Poulan 438511, PO14542LT manual Before Starting the Engine, Check Engine OIL Level, ADD Gasoline

Page 12

OPERATION

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL

The engine in your tractor has been shipped, from the factory, already filled with summer weight oil.

•Check engine oil with tractor on level ground.

•Remove oil fill cap/dipstick and wipe clean, reinsert the dipstick and screw cap tight, wait for a few seconds, remove and read oil level. If necessary, add oil until “FULL” mark on dipstick is reached. Do not overfill.

•For cold weather operation you should change oil for easier starting (See “OIL VISCOSITY CHART” in the Maintenance section of this manual).

•To change engine oil, see the Maintenance section in this manual.

ADD GASOLINE

•Fill fuel tank to bottom of filler neck. Do not overfill. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness.

CAUTION: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

IMPORTANT: WHEN OPERATING IN TEMPERATURES BELOW 32°F (0°C), USE FRESH, CLEAN WINTER GRADE GASOLINE TO HELP ENSURE GOOD COLD WEATHER STARTING.

CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract mois- ture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

TO START ENGINE (See Fig. 4)

When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.

•Sit on seat in operating position, depress clutch/brake pedal and set parking brake.

•Place gear shift lever in neutral position.

•Move attachment clutch to “DISENGAGED” position.

•Move throttle control to choke position.

NOTE: Before starting, read the warm and cold starting procedures below.

•Insert key into ignition and turn key clockwise to “START” position and release key as soon as engine starts. Do not run starter continuously for more than fifteen seconds per minute. If the engine does not start after several attempts, move throttle control to fast position, wait a few minutes and try again. If engine still does not start, move the throttle control back to the choke position and retry.

WARM WEATHER STARTING (50°F/10°C and above)

•When engine starts, move the throttle control to the fast position.

•The attachments and ground drive can now be used. If the engine does not accept the load, restart the engine and allow it to warm up for one minute using the choke as described above.

COLD WEATHER STARTING (50°F/10°C and below)

•When engine starts, allow engine to run with the throttle control in the choke position until the engine runs roughly, then move throttle control to fast posi- tion. This may require an engine warm-up period from several seconds to several minutes, depending on the temperature.

•The attachments can also be used during the engine warm-up period.

NOTE: If at a high altitude (above 3000 feet) or in cold temperatures (below 32° F /0°C) the carburetor fuel mixture may need to be adjusted for best engine performance. See “TO ADJUST CARBURETOR” in the Service and Adjust- ments section of this manual.

12

Page 11 Page 13
Image 12
Page 11 Page 13
Contents PO14542LT Safety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationService III. ChildrenIV. Towing Table of Contents Unassembled Parts Steering WheelAssembly Tools Required for AssemblyTo Remove Tractor from Carton Before Removing Tractor from SkidCheck Deck Levelness Check for Proper Position of ALL BeltsCheck Brake System Check Tire PressureOperation Know Your Tractor HOW to USE Your Tractor Reverse Operation System ROS To Operate on HillsTo Transport Towing Carts and Other AttachmentsBefore Starting the Engine Check Engine OIL LevelADD Gasoline To Start Engine See FigMowing Tips Maintenance General RecommendationsBattery TractorBlade Care Blade Removal See FigTransaxle Maintenance EngineBelts LubricationCleaning Clean AIR ScreenAIR Filter MufflerService and Adjustments To Install Mower See FigTo Remove Mower See Fig To Level Mower Housing FRONT-TO-BACK Adjustment See FigsTo Replace Mower Blade Drive Belt See Fig To Check BrakeTo Replace Motion Drive Belt See Fig Transaxle Gear Shift Lever Neutral Adjustment See Fig To Adjust Steering Wheel AlignmentTo Start Engine with a Weak Battery See Fig Front Wheel TOE-IN/CAMBERTo Adjust Throttle Control Cable To Adjust Choke ControlTo Adjust Carburetor To Replace Headlight BulbStorage OtherFuel System Engine OILTroubleshooting Points Excessive Service Notes Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAXLimited Warranty
Related manuals
Manual 20 pages 52.33 Kb

96012011200, PO14542LT, 438511 specifications

The Poulan PO14542LT is a powerful and versatile lawn tractor designed to make yard care easier for homeowners. With its robust features and advanced technologies, this ride-on mower stands out as an excellent choice for those managing medium to large-sized lawns.

One of the main features of the Poulan PO14542LT is its 14.5 horsepower Briggs & Stratton engine. The engine provides reliable power to tackle tough mowing tasks, ensuring efficient cutting and handling of overgrown grass. Coupled with an automatic transmission, the tractor allows for smooth speed adjustments without the need for manual gear shifting, enhancing user convenience and comfort.

The cutting deck is another standout characteristic of the PO14542LT. With a 42-inch width, the deck is designed to deliver a clean and even cut, helping to reduce the number of passes required on your lawn. It also features a 3-in-1 cutting system that allows users to choose between mulching, bagging, or side discharge options, providing flexibility based on the specific needs of the lawn.

In terms of ergonomics, the Poulan PO14542LT is designed with the user in mind. The high-back seat provides comfort during long mowing sessions, while the easy-to-reach controls allow for effortless operation. The steering wheel is designed for ease of maneuverability, making it simple to navigate around obstacles in the yard.

Safety is a priority in the design of this tractor. The PO14542LT comes equipped with a safety switch that ensures the engine will shut off if the operator leaves the seat while the mower is engaged. Additionally, the tractor includes oversized batteries and an efficient fuel economy, allowing for extended operation between refuels.

Poulan also incorporates advanced technologies into the PO14542LT. The dual-blade cutting system enhances grass chopping capabilities, promoting healthier lawn growth by finely cutting the grass clippings that are returned to the soil. This, combined with the mulching capability, supports environmentally friendly yard maintenance.

In conclusion, the Poulan PO14542LT is an impressive lawn tractor that excels in performance, comfort, and versatility. Its combination of power, user-friendly features, and safety mechanisms makes it an ideal companion for homeowners seeking to achieve a beautifully maintained lawn with minimal effort. Whether it’s routine mowing or tackling tougher terrains, the PO14542LT proves to be a reliable choice for any lawn care endeavor.
Top Page Image Contents