Poulan HD21H42 manual To Check and Adjust Brake, To Replace Motion Drive Belt See Fig

Page 21

SERVICE AND ADJUSTMENTS

TO CHECK AND ADJUST BRAKE

(See Fig. 20)

Your tractor is equipped with an adjustable brake system which is mounted on the right side of the transaxle.

If tractor requires more than five (5) feet to stop at highest speed in highest gear on a level, dry concrete or paved surface, then brake must be checked and adjusted.

TO CHECK BRAKE

•Park tractor on a level, dry concrete or paved surface, depress clutch/brake pedal all the way down and en- gage parking brake.

•Disengage transmission by placing freewhel control in “transmission disengaged” position. Pull freewheel control out and into the slot and release so it is held in the disengaged position.

The rear wheels must lock and skid when you try to manually push the tractor forward. If the rear wheels rotate, the brake needs to be adjusted or the pads need to be replaced.

TO ADJUST BRAKE

•Depress clutch/brake pedal all the way down and en- gage parking brake.

•Measure distance between brake operating arm and nut “A” on brake rod.

•If distance is other than 1-9/16", loosen jam nut and turn nut “A” until distance becomes 1-9/16". Retighten jam nut against nut “A”.

•Engage transmission by placing freewheel control in “transmission engaged” position.

•Road test tractor for proper stopping distance as stated above. Readjust if necessary. If stopping distance is still greater than five (5) feet in highest gear, further maintenance is necessary. Replace brake pads or contact a qualified service center.

WITH PARKING BRAKE “ENGAGED”

NUT “A”

1-9/16”

JAM NUT

 

OPERATING

ARM

01513

DO NOT TOUCH THIS NUT. IF FURTHER

BRAKE ADJUSTMENT IS NECESSARY CON-

TACT YOUR NEAREST AUTHORIZED SERVICE

CENTER/DEPARTMENT

FIG. 20

TO REPLACE MOTION DRIVE BELT (See Fig. 21)

Park the tractor on level surface. Engage parking brake. For assistance, there is a belt installation guide decal on bottom side of left footrest.

BELT REMOVAL -

•Remove mower (See “TO REMOVE MOWER” in this section of manual).

NOTE: Observe entire motion drive belt and position of all belt guides and keepers.

•Remove belt from stationary idler and clutching idler.

•Remove belt downward from around engine pulley.

•Pull belt slack toward rear of tractor. Carefully remove belt upwards from transmission input pulley and over cooling fan blades.

•Remove belt from center span keeper and pull belt away from tractor.

BELT INSTALLATION -

•Carefully work new belt down around transmission cooling fan and onto the input pulley.

•Slide belt into the center span keeper.

•Pull belt toward front of tractor and roll around the top groove of engine pulley.

•Install belt through stationary idler and clutching idler.

•Make sure belt is in all pulley grooves and inside all belt guides and keepers.

•Install mower (See “TO INSTALL MOWER” in this sec- tion of manual).

ENGINE

PULLEY

CLUTCHING

IDLER

STATIONARY

IDLER

TRANSMISSION

INPUT PULLEYCENTER SPAN KEEPER

FIG. 21

TRANSAXLE MOTION CONTROL LEVER NEUTRAL ADJUSTMENT (See Fig. 22)

The motion control lever has been preset at the factory and adjustment should not be necessary.

•Loosen adjustment bolt in front of the right rear wheel, and lightly tighten.

•Start engine and move motion control lever until tractor does not move forward or backward.

•Hold motion control lever in that position and turn engine

21 off.

Page 20 Page 22
Image 21
Page 20 Page 22
Contents Always Wear EYE Protection During Operation HD21H42Safe Operation Practices for Ride-On Mowers Safety RulesGeneral Operation II. Slope OperationGeneral Service ServiceIII. Children IV. TowingTable of Contents Unassembled Parts Steering Wheel SeatSlope Sheet Tools Required for Assembly AssemblyTo Remove Tractor from Carton Before Removing Tractor from SkidCheck Battery See Fig Check Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To Operate Mower See Fig Using the Reverse Operation SystemReverse Operation System ROS To Operate on HillsCheck Engine OIL Level Before Starting the EngineADD Gasoline To Start Engine See FigPurge Transmission Mowing TipsLubrication Chart MaintenanceGeneral Recommendations Before Each USETractor Blade Removal See FigTo Sharpen Blade See Fig Engine Cleaning To Install Mower See Fig Service and AdjustmentsTo Level Mower Housing To Remove Mower See FigBelt Installation To Replace Mower Blade Drive Belt See FigBelt Removal Transaxle Motion Control Lever Neutral Adjustment See Fig To Check and Adjust BrakeSee Fig To Replace Motion Drive Belt See FigTo Adjust Steering Wheel ALIGN- Ment Transmission REMOVAL/REPLACEMENTTo Start Engine with a Weak Battery See Fig Front Wheel TOE-IN/CAMBERTo Adjust Choke Control To Adjust Throttle Control CableTo Adjust Carburetor To Replace Headlight BulbOther StorageFuel System Engine OILProblem Cause Correction Troubleshooting PointsEngine dies when Limited Warranty Service Notes Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationParts and Service

HD21H42 specifications

The Poulan HD21H42 lawn tractor is a powerful and versatile lawn care machine, designed to meet the needs of homeowners with medium to large-sized lawns. This tractor is equipped with a robust 21 horsepower Briggs & Stratton engine, providing the ideal balance between power and efficiency. Its reliable engine ensures smooth operation while delivering ample torque for tackling various terrains and grass conditions.

One of the standout features of the HD21H42 is its 42-inch cutting deck, which allows for efficient mowing of larger areas. The deck is designed with a durable steel construction, ensuring longevity and resistance to wear and tear. The cutting height is adjustable, offering a range of settings that cater to different grass types and seasonal growth patterns. This adaptability is crucial for achieving a perfectly manicured lawn.

The Poulan HD21H42 also incorporates an advanced hydrostatic transmission system. This technology allows for an effortless driving experience, offering infinite speed control without the need for shifting gears. Users can easily maneuver around obstacles and navigate tight spaces with confidence, significantly enhancing the tractor's usability.

Comfort is another key characteristic of the Poulan HD21H42. The tractor features an ergonomic seat that provides support during long mowing sessions, along with a high backrest for added comfort. The straightforward control panel simplifies operation, enabling users to focus on their mowing tasks without confusion. Additionally, the tractor's tight turning radius helps in making sharp turns, reducing the need for manual adjustments.

Maintenance is straightforward with the HD21H42, as its removable cutting deck makes it easy to access and clean. Regular maintenance routines contribute to prolonging the lifespan of the machine and ensuring consistent performance over time.

Moreover, the Poulan HD21H42 offers enhanced versatility with optional attachments such as mulching kits, baggers, and snow plows. This allows homeowners to extend the utility of their lawn tractor throughout different seasons, adapting it to varied tasks beyond just mowing.

In conclusion, the Poulan HD21H42 lawn tractor combines power, ease of use, and adaptability, making it an excellent choice for homeowners seeking a reliable lawn maintenance solution. Its advanced features and thoughtful design ensure that mowing the lawn is not only an obligation but a satisfying and efficient task.
Top Page Image Contents