Poulan pb19546lt manual Transaxle Gear Shift Lever NEUTRAL- Adjustment See Fig

Page 23

SERVICE AND ADJUSTMENTS

TRANSAXLE GEAR SHIFT LEVER NEUTRAL- ADJUSTMENT (See Fig. 26)

The transaxle should be in neutral when the gear shift lever is in neutral (N) (lock gate) position. The adjustment is preset at the factory; however, if adjustment is needed, proceed as follows:

•Make sure transaxle is in neutral (N).

NOTE: When the tractor rear wheels move freely, the transaxle is in neutral.

•Loosen adjustment bolt in front of the right rear wheel.

•Position the gear shift lever in the neutral (N) posi- tion.

•Tighten adjustment bolt securely.

NOTE: If additional clearance is needed to get to adjustment bolt, move mower deck height to the lowest position.

RETAINING WASHERS

RING

AXLE

COVER

SQUARE KEY (REAR

WHEEL ONLY)

FIG. 27

TO START ENGINE WITH A WEAK BATTERY (See Fig. 28)

GEARSHIFT LEVER

NEUTRAL LOCK GATE

WARNING: Lead-acid batteries gen- erate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the Maintenance section of this manual).

ADJUSTMENT

BOLT

FIG. 26

TO ADJUST STEERING WHEEL ALIGN- MENT

If steering wheel crossbars are not horizontal (left to right) when wheels are positioned straight forward, remove steer- ing wheel and reassemble per instructions in the Assembly section of this manual.

FRONT WHEEL TOE-IN/CAMBER

The front wheel toe-in and camber are not adjustable on your tractor. If damage has occurred to affect the front wheel toe-in or camber, contact your nearest authorized service center/department.

If “jumper cables” are used for emergency starting, follow this procedure:

IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.

TO ATTACH JUMPER CABLES -

•Connect one end of the RED cable to the POSITIVE

(+)terminal of each battery(A-B), taking care not to short against tractor chassis.

•Connect one end of the BLACK cable to the NEGATIVE (-) terminal (C) of fully charged battery.

•Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

•BLACK cable first from chassis and then from the fully charged battery.

•RED cable last from both batteries.

TO REMOVE WHEEL FOR REPAIRS (See Fig. 27)

•Block up axle securely.

•Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not lose).

•Repair tire and reassemble.

•On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.

•Replace washers and snap retaining ring securely in axle groove.

•Replace axle cover.

WEAK OR DEAD BATTERY

FULLY CHARGED

BATTERY

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and

corrosion.23

FIG. 28

Page 22 Page 24
Image 23
Page 22 Page 24
Contents PB19546LT II. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationIV. Towing ServiceGeneral Service III. ChildrenTable of Contents Contents of Hardware Pack Carton AssemblyTools Required for Assembly To Remove Tractor fromCheck Battery See Fig Check Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor HOW to USE Your Tractor To Operate Mower See Fig Using the Reverse Operation SystemReverse Operation System ROS Before Starting the Engine Mowing Tips General Recommendations MaintenanceTo Sharpen Blade See Fig TractorBlade Removal See Fig Transaxle Cooling BatteryEngine BeltsCleaning To Remove Mower See Fig Service and AdjustmentsTo Install Mower See Fig Install belt on engine pulley M, in belt keepers G To Level Mower Precision SIDE-TO-SIDE AdjustmentTo Check Brake Belt InstallationTo Replace Mower Drive Belt See Fig To Replace Motion Belt Drive See FigFront Wheel TOE-IN/CAMBER Transaxle Gear Shift Lever NEUTRAL- Adjustment See FigTo Start Engine with a Weak Battery See Fig To Adjust Steering Wheel ALIGN- MentTo Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorEngine OIL StorageOther Fuel SystemProblem Cause Correction Troubleshooting PointsEngine dies when Limited Warranty Tractor - Model Number PB19546LT 96042003500, Product no 42 SchematicElectrical KEY Part Description 162 DriveRepair Parts Chassis 194263 Drawbar Wheels and Tires Steering Engine Engine Power Rating Information Mower Deck Repair Parts Seat Mower Lift Service Notes Service Notes Service Notes Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationPolicy

pb19546lt specifications

The Poulan PB19546LT is a powerful and versatile lawn mower designed for homeowners seeking efficiency and performance in their lawn maintenance. Equipped with a robust 19.5 horsepower Briggs & Stratton engine, this mower delivers reliable power, making it well-suited for tackling various lawn sizes and terrains. The engine's design ensures smooth operation while minimizing vibrations, providing a more comfortable mowing experience.

One of the standout features of the PB19546LT is its 46-inch cutting deck, which allows for a wider cutting path. This size significantly reduces the time spent mowing, enabling users to cover large areas quickly. The deck is made from durable materials to withstand the rigors of outdoor use while ensuring a clean cut. Additionally, it includes a 2-in-1 cutting system, offering both mulching and bagging options, allowing users to choose the most efficient method for their lawn care needs.

Another key characteristic of the Poulan PB19546LT is its adjustable cutting height, which can be easily modified with a simple lever. This functionality provides adaptability to varying grass lengths and conditions, ensuring that users can achieve the desired lawn appearance. The mower also features a tight turning radius, making it easier to maneuver around obstacles such as trees or flower beds, enhancing overall mowing efficiency.

The PB19546LT comes equipped with a comfortable, ergonomic seat and steering wheel, allowing for extended mowing sessions without fatigue. The user-friendly instrument panel provides easy access to controls, including throttle and choke, simplifying the mowing process.

Moreover, this mower incorporates a reliable transmission system, which provides smooth acceleration and transition between speeds, an essential feature for tackling different terrains. The durable construction of the Poulan PB19546LT not only enhances its longevity but also ensures that it can withstand the challenges of regular lawn maintenance.

In summary, the Poulan PB19546LT is an excellent choice for homeowners seeking a mower that combines power, versatility, and ease of use. Its cutting-edge technologies, robust engine, and thoughtful design make it a strong contender in the lawn care market, offering a reliable solution for maintaining a beautiful lawn.
Top Page Image Contents