Poulan PB26H54YT, 433432 To USE Cruise Control J See Fig, To Adjust Mower Cutting Height See Fig

Page 13

OPERATION

K

J

L

Fig. 20

TO USE CRUISE CONTROL (J) (See Fig. 20)

The cruise control feature can be used for forward travel only.

SYSTEM CHARACTERISTICS

The cruise control should only be used while mowing or transporting on relatively smooth, straight surfaces. Other conditions such as trimming at slow speeds may cause the cruise control to disengage. Do not use the cruise control on slopes, rough terrian or while trimmimg or turning.

•With forward drive pedal depressed to desired speed, pull cruise control lever (J) up and hold while lifting your foot off the pedal, then release the lever.

To disengage the cruise control, depress the brake pedal or tap on forward drive pedal.

TO ADJUST MOWER CUTTING HEIGHT (See Fig. 21)

The position of the attachment lift lever (A) determines the cutting height.

A

T

Fig. 21

•Put attachment lift lever in desired cutting height slot.

•Slide pointer tab (T) to desired cutting height as a reminder for next time you mow.

The cutting height range is approximately 1" to 4". The heights are measured from the ground to the blade tip with the engine not running. These heights are approximate and may vary depending upon soil conditions, height of grass and types of grass being mowed.

•The average lawn should be cut to approximately 2-1/2" during the cool season and to over 3" during hot months. For healthier and better looking lawns, mow often and after moderate growth.

•For best cutting performance, grass over 6" in height should be mowed twice. Make the first cut relatively high; the second to desired height.

TO ADJUST GAUGE WHEELS (See Fig. 22)

Gauge wheels are properly adjusted when they are slightly off the ground when mower is at the desired cutting height in operating position. Gauge wheels then keep the deck in prop- er position to help prevent scalping in most terrain conditions.

NOTE:Adjust gauge wheels with tractor on a flat level surface.

•Adjust mower to desired cutting height (See “TO AD- JUST MOWER CUTTING HEIGHT” in the Operation section of this manual).

•With mower in desired height of cut position, gauge wheels should be assembled so they are slightly off the ground. Install gauge wheel in appropriate hole as shown and tighten securely.

•Repeat for opposite side installing gauge wheel in same adjustment hole.

Fig. 22

TO OPERATE MOWER

Your tractor is equipped with an operator presence sensing switch. Any attempt by the operator to leave the seat with the engine running and the attachment clutch engaged will shut off the engine. You must remain fully and centrally positioned in the seat to prevent the engine from hesitat- ing or cutting off when operating your equipment on rough, rolling terrain or hills.

•Select desired height of cut (see "TO ADJUST MOWER CUTTING HEIGHT")

•Start mower blades by engaging attachment clutch control.

TO STOP MOWER BLADES

Disengage attachment clutch control.

CAUTION: Do not operate the mower without either the entire grass catcher, on mowers so equipped, or the deflector shield

(S) in place (See Fig. 23).

S

FIG. 23

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents PB26H54YT Safe Operation Practices for Ride-On Mowers Safety RulesGeneral Operation II. Slope OperationGeneral Service ServiceIII. Children IV. TowingTable of Contents Mower Mower Front Wheel Unassembled PartsTools Required for Assembly AssemblyToremovetractorfromcarton Before Removing Tractor from SkidTurn Steering Wheel Left and Position Mower See Fig Install ANTI-SWAY BAR S if Equipped SeeANTI-SWAY BAR S Attach Rear Lift Links C See Fig Attach Mower Side Suspension Arms a to Chassis See FigAttach Front Link E See Fig Check Tire Pressure Install Belt on Engine Clutch Pulley M SeeCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor To SET Parking Brake See Fig HOW to USE Your TractorStopping See Fig To USE Throttle Control D See FigTo Adjust Gauge Wheels See Fig To Adjust Mower Cutting Height See FigTo USE Cruise Control J See Fig To Operate MowerBefore Starting the Engine Purge Transmission To Start Engine See FigAutomatic Transmission Warm UP Mowing Tips Maintenance MaintenanceGeneral Recommendations ScheduleTractor BatteryBlade Care Blade Removal See FigEngine IN-LINE Fuel Filter See Fig CleaningDeck Washout Port See Fig To Install Mower Service and AdjustmentsTo Remove Mower See Fig To Replace Mower Blade Drive Belt See FigTo Level Mower To Check Brake To Replace Motion Drive Belt See FigFront Wheel TOE-IN/CAMBER To Remove Wheel See FigReplacing Battery See Fig To Start Engine with a Weak Battery See FigTo Attach Jumper Cables To Remove CABLES, Reverse OrderTransmission Other StorageFuel System Engine OILProblem Cause Correction TroubleshootingBattery will not To run when operFires when turn Engine continuesSuggested Guide for Sighting Slopes for Safe Operation Limited Warranty

433432, PB26H54YT, 96042011000 specifications

The Poulan PB26H54YT, model number 96042011000, is a versatile and powerful lawn tractor designed for homeowners seeking a reliable solution for their yard maintenance needs. This lawn tractor stands out in the market for its combination of features, technological advancements, and user-friendly characteristics, making it an excellent choice for both novice and experienced users.

One of the main features of the PB26H54YT is its robust 26-horsepower engine. This powerful engine ensures that the tractor can handle a variety of tasks, from mowing to towing, without sacrificing performance. The engine is paired with a hydrostatic transmission, allowing for smooth and effortless speed adjustments. This feature is particularly advantageous for navigating complex landscapes, as it provides precise control over speed and direction.

The PB26H54YT is equipped with a 54-inch cutting deck, which enables users to mow large areas efficiently. The cutting deck design includes reinforced edges, enhancing durability and preventing wear over time. Additionally, the deck is adjustable, allowing users to select the desired cutting height for their specific grass type and growth conditions. This adaptability ensures a clean and professional-looking cut every time.

Another noteworthy characteristic is the tractor's ease of operation. The intuitive control panel includes a comfortable seat with a high backrest, providing excellent support during long mowing sessions. The steering wheel is ergonomically designed for user comfort, while the pedal-operated transmission enhances maneuverability. Users will also appreciate the electric start feature, which eliminates the need for pull cords, making starting the engine a breeze.

Safety is a top priority with the PB26H54YT, as it is equipped with essential safety features such as a cut-off switch that activates when the operator leaves the seat. This feature helps prevent accidents, providing peace of mind to users while operating the tractor. Additionally, the wide rear tires offer enhanced traction, ensuring stability on uneven terrain, which is a common challenge in many yards.

Overall, the Poulan PB26H54YT,96042011000,433432 combines power, efficiency, and user-centered design, making it an ideal solution for residential lawn care. Whether it's mowing, hauling, or handling other yard tasks, this lawn tractor is built to deliver reliability and performance, ensuring that your lawn remains well-maintained all season long.
Top Page Image Contents