Poulan 433480 manual To Replace Mower Blade Drive Belt See Fig, To Check Brake, Belt Removal

Page 21

SERVICE AND ADJUSTMENTS

TO REPLACE MOWER BLADE DRIVE BELT (See Fig. 33)

The mower blade drive belt may be replaced without tools. Park the tractor on level surface. Engage parking brake.

BELT REMOVAL -

•Remove mower from tractor (See “TO REMOVE MOWER” in this section of manual).

•Work belt off both mandrel pulleys and idler pulleys.

•Pull belt away from mower.

BELT INSTALLATION -

•Work belt around both mandrel pulleys and idler pulleys.

•Make sure belt is in all pulley grooves and inside all belt guides.

•Install mower (See "To Install Mower" in this section of manual).

MANDRELIDLER

PULLEYPULLEYS

MANDREL

PULLEY

Fig. 33

TO CHECK BRAKE

If tractor requires more than five (5) feet to stop at highest speed in highest gear on a level, dry concrete or paved surface, then brake must be serviced.

You may also check brake by:

1.Park tractor on a level, dry concrete or paved surface, depress brake pedal all the way down and engage parking brake.

2.Disengage transmission by placing freewheel control in “transmission disengaged” position. Pull freewheel control out and into the slot and release so it is held in the disengaged position.

The rear wheels must lock and skid when you try to manu- ally push the tractor forward. If the rear wheels rotate, then the brake needs to be serviced. Contact a qualified service center.

TO REPLACE MOTION DRIVE BELT (See Fig. 34)

Park the tractor on level surface. Engage parking brake. For assistance, there is a belt installation guide decal on bottom side of left footrest.

BELT REMOVAL -

•Remove mower (See “TO REMOVE MOWER” section in this manual).

NOTE: Observe entire motion drive belt and position of all belt guides and keepers.

•Remove belt from stationary idler (A) and clutching idler (B).

•Remove belt from centerspan idler (C).

•Pull belt slack toward rear of tractor. Carefully remove belt upwards from transmission input pulley and over cooling fan blades (D).

•Remove belt downward from engine pulley (E).

•Slide belt toward rear of tractor, off the steering plate

(F) and remove from tractor.

BELT INSTALLATION -

•Install new belt from tractor rear to front, over the steer- ing plate (F) and above clutch brake pedal shaft (G).

•Pull belt toward front of tractor and roll belt onto engine pulley (E).

•Pull belt toward rear of tractor. Carefully work belt down around transmission cooling fan and onto the input pulley (D). Be sure belt is inside the belt keeper.

•Install belt on centerspan idler (C).

•Install belt through stationary idler (A) and clutching idler (B).

•Make sure belt is in all pulley grooves and inside all belt guides and keepers.

•Install mower (See “TO INSTALL MOWER” section in this manual).

 

E

 

F

A

 

B

G

 

C

 

D

02952

Fig. 34

21

Page 20 Page 22
Image 21
Page 20 Page 22
Contents Model PB195H42LTSafe Operation Practices for Ride-On Mowers Safety RulesGeneral Operation II. Slope OperationService III. ChildrenIV. Towing Table of Contents Steering Wheel Unassembled PartsTools Required for Assembly AssemblyToremovetractorfromcarton Before Removing Tractor from SkidCheck Tire Pressure To Adjust Seat See FigCheck Deck Levelness Check Brake SystemOperation Know Your Tractor To SET Parking Brake See Fig HOW to USE Your TractorTo USE Throttle Control D See Fig Stopping See FigTo Adjust Gauge Wheels See Fig To Adjust Mower Cutting Height See FigReverse Operation System ROS To Operate MowerTo Operate on Hills Before Starting the EngineTowing Carts and Other Attachments Check Engine OIL LevelMowing Tips Purge TransmissionAutomatic Transmission Warm UP Maintenance MaintenanceGeneral Recommendations ScheduleBattery TractorBlade Removal See Fig Engine Engine Cooling System See Fig CleaningMuffler Spark PlugsService and Adjustments To Install Mower See FigTo Remove Mower See Fig Install belt on engine pulley M, in belt keepers G Turn nut right Turn nut left To raise mower To lower mower To Level MowerTo Replace Mower Blade Drive Belt See Fig Belt InstallationTo Check Brake To Replace Motion Drive Belt See FigTo Start Engine with a Weak Battery See Fig Transaxle Motion Control Lever Neutral Adjustment See FigTo Adjust Steering Wheel Alignment Front Wheel TOE-IN/CAMBERTransmission Other StorageFuel System Engine OILTroubleshooting Troubleshooting Points Fold Along This Dotted Line Degree Slope Only Ride UP and Down Hill Not Across Hill Degrees MAXHOP Outdoor Products Customer Service DeptCanada contact Stevens Creek Road Terry Fox Way Augusta, GA 30907 USADept Service Customer Products Outdoor Canada Au AutoriséGarantie cette de exclus sont normal l’entretien et Degrés Moteur le quand ieux Dépannage DE GuidePuissance de Entreposage Moteur Réglages ET RévisionCarburateur LE Régler Pour CalandrelaetcapotleenleverpourRossage -AVANT/CAR Roues DES Convergence DI LA DE L’ALIGNEMENT Régler PourTionrec Tondeuse DE Lame DE Mentnetraî Fig la Voir D’ENTRAÎNEMENT Courroie a L Acer Rempl Pour’EN Courroie LA Remplacer Pour Freins LES Vérifier Pour32 .Fig Tondeuse LA Niveau LE Ajuster Pour31 .Fig 30 .Fig27 .Fig 28 .Fig25 .Fig 24 .FigTondeuse LA Enlever Pour Fig Voir23 .Fig GagedMontage Ligne EN Installé D’ESSENCE Filtre’ALLUMAGE Bougie Fig la Voir Ventilation DE Système’AIR Tamis LE Nettoyer EntretienAIR À Filtre Sionmistrans LA DE Moteur FluideLames DES Entretien Fig la Voir Lame LA EnleverPneus Frein DU FonctionnementCe de Réglages et Etretien section la dans réglages les Tous Utilisation Chaque AvantTransmission LA Purger UtilisationTonte DE Conseils 15 .FigMoteur LE Démarrer Pour Accessoires Autres’ESSENCE Réservoir LE Remplir ET Charrettes DES Remorquer PourJauge DE Roues LES Régler Pour Tondeuse DE Lames LES Arrêter PourROS Arrière CHE -MAR EN Fonctionnement DE Système Fig la Voir Mentne -TIONSTA DE Frein LE Engager Pour GAZ DES Commande LA Utiliser PourReculer Pour ET Avancer Pour Fig la Voir Arrêter Pour 6 .Fig’OPÉRA DE Présence DE Système DU Commutateur Propriété la de lendommagement Frein DE Système LE Vérifier Place EN CorrectementNiveau DE EST Tondeuse LA SI Vérifier Et 3 .Figs les Voir Siège LE Ajustez Tracteur Votre DE Getamon LE Pour Exigés Outils LESFig la Voir Batterie LA Vérifier Palette DE Tracteur LE Retirer AvantSiège Assemblé PAS PiècesSommaire U1R DimensionCCA .MIN AMP/HR SL-SG-APITracteurs des sécurité toute Sécurité DE RèglesEnfants En l’utilisation pour ConseilsTracteurs des sécurité toute en l’utilisation pour Conseils AvertissementPentes LES Dans Fonctionnement Général Fonctionnement433480
Top Page Image Contents