Ryobi Outdoor 510r manual Maintenance and Repair Instructions, Maintenance Schedule

Page 13

MAINTENANCE AND REPAIR INSTRUCTIONS

NOTE: Some maintenance procedures may require special tools or skills. If you are unsure about these procedures take your unit to an authorized service dealer.

MAINTENANCE SCHEDULE

These required maintenance procedures should be performed at the frequency stated in the table. They should also be included as part of any seasonal tune-up.

WARNING: To prevent serious injury, never do maintenance or repairs with unit running. Always do maintenance and repairs on a cool unit. Disconnect spark plug wire to ensure the unit will not start.

FREQUENCY

MAINTENANCE REQUIRED

REFER TO:

Before Starting Engine

Fill fuel tank with fresh fuel

Page 9-10

 

 

Check oil

Page 14

 

 

 

Every 10 Hours

Clean and re-oil air filter.

Page 15

 

 

 

1st Change at 10 Hours

Change oil

Page 14

Every 25

Hours there after

Change oil

Page 14

Every 25

Hours

Clean Spark Arrestor

Page 18

 

 

 

10 hours on new engine

Check rocker arm to valve clearance and adjust as required

Page 16-17

Every 50

Hours

Check rocker arm to valve clearance and adjust as required

Page 16-17

Every 50

Hours

Check spark plug condition and gap

Page 18

 

 

 

 

TINE REMOVAL AND REPLACEMENT

All 4 tines should be replaced at the same time because they will wear evenly through normal use. Work on one side at a time.

WARNING: To prevent serious personal injury, always wear heavy gloves when handling the tines.

1.Put the On/Off Stop Control in the STOP (O) position and disconnect the spark plug wire.

2.Remove the clevis pin clips and clevis pins (Fig. 15).

3.Remove the tines and felt cushions from the shaft.

4.Clean and oil the shaft.

5.Replace the tines and felt cushions by reversing steps 2 and 3 (Fig. 16).

NOTE: When installed correctly, the hubs on the tines will face each other and the letter “R” stamped on the tines will appear on the right side of the cultivator and the letter “L” will appear on the left side from the normal operating position. It is important that the tines are installed correctly.

6. Repeat this procedure on the opposite side.

Clevis Pin

Clevis Pin Clip

Fig. 15

Felt Cushion

Fig. 16

13

Image 13
Contents OPERATOR’S Manual Introduction Table of ContentsSpark Arrestor California Emission RegulationsRules for Safe Operation Symbol MeaningSymbolmeaning Safety Alert Symbol Safety and International SymbolsFor Service INFORMATION, Call Wear EYE and Hearing ProtectionUnleaded Fuel Symbolmeaning Keep Bystanders Away PrimerOIL Thrown Objects can Cause Severe Injury ON/OFF Stop ControlApplication Know Your UnitAdjusting the Handlebar Height Assembly InstructionsInstalling the Wheel Bracket Assembly Assembling the UnitOIL and Fuel Information Using Blended FuelsRecommended OIL Type Recommended Fuel TypeSTARTING/STOPPING Instructions Using Fuel AdditivesFueling Unit Starting InstructionsEngine Re-Start Warm Engine With Fuel Stopping InstructionsOperating Instructions Adjusting Tine DepthOperating Tips Maintenance Schedule Maintenance and Repair InstructionsFrequency Maintenance Required Refer to Tine Removal and ReplacementChanging the OIL Checking the OIL LevelCleaning the Air Filter AIR Filter MaintenanceClean Air Filter Carburetor AdjustmentAdjust Idle Speed Screw Rocker ARM ClearanceRemove the rocker arm cover and gasket ACCESSORIES/REPLACEMENT Parts Spark Arrestor MaintenanceReplacing the Spark Plug Cleaning and Storage U S E T I O N TroubleshootingEngine SpecificationsPage Manufacturers Warranty Coverage Owners Warranty ResponsibilitiesREV. B Limited TWO-YEAR Warranty