Poulan 433432, 96042011000, PB26H54YT manual Storage, Other, Fuel System, Engine OIL, Cylinders

Page 26

STORAGE

Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more.

WARNING: Never store the tractor with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter storage. When mower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

•Clean entire tractor (See “CLEANING” in the Mainte- nance section of this manual).

•Inspect and replace belts, if necessary (See belt re- placement instructions in the Service and Adjustments section of this manual).

•Lubricate as shown in the Maintenance section of this manual.

•Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

•Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

•Fully charge the battery for storage.

•After a period of time in storage, battery may require recharging.

•To help prevent corrosion and power leakage during long periods of storage, battery cables should be dis- connected and battery cleaned thoroughly (see “TO CLEAN BATTERY AND TERMINALS” in the Mainte- nance section of this manual).

•After cleaning, leave cables disconnected and place cables where they cannot come in contact with battery terminals.

•If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: IT IS IMPORTANT TO PREVENT GUM DEPOSITS FROM FORMING IN ESSENTIAL FUEL SYSTEM PARTS SUCH AS CARBURETOR, FUEL FILTER, FUEL HOSE, OR TANK DURING STORAGE. ALSO, EXPERIENCE INDICATES THAT ALCOHOL BLENDED FUELS (CALLED GASOHOL OR USING ETHANOL OR METHANOL) CAN ATTRACT MOISTURE WHICH LEADS TO SEPARATION AND FORMATION OF ACIDS DURING STORAGE. ACIDIC GAS CAN DAMAGE THE FUEL SYSTEM OF AN ENGINE WHILE IN STORAGE.

•Empty the fuel tank by starting the engine and let it run until the fuel lines and carburetor are empty.

•Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

•Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in mini- mizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor. Do not empty the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean en- gine oil. (See “ENGINE” in the Maintenance section of this manual).

CYLINDER(S)

•Remove spark plug(s).

•Pour one ounce of oil through spark plug hole(s) into cylinder(s).

•Turn ignition key to “START” position for a few seconds to distribute oil.

•Replace with new spark plug(s).

OTHER

•Do not store gasoline from one season to another.

•Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

•If possible, store your tractor indoors and cover it to give protection from dust and dirt.

•Cover your tractor with a suitable protective cover that does not retain moisture. Do not use plastic. Plastic cannot breathe which allows condensation to form and will cause your tractor to rust.

IMPORTANT: NEVER COVER TRACTOR WHILE ENGINE AND EXHAUST AREAS ARE STILL WARM.

26

Page 25 Page 27
Image 26
Page 25 Page 27
Contents PB26H54YT General Operation Safety RulesSafe Operation Practices for Ride-On Mowers II. Slope OperationIII. Children ServiceGeneral Service IV. TowingTable of Contents Unassembled Parts Mower Mower Front WheelToremovetractorfromcarton AssemblyTools Required for Assembly Before Removing Tractor from SkidANTI-SWAY BAR S Install ANTI-SWAY BAR S if Equipped SeeTurn Steering Wheel Left and Position Mower See Fig Attach Front Link E See Fig Attach Mower Side Suspension Arms a to Chassis See FigAttach Rear Lift Links C See Fig Check Deck Levelness Install Belt on Engine Clutch Pulley M SeeCheck Tire Pressure Check for Proper Position of ALL BeltsOperation Know Your Tractor Stopping See Fig HOW to USE Your TractorTo SET Parking Brake See Fig To USE Throttle Control D See FigTo USE Cruise Control J See Fig To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig To Operate MowerBefore Starting the Engine Automatic Transmission Warm UP To Start Engine See FigPurge Transmission Mowing Tips General Recommendations MaintenanceMaintenance ScheduleBlade Care BatteryTractor Blade Removal See FigEngine Deck Washout Port See Fig CleaningIN-LINE Fuel Filter See Fig To Remove Mower See Fig Service and AdjustmentsTo Install Mower To Replace Mower Blade Drive Belt See FigTo Level Mower Front Wheel TOE-IN/CAMBER To Replace Motion Drive Belt See FigTo Check Brake To Remove Wheel See FigTo Attach Jumper Cables To Start Engine with a Weak Battery See FigReplacing Battery See Fig To Remove CABLES, Reverse OrderTransmission Fuel System StorageOther Engine OILTroubleshooting Problem Cause CorrectionFires when turn To run when operBattery will not Engine continuesSuggested Guide for Sighting Slopes for Safe Operation Limited Warranty

433432, PB26H54YT, 96042011000 specifications

The Poulan PB26H54YT, model number 96042011000, is a versatile and powerful lawn tractor designed for homeowners seeking a reliable solution for their yard maintenance needs. This lawn tractor stands out in the market for its combination of features, technological advancements, and user-friendly characteristics, making it an excellent choice for both novice and experienced users.

One of the main features of the PB26H54YT is its robust 26-horsepower engine. This powerful engine ensures that the tractor can handle a variety of tasks, from mowing to towing, without sacrificing performance. The engine is paired with a hydrostatic transmission, allowing for smooth and effortless speed adjustments. This feature is particularly advantageous for navigating complex landscapes, as it provides precise control over speed and direction.

The PB26H54YT is equipped with a 54-inch cutting deck, which enables users to mow large areas efficiently. The cutting deck design includes reinforced edges, enhancing durability and preventing wear over time. Additionally, the deck is adjustable, allowing users to select the desired cutting height for their specific grass type and growth conditions. This adaptability ensures a clean and professional-looking cut every time.

Another noteworthy characteristic is the tractor's ease of operation. The intuitive control panel includes a comfortable seat with a high backrest, providing excellent support during long mowing sessions. The steering wheel is ergonomically designed for user comfort, while the pedal-operated transmission enhances maneuverability. Users will also appreciate the electric start feature, which eliminates the need for pull cords, making starting the engine a breeze.

Safety is a top priority with the PB26H54YT, as it is equipped with essential safety features such as a cut-off switch that activates when the operator leaves the seat. This feature helps prevent accidents, providing peace of mind to users while operating the tractor. Additionally, the wide rear tires offer enhanced traction, ensuring stability on uneven terrain, which is a common challenge in many yards.

Overall, the Poulan PB26H54YT,96042011000,433432 combines power, efficiency, and user-centered design, making it an ideal solution for residential lawn care. Whether it's mowing, hauling, or handling other yard tasks, this lawn tractor is built to deliver reliability and performance, ensuring that your lawn remains well-maintained all season long.
Top Page Image Contents