Poulan 96018000500, 532 43 88-96 manual Storage, Other, Fuel System, Engine OIL, Cylinders

Page 23

STORAGE

Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more.

WARNING: Never store the tractor with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter storage. When mower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

•Clean entire tractor (See “CLEANING” in the Mainte- nance section of this manual).

•Inspect and replace belts, if necessary (See belt re- placement instructions in the Service and Adjustments section of this manual).

•Lubricate as shown in the Maintenance section of this manual.

•Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

•Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

•Fully charge the battery for storage.

•After a period of time in storage, battery may require recharging.

•To help prevent corrosion and power leakage during long periods of storage, battery cables should be dis- connected and battery cleaned thoroughly (see “TO CLEAN BATTERY AND TERMINALS” in the Mainte- nance section of this manual).

•After cleaning, leave cables disconnected and place cables where they cannot come in contact with battery terminals.

•If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: IT IS IMPORTANT TO PREVENT GUM DEPOSITS FROM FORMING IN ESSENTIAL FUEL SYSTEM PARTS SUCH AS CARBURETOR, FUEL FILTER, FUEL HOSE, OR TANK DURING STORAGE. ALSO, EXPERIENCE INDICATES THAT ALCOHOL BLENDED FUELS (CALLED GASOHOL OR USING ETHANOL OR METHANOL) CAN ATTRACT MOISTURE WHICH LEADS TO SEPARATION AND FORMATION OF ACIDS DURING STORAGE. ACIDIC GAS CAN DAMAGE THE FUEL SYSTEM OF AN ENGINE WHILE IN STORAGE.

•Empty the fuel tank by starting the engine and let it run until the fuel lines and carburetor are empty.

•Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

•Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in mini- mizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor. Do not empty the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean en- gine oil. (See “ENGINE” in the Maintenance section of this manual).

CYLINDER(S)

•Remove spark plug(s).

•Pour one ounce of oil through spark plug hole(s) into cylinder(s).

•Turn ignition key to “START” position for a few seconds to distribute oil.

•Replace with new spark plug(s).

OTHER

•Do not store gasoline from one season to another.

•Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

•If possible, store your tractor indoors and cover it to give protection from dust and dirt.

•Cover your tractor with a suitable protective cover that does not retain moisture. Do not use plastic. Plastic cannot breathe which allows condensation to form and will cause your tractor to rust.

IMPORTANT: NEVER COVER TRACTOR WHILE ENGINE AND EXHAUST AREAS ARE STILL WARM.

23

Page 22 Page 24
Image 23
Page 22 Page 24
Contents PO15538LT II. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationIV. Towing ServiceIII. Children Table of Contents Steering Wheel Unassembled PartsBefore Removing Tractor from Skid AssemblyTools Required for Assembly To Remove Tractor from CartonCheck Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor Towing Carts and Other Attachments Reverse Operation System ROSTo Operate on Hills To TransportTo Start Engine See Fig Before Starting the EngineCheck Engine OIL Level ADD GasolineMowing Tips General Recommendations MaintenanceBlade Removal See Fig BatteryTractor Blade CareEngine IN-LINE Fuel Filter See Fig CleaningEngine Cooling System See Fig To Remove Mower See Fig Service and AdjustmentsTo Install Mower See Fig SIDE-TO-SIDE Adjustment See Figs To Level Mower HousingTo Replace Motion Drive Belt See Fig To Replace Mower Blade Drive Belt See FigTo Check Brake Front Wheel TOE-IN/CAMBER Transaxle Gear Shift Lever Neutral Adjustment See FigTo Adjust Steering Wheel Alignment To Start Engine with a Weak Battery See FigTo Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorEngine OIL StorageOther Fuel SystemTroubleshooting Points Excessive Service Notes Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationLimited Warranty

532 43 88-96, 96018000500 specifications

The Poulan 96018000500,532 43 88-96 is a versatile and powerful tool designed for various outdoor tasks, particularly for homeowners and landscaping professionals. This particular model stands out due to its robust performance and user-friendly features.

One of the notable characteristics of the Poulan 96018000500 is its powerful engine, which is engineered to deliver reliable performance for a range of applications. This engine not only provides sufficient power to handle tough cutting jobs but also ensures fuel efficiency, allowing users to complete their tasks without frequent refueling interruptions.

In addition to its engine, the Poulan 96018000500 incorporates advanced technology that enhances its usability. The tool features an intuitive starting mechanism that simplifies the ignition process, making it easier for users to start the machine with minimal effort. This is particularly beneficial for those who may not have extensive experience with outdoor equipment.

The design of the Poulan 96018000500 is also noteworthy. It features an ergonomic handle that provides a comfortable grip and reduces user fatigue during extended use. This is an important consideration for landscaping work, where operators may be required to use the tool for long periods. The lightweight construction of the equipment contributes to its maneuverability, allowing users to work efficiently in various terrains.

Durability is another key characteristic of the Poulan 96018000500. Constructed with high-quality materials, this tool is built to withstand harsh outdoor conditions and resist wear and tear. This reliability ensures that users can depend on their equipment for years without compromising performance.

Moreover, the Poulan 96018000500 is designed for versatility. It is compatible with a range of attachments, allowing users to convert it for different tasks such as trimming, edging, and blowing debris. This adaptability makes it an essential addition to any homeowner's toolkit or professional landscaper's arsenal.

In summary, the Poulan 96018000500,532 43 88-96 combines power, efficiency, and user-centric design, making it a standout choice for outdoor maintenance. With its advanced starting technology, ergonomic features, and durability, this tool meets the demands of both casual users and professionals alike. Whether tackling simple yard maintenance or more demanding landscaping tasks, the Poulan 96018000500 proves to be a reliable partner in enhancing outdoor spaces.
Top Page Image Contents