TROUBLESHOOTING CHART:
PROBLEM | CAUSE | CORRECTION | ||
Poor grass | 1. | Engine speed too slow. | 1. | Place throttle control in “FAST” |
discharge |
|
|
| position. |
| 2. | Travel speed too fast. | 2. | Shift to slower speed. |
| 3. | Wet grass. | 3. | Allow grass to dry before |
|
|
|
| mowing. |
| 4. | Mower deck not level. | 4. | Level mower deck. |
| 5. | Low/uneven tire air pressure. | 5. | Check tires for proper air |
|
|
|
| pressure. |
| 6. | Worn, bent or loose blade. | 6. | Replace/sharpen blade. |
|
|
|
| Tighten blade bolt. |
| 7. | Buildup of grass, leaves and | 7. | Clean underside of mower |
|
| trash under mower. |
| housing. |
| 8. | Mower drive belt worn. | 8. | Replace mower drive belt. |
| 9. | Blades improperly installed. | 9. | Reinstall blades sharp edge |
|
|
|
| down. |
| 10. Improper blades used. | 10. Replace with blades listed | ||
|
|
|
| in this manual. |
| 11. Clogged mower deck vent | 11. Clean around mandrels to | ||
|
| holes from buildup of grass, |
| open vent holes. |
|
| leaves, and trash around |
|
|
|
| mandrels. |
|
|
|
|
|
|
|
Headlight(s) not | 1. | Switch is “OFF”. | 1. | Turn switch “ON”. |
working | 2. | Bulb(s) or lamp(s) burned out. | 2. | Replace bulb(s) or lamp(s). |
(if so equipped) | 3. | Faulty light switch. | 3. | Check/replace light switch. |
| 4. | Loose or damaged wiring. | 4. | Check wiring and connections. |
| 5. | Blown fuse. | 5. | Replace fuse. |
|
|
|
|
|
Battery will not | 1. | Bad battery cell(s). | 1. | Replace battery. |
charge | 2. | Poor cable connections. | 2. | Check/clean all connections. |
| 3. | Faulty regulator | 3. | Replace regulator. |
|
| (if so equipped). |
|
|
| 4. | Faulty alternator. | 4. | Replace alternator. |
|
|
|
|
|
Loss of drive | 1. | Freewheel control in | 1. | Place freewheel control in |
|
| “disengaged” position. |
| “engaged” position. |
| 2. | Motion drive belt worn, | 2. | Replace motion drive belt. |
|
| damaged, or broken. |
|
|
| 3. | Air trapped in transmission | 3. | Purge transmission. |
|
| during shipment or servicing. |
|
|
|
|
|
|
|
Engine “backfires” | 1. | Engine throttle control not | 1. | Move throttle control to |
when turning |
| set at “SLOW” position for 30 |
| “SLOW” position and allow |
engine “OFF” |
| seconds before stopping |
| to idle for 30 seconds before |
|
| engine. |
| stopping engine. |
|
|
|
|
|
30