Poulan 412412 manual Unassembled Parts, Assembly, To Remove Tractor from Carton, Unpack Carton

Page 5

UNASSEMBLED PARTS

Slope Sheet

Key

(1) Oil Drain Tube

(2) Keys

ASSEMBLY

Your new tractor has been assembled at the factory with the exception of those parts left unassembled for shipping puposes.

When right or left hand is mentioned in this manual, it means when you are in the operating position (seated behind the steering wheel).

TO REMOVE TRACTOR FROM CARTON

UNPACK CARTON

•Remove all accessible loose parts and parts cartons from carton.

•Cut along dashed lines on all four panels of carton. Remove end panels and lay side panels flat.

•Check for any additional loose parts or cartons and remove.

CHECK BATTERY (See Fig. 1)

•Lift seat pan to raised position.

•If this battery is put into service after month and year indicated on label (label located between terminals) charge battery for minimum of one hour at 6-10 amps. (See "BATTERY" in the Maintenance section of this manual for charging instructions).

DISCARD TERMINAL

KEPS NUT

HEX BOLT

 

PROTECTIVE CAPS

 

 

 

TERMINAL

COVER

NEGATIVE (BLACK) CABLE

POSITIVE (RED) CABLE

ADJUST SEAT (See Fig. 2)

•Sit in seat.

•Lift up adjustment lever (A) and slide seat until a com- fortable position is reached which allows you to press clutch/brake pedal all the way down.

•Release lever to lock seat in position.

A

FIG. 2

NOTE: You may now roll or drive your tractor off the skid. Follow the appropriate instruction below to remove the tractor from the skid.

WARNING: Before starting, read, understand and follow all instructions in the Operation section of this manual. Be sure tractor is in a well-ventilated area. Be sure the area in front of tractor is clear of other people and objects.

03037

FIG. 1

5

TO ROLL TRACTOR OFF SKID (See Op- eration section for location and function of controls)

1. Raise attachment lift lever to its highest position.

2. Release parking brake by depressing brake pedal.

3. Place freewheel control in disengaged position to dis- engage transmission (See “TO TRANSPORT” in the Operation section of this manual).

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Model XT20H46YTSafe Operation Practices for Ride-On Mowers Safety RulesGeneral Operation II. Slope OperationIV. Towing ServiceIII. Children Table of Contents Unassembled Parts AssemblyTo Remove Tractor from Carton Unpack CartonCheck Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor Stopping HOW to USE Your TractorTo Adjust Gauge Wheels See Fig To Adjust Mower Cutting Height See FigSystem Characteristics To Operate MowerReverse Operation System ROS Before Starting the EngineTo Operate on Hills To Transport See FigsTo Start Engine See Fig ADD GasolinePurge Transmission Automatic Transmission Warm UPMowing Tips Maintenance MaintenanceGeneral Recommendations ScheduleTractor BatteryBrake Operation TiresEngine Engine OIL Filter CleaningMuffler Spark PlugsTo Remove Mower See Fig Service and AdjustmentsTo Install Mower See -21 Install belt on engine pulley M, in belt keepers G To Level Mower To Replace Motion Drive Belt See Fig To Replace Mower Drive Belt See FigTo Check Brake Replacing Battery See Fig To Start Engine with a Weak Battery See FigFront Wheel TOE-IN/CAMBER To Remove Wheel for Repairs See FigTo Adjust Choke Control To Adjust Throttle Control CableTo Adjust Carburetor To Replace Headlight BulbOther StorageFuel System Engine OILProblem Cause Correction Troubleshooting PointsEngine dies when Fold Along This Dotted Line Degree Slope Only Ride UP and Down Hill Not Across Hill Degrees MAXLimited Warranty Service Notes Service Notes Service Notes Parts and Service Changere DE Pièces LES ET L’ENTRETIEN Dentretien Remarques Dentretien Remarques Dentretien Remarques Limitée Garantie UNE Pliez EST Ceci Degrés Suivant LESConnexions les et interrupteurs les câblage, le Vérifiez Dépannage DE GuideLame de mandrin le Remplacez Tordu est lame de mandrin Un Entreposage GAZ DES Commande LA DE Câble LE Régler Pour Starter DU Commande LA Régler PourReglages ET Revision MoteurAvant Roue LA DE PINCEMENT/CARROSSAGE Fig la Voir Batterie LA ReplacerFig la Voir Tionsraparé LES Pour Roues LES Enlever Pour Fig la Voir D’ENTRAÎNEMENT Courroie a L Acer Rempl Pour Réglages ET RévisionFreins LES Vérifier Pour 27 .FIG25 .FIG Tondeuse LA Niveau LE Ajuster Pour24 .FIG 23 .FIG18 .FIG 21 .FIG 19 .FIG20 .FIG Fig Voir Courroie LA ET Tondeuse LA InstallerTondeuse LA Enlever Pour 17 .FIGFig la Voir Entretien’ALLUMAGE Bougie Moteur DE D’HUILE Filtre’AIR Tamis LE Nettoyer AIR À FiltreSionmistrans LA DE Moteur Fluide Transmission LA DE RefroidissementEN Fonctionnement DE Système ET Fig la Voir Lame LA EnleverUtilisation Chaque Avant Lubrification DE Tableau12 .FIG UtilisationMoteur LE Démarrer Pour Transmission LA PurgerQuetimaauto Sion Transmis DE RéchauffementMAR EN Fonctionnement DE Système 11 et 3 .Fig les VoirJauge DE Roues LES Régler Pour Tondeuse LA Utiliser Pour10 .FIG Système DU CaractéristiquesVitess GAZ DES Commande LA Utiliser PourDE Régulateur LE Utiliser Comment Fig la Voir Mentnetionsta DE Frein LE Engager PourUtilisation ’EMBRAYAGE LA DE Tracteur LE Retirer Pour MontageDesmancom des tionfonc la et Toncar DU Tracteur LE Sortir Pour Montées NON PiécesFig la Voir Batterie LA Vérifier Fig la Voir Siège LE AjustezSommaire Tracteurs des sécurité toute Général EntretienEn l’utilisation pour Conseils ’ESSENCE DE Sûre ManipulationTracteurs des sécurité toute en l’utilisation pour Conseils PentesLES Dans Fonctionnement AUX Imprimé

412412 specifications

The Poulan 412412 is a noteworthy chainsaw that combines power, efficiency, and user-friendly design, making it a popular choice for both hobbyists and professionals alike. Known for its versatility, the Poulan 412412 excels at a variety of tasks such as tree pruning, firewood cutting, and other general outdoor applications.

One of the standout features of the Poulan 412412 is its robust engine. Equipped with a reliable two-stroke engine, it delivers substantial power for its size. The engine ensures smooth operation and effective performance, allowing users to tackle even tough cutting tasks with ease. The saw is lightweight, which significantly enhances maneuverability and reduces user fatigue, enabling longer working sessions without discomfort.

The Poulan 412412 also boasts an efficient cutting system. It is fitted with a high-quality bar and chain that work in unison to ensure a clean and precise cut. The 16-inch bar length strikes a perfect balance between agility and cutting capacity, allowing users to handle a variety of cutting tasks without the need for a larger, heavier model.

Innovative technologies enhance the overall performance and safety of the Poulan 412412. The chainsaw features an automatic oiler system that delivers lubrication to the chain, minimizing wear and extending the lifespan of the chain and bar. Safety features such as a chain brake and anti-vibration technology ensure that users can operate the saw with confidence, even during extended periods of use.

Ease of maintenance is another key characteristic of the Poulan 412412. Access to the air filter and spark plug is straightforward, allowing users to perform routine maintenance without the need for specialized tools. This accessibility promotes regular upkeep, ensuring that the chainsaw remains in optimal working condition for years to come.

In conclusion, the Poulan 412412 is a reliable and efficient chainsaw that stands out due to its powerful engine, effective cutting system, and user-friendly design. With its commitment to safety and easy maintenance, it is an excellent choice for anyone looking to get the most out of their outdoor power equipment. Whether you are a seasoned professional or a budding DIY enthusiast, the Poulan 412412 is designed to meet your cutting needs with precision and reliability.
Top Page Image Contents