Porter-Cable PH350IS instruction manual Stopping Engine, Connecting Electrical Loads

Page 14

STOPPING ENGINE

1. Disconnect all electrical loads.

2.Turn ON/OFF switch to "OFF" position.

3.Close fuel shut-off valve.

CONNECTING ELECTRICAL LOADS

1.Let engine run and warm up for five minutes after starting with no electrical load.

Connect loads in the following manner to prevent damage to equipment:

2.Connect inductive load equipment first, inductive loads consist of refrigerators, freezers, water pumps, air conditioners, or small hand tools. Connect the items that require the most wattage first. See Wattage Calcu- lation Section in this manual.

3.Connect the lights next.

4.Voltage sensitive equipment should be the last equipment connected to the generator. Plug voltage sensitive appliances such at TV's, VCR's, micro- waves, ovens, computers, and cordless telephones into a UL listed voltage surge protector, then connect the UL listed voltage surge protector to the generator.

Failure to connect and operate equipment in this sequence can cause damage to equipment and will void the warranty

on your generator.

Follow the wattage calculation table in the Wattage Calculation section of this manual. Overloading the generator will cause power fluctuations and can damage equipment and appliances.

Porter-Cable Corporation will only be responsible for damage to customer's equipment when the generator is determined to be defective. This determination will only be made by an authorized representative of Porter-Cable Corporation and this decision will be final. Porter-Cable Corporation reserves the right to inspect the electrical connections at the customer's site of operation and test the generator for proper operation before any determination of liability is made. Failure to maintain the equipment or wiring for inspection will void any claim for damages by the customer. Porter-Cable Corporation will not be responsible for equipment damaged as a result of voltage surges, improper operation or improper installation of the generator.

D27381

14- ENG

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Generator Consumer General and Service Information Consumer Safety InformationWhen installing a Double Safety Guidelines / DefinitionsImportant Safety Instructions Risk of Electrocution and FireOperation When damagedRisk of Electrocution and Fire Generator in rainConfined Area Risk of FireUnit Indoors or in ANY Risk of Breathing Inhalation Hazard Risk of Unsafe OperationRisk of HOT Surfaces Risk from Lifting SpecificationsRisk of Moving Parts Other Loose Parts AssemblyRemove Generator from Carton Extension Cord Wrap Forms and Protective BARRubber Bumper HandleObtaining Electricity from the Generator Double Throw Transfer SwitchGrounding the Generator Extension CordsOperation To Start the Engine Connecting Electrical Loads Stopping EngineGenerator Maintenance MaintenanceEngine Maintenance Customer Responsibilities TableGenerator StorageEngine Preparation Wattage Calculations Determining Wattage RequirementsApplication Guide Starting Wattage RequirementsHousehold Wattage Calculator Appliance or Load Device Typical Device Wattage TotalTroubleshooting Guide StartLimited Warranty Responsibility of Original Purchaser initial UserQuick Facts
Top Page Image Contents