Installing the Wheel Assembly Accessory

ASSEMBLY

INSTALLING THE WHEEL ASSEMBLY ACCESSORY

See Figures 3 - 4.

Use the wheel assembly accessory to transport the unit to and from the work area. To install:

n Raise the adjustment knob located at the back of the tine

shield. Twist slightly to secure in the raised position.

n Insert the wheel assembly support rod into the opening

beneath the adjustment knob. To place the wheels in a

high position, insert the rod to the first hole. For a lower

wheel position, insert the rod to the second hole.

ADJUSTMENT

KNOB OPENING

WHEEL

ASSEMBLY

SUPPORT

n Rotate the adjustment knob in the opposite direction to

return it to the seated position, which will secure the wheel

assembly in place.

n Insert the drag bar into the open slot in the wheel as-

sembly support rod.

n Insert pull pin through holes in support rod, passing

through desired hole in drag bar, to secure drag bar at

desired height.

DRAG

BAR

ROD

Fig. 3

INSTALLING THE TINES

See Figure 5.

The cultivator has four tines —two inner tines labeled B and C, and two outer tines labeled A and D. For correct opera- tion of the unit, the tines must be installed in the correct orientation.

nLean the unit back on its wheels so that the handlebar rests on the ground.

nPlace tine C on the tine shaft to the left of the gear box. The stamped side of the tine should face away from the gear box.

nPlace tine B on the tine shaft to the right of the gear box. The stamped side of the tine should face away from the gear box.

nPlace a felt washer on each side of the tine shaft, and slide to rest against the inner tines.

nPlace the outer tine labeled D on the left side of the tine shaft. The stamped side should face in toward tine C.

nPlace the outer tine labeled A on the right side of the tine shaft. The stamped side should face in toward tine B.

FELT FLAT EDGE

WASHER

TINE D

	WHEEL	DRAG
	ASSEMBLY	DRAG
	ASSEMBLY	BAR
	SUPPORT	BAR
	SUPPORT
	ROD
	PULL PIN

Fig. 4

NOTE: When installed correctly, the angled edge of the tine blades should face the ground.

nTo secure the tines to the tine shaft, insert the hitch pin into the holes located on either side of the tine shaft.

NOTE: The unit will not operate properly if the tines are in- stalled incorrectly. If you notice a problem with the cultivating operation of the unit, check for proper tine positioning.

GEAR	FELT	TINE A
BOX	WASHER

HITCH	ANGLED EDGE			HITCH
PIN	ANGLED EDGE	TINE C TINE SHAFT	TINE B	PIN	Fig. 5
					Fig. 5

ASSEMBLY