trimmer USESymbol Name Explanation SymbolsVibration level racing Technical DataPacking List for OWNER’S KIT FeaturesUnpacking InstructionsAttaching the Storage Hanger AssemblyAttaching the Power Head to the Trimmer Attachment Removing the Attachment from the Power HeadAttaching the Handle Silencer Guard Attaching the Shoulder StrapConverting from Trimmer to Brushcutter Drive Connector Spool RetainerBlade Guard Grass DeflectorRemoving the Blade Installing the BladeInstalling the String Head Converting from Brushcutter to TrimmerOperating the Trimmer OperationFuel and Refuelling Grass Deflector Line Trimming CUT- OFF Blade Advancing the StringCutting Tips Cutting Technique Blade Operating the BrushcutterTRI-ARC Blade To Start a Warm Engine Ignition SwitchStarting and Stopping To Start a Cold EngineSee Figures 18 MaintenanceSpool Replacement EZ Line TAP Advance System NEW PRE-WOUND SpoolBlade Protector See Figures 25 Cleaning the Exhaust Port and SilencerReplacing and Cleaning AIR Filter Spark ArresterStorage 1 Month or Longer Fuel CAPSparking Plug Troubleshooting Idle Speed Screw Needle Sound Pressure Sound Power Vibration Model Model no WarrantySafety Directive Guarantee Statement Rtsa / Rtuk / RTGPage Ryobi Technologies GmbH
Top Page Image Contents