Ryobi Outdoor 510r manual Troubleshooting, U S E T I O N

Page 20

TROUBLESHOOTING

 

 

 

 

ENGINE WILL NOT START

 

C A U S E

A C T I O N

Ignition switch is OFF

Turn switch to ON

Empty fuel tank

Fill fuel tank

Primer bulb wasn't pressed enough

Press primer bulb fully and slowly 5-7 times

Engine flooded

Use starting procedure with choke lever in the

 

RUN position, Pg. 10

Old Gasoline

Drain fuel tank / Add fresh Gasoline

Fouled spark plug

Replace or clean the spark plug

 

 

ENGINE WILL NOT IDLE

 

C A U S E

A C T I O N

Air Filter is Plugged

Replace or clean the air filter

Old Gasoline

Drain fuel tank / Add fresh Gasoline

Improper carburetor adjustment

Adjust per instruction Pg. 16

 

 

ENGINE WILL NOT ACCELERATE

 

C A U S E

A C T I O N

Old Gasoline

Drain gas tank / Add fresh Gasoline

Improper carburetor adjustment

Take to an authorized service dealer for

 

carburetor adjustment

Dirty air filter

Clean or replace the air filter

Clogged Spark Arrestor Screen

Clean or Replace. See Pg. 18

 

ENGINE LACKS POWER OR STALLS WHEN UNDER LOAD

C A U S E

A C T I O N

Old Gasoline

Drain gas tank / Add fresh Gasoline

Improper carburetor adjustment

Take to an authorized service dealer for

 

carburetor adjustment

Cultivator tines bound with dirt or grass

Stop the unit, switch the On/Off Stop Control to

 

STOP, clean and remove any debris binding the tines

 

 

SIGNS OF OIL AROUND OIL FILL PLUG/DIPSTICK

 

C A U S E

A C T I O N

Oil fill plug/dipstick loose or missing o-ring

Tighten oil fill plug/dipstick, replace o-ring.

20

Image 20
Contents OPERATOR’S Manual Table of Contents IntroductionCalifornia Emission Regulations Spark ArrestorSymbol Meaning Rules for Safe OperationSafety and International Symbols Symbolmeaning Safety Alert SymbolFor Service INFORMATION, Call Wear EYE and Hearing ProtectionSymbolmeaning Keep Bystanders Away Primer Unleaded FuelOIL Thrown Objects can Cause Severe Injury ON/OFF Stop ControlKnow Your Unit ApplicationAssembly Instructions Adjusting the Handlebar HeightInstalling the Wheel Bracket Assembly Assembling the UnitUsing Blended Fuels OIL and Fuel InformationRecommended OIL Type Recommended Fuel TypeUsing Fuel Additives STARTING/STOPPING InstructionsFueling Unit Starting InstructionsStopping Instructions Engine Re-Start Warm Engine With FuelOperating Tips Adjusting Tine DepthOperating Instructions Maintenance and Repair Instructions Maintenance ScheduleFrequency Maintenance Required Refer to Tine Removal and ReplacementChecking the OIL Level Changing the OILAIR Filter Maintenance Cleaning the Air FilterCarburetor Adjustment Clean Air FilterAdjust Idle Speed Screw Rocker ARM ClearanceRemove the rocker arm cover and gasket Replacing the Spark Plug Spark Arrestor MaintenanceACCESSORIES/REPLACEMENT Parts Cleaning and Storage Troubleshooting U S E T I O NSpecifications EnginePage Owners Warranty Responsibilities Manufacturers Warranty CoverageLimited TWO-YEAR Warranty REV. B