Poulan 412412 manual Storage, Other, Fuel System, Engine OIL, Cylinders

Page 24

STORAGE

Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more.

WARNING: Never store the tractor with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter storage. When mower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

•Clean entire tractor (See “CLEANING” in the Mainte- nance section of this manual).

•Inspect and replace belts, if necessary (See belt re- placement instructions in the Service and Adjustments section of this manual).

•Lubricate as shown in the Maintenance section of this manual.

•Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

•Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

•Fully charge the battery for storage.

•After a period of time in storage, battery may require recharging.

•To help prevent corrosion and power leakage during long periods of storage, battery cables should be dis- connected and battery cleaned thoroughly (see “TO CLEAN BATTERY AND TERMINALS” in the Mainte- nance section of this manual).

•After cleaning, leave cables disconnected and place cables where they cannot come in contact with battery terminals.

•If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: IT IS IMPORTANT TO PREVENT GUM DEPOSITS FROM FORMING IN ESSENTIAL FUEL SYSTEM PARTS SUCH AS CARBURETOR, FUEL FILTER, FUEL HOSE, OR TANK DURING STORAGE. ALSO, EXPERIENCE INDICATES THAT ALCOHOL BLENDED FUELS (CALLED GASOHOL OR USING ETHANOL OR METHANOL) CAN ATTRACT MOISTURE WHICH LEADS TO SEPARATION AND FORMATION OF ACIDS DURING STORAGE. ACIDIC GAS CAN DAMAGE THE FUEL SYSTEM OF AN ENGINE WHILE IN STORAGE.

•Empty the fuel tank by starting the engine and let it run until the fuel lines and carburetor are empty.

•Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

•Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in mini- mizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor. Do not empty the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean en- gine oil. (See “ENGINE” in the Maintenance section of this manual).

CYLINDER(S)

•Remove spark plug(s).

•Pour one ounce of oil through spark plug hole(s) into cylinder(s).

•Turn ignition key to “START” position for a few seconds to distribute oil.

•Replace with new spark plug(s).

OTHER

•Do not store gasoline from one season to another.

•Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

•If possible, store your tractor indoors and cover it to give protection from dust and dirt.

•Cover your tractor with a suitable protective cover that does not retain moisture. Do not use plastic. Plastic cannot breathe which allows condensation to form and will cause your tractor to rust.

IMPORTANT: NEVER COVER TRACTOR WHILE ENGINE AND EXHAUST AREAS ARE STILL WARM.

24

Page 23 Page 25
Image 24
Page 23 Page 25
Contents XT20H46YT ModelSafety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationService III. ChildrenIV. Towing Table of Contents Assembly Unassembled PartsTo Remove Tractor from Carton Unpack CartonCheck Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor StoppingTo Adjust Mower Cutting Height See Fig To Adjust Gauge Wheels See FigSystem Characteristics To Operate MowerBefore Starting the Engine Reverse Operation System ROSTo Operate on Hills To Transport See FigsADD Gasoline To Start Engine See FigPurge Transmission Automatic Transmission Warm UPMowing Tips Maintenance MaintenanceGeneral Recommendations ScheduleBattery TractorBrake Operation TiresEngine Cleaning Engine OIL FilterMuffler Spark PlugsService and Adjustments To Install Mower See -21To Remove Mower See Fig Install belt on engine pulley M, in belt keepers G To Level Mower To Replace Mower Drive Belt See Fig To Check BrakeTo Replace Motion Drive Belt See Fig To Start Engine with a Weak Battery See Fig Replacing Battery See FigFront Wheel TOE-IN/CAMBER To Remove Wheel for Repairs See FigTo Adjust Throttle Control Cable To Adjust Choke ControlTo Adjust Carburetor To Replace Headlight BulbStorage OtherFuel System Engine OILTroubleshooting Points Problem Cause CorrectionEngine dies when Only Ride UP and Down Hill Not Across Hill Degrees MAX Fold Along This Dotted Line Degree SlopeLimited Warranty Service Notes Service Notes Service Notes Parts and Service Changere DE Pièces LES ET L’ENTRETIEN Dentretien Remarques Dentretien Remarques Dentretien Remarques Limitée Garantie Degrés Suivant LES UNE Pliez EST CeciDépannage DE Guide Connexions les et interrupteurs les câblage, le VérifiezLame de mandrin le Remplacez Tordu est lame de mandrin Un Entreposage Starter DU Commande LA Régler Pour GAZ DES Commande LA DE Câble LE Régler PourReglages ET Revision MoteurFig la Voir Batterie LA Replacer Fig la Voir Tionsraparé LES Pour Roues LES Enlever PourAvant Roue LA DE PINCEMENT/CARROSSAGE Réglages ET Révision Fig la Voir D’ENTRAÎNEMENT Courroie a L Acer Rempl PourFreins LES Vérifier Pour 27 .FIGTondeuse LA Niveau LE Ajuster Pour 25 .FIG24 .FIG 23 .FIG21 .FIG 19 .FIG 20 .FIG18 .FIG Courroie LA ET Tondeuse LA Installer Fig VoirTondeuse LA Enlever Pour 17 .FIGEntretien Fig la Voir’ALLUMAGE Bougie Moteur DE D’HUILE FiltreAIR À Filtre ’AIR Tamis LE NettoyerSionmistrans LA DE Moteur Fluide Transmission LA DE RefroidissementFig la Voir Lame LA Enlever EN Fonctionnement DE Système ETLubrification DE Tableau Utilisation Chaque AvantUtilisation 12 .FIGTransmission LA Purger Moteur LE Démarrer PourQuetimaauto Sion Transmis DE Réchauffement11 et 3 .Fig les Voir MAR EN Fonctionnement DE SystèmeTondeuse LA Utiliser Pour Jauge DE Roues LES Régler Pour10 .FIG Système DU CaractéristiquesGAZ DES Commande LA Utiliser Pour VitessDE Régulateur LE Utiliser Comment Fig la Voir Mentnetionsta DE Frein LE Engager PourUtilisation ’EMBRAYAGE Montage Desmancom des tionfonc la etLA DE Tracteur LE Retirer Pour Montées NON Piéces Toncar DU Tracteur LE Sortir PourFig la Voir Batterie LA Vérifier Fig la Voir Siège LE AjustezSommaire Général Entretien Tracteurs des sécurité touteEn l’utilisation pour Conseils ’ESSENCE DE Sûre ManipulationPentes LES Dans FonctionnementTracteurs des sécurité toute en l’utilisation pour Conseils AUX Imprimé

412412 specifications

The Poulan 412412 is a noteworthy chainsaw that combines power, efficiency, and user-friendly design, making it a popular choice for both hobbyists and professionals alike. Known for its versatility, the Poulan 412412 excels at a variety of tasks such as tree pruning, firewood cutting, and other general outdoor applications.

One of the standout features of the Poulan 412412 is its robust engine. Equipped with a reliable two-stroke engine, it delivers substantial power for its size. The engine ensures smooth operation and effective performance, allowing users to tackle even tough cutting tasks with ease. The saw is lightweight, which significantly enhances maneuverability and reduces user fatigue, enabling longer working sessions without discomfort.

The Poulan 412412 also boasts an efficient cutting system. It is fitted with a high-quality bar and chain that work in unison to ensure a clean and precise cut. The 16-inch bar length strikes a perfect balance between agility and cutting capacity, allowing users to handle a variety of cutting tasks without the need for a larger, heavier model.

Innovative technologies enhance the overall performance and safety of the Poulan 412412. The chainsaw features an automatic oiler system that delivers lubrication to the chain, minimizing wear and extending the lifespan of the chain and bar. Safety features such as a chain brake and anti-vibration technology ensure that users can operate the saw with confidence, even during extended periods of use.

Ease of maintenance is another key characteristic of the Poulan 412412. Access to the air filter and spark plug is straightforward, allowing users to perform routine maintenance without the need for specialized tools. This accessibility promotes regular upkeep, ensuring that the chainsaw remains in optimal working condition for years to come.

In conclusion, the Poulan 412412 is a reliable and efficient chainsaw that stands out due to its powerful engine, effective cutting system, and user-friendly design. With its commitment to safety and easy maintenance, it is an excellent choice for anyone looking to get the most out of their outdoor power equipment. Whether you are a seasoned professional or a budding DIY enthusiast, the Poulan 412412 is designed to meet your cutting needs with precision and reliability.
Top Page Image Contents