Porter-Cable PH350IS instruction manual Rubber Bumper, Handle

Page 10

RUBBER BUMPER

1.Attach the rubber bumper (6) to the foot bracket with 1/4-20 x 3/4" screw (7) and 1/4- 20 keps nut with washer (8).

NOTE: Lubricate area where handles rotates in brackets with light oil.

Risk of moving parts. Keep fingers away from all moving parts. Contact with moving parts

can result in serious injury. Keep children away from the generator at all times. They may not be able to recognize the hazards of this product.

1.Raise handle and allow snap buttons to snap into place.

D27381

10- ENG

Image 10

Contents Generator Consumer General and Service Information Consumer Safety InformationWhen installing a Double Safety Guidelines / DefinitionsImportant Safety Instructions Risk of Electrocution and FireOperation When damagedRisk of Electrocution and Fire Generator in rainUnit Indoors or in ANY Risk of FireConfined Area Risk of Breathing Inhalation Hazard Risk of Unsafe OperationRisk of HOT Surfaces Risk of Moving Parts SpecificationsRisk from Lifting Other Loose Parts AssemblyRemove Generator from Carton Extension Cord Wrap Forms and Protective BARRubber Bumper HandleObtaining Electricity from the Generator Double Throw Transfer SwitchGrounding the Generator Extension CordsOperation To Start the Engine Connecting Electrical Loads Stopping EngineGenerator Maintenance MaintenanceEngine Maintenance Customer Responsibilities TableEngine Preparation StorageGenerator Wattage Calculations Determining Wattage RequirementsApplication Guide Starting Wattage RequirementsHousehold Wattage Calculator Appliance or Load Device Typical Device Wattage TotalTroubleshooting Guide StartLimited Warranty Responsibility of Original Purchaser initial UserQuick Facts