Poulan PC14542D owner manual Engine, Battery, Belts, Transaxle Cooling, Lubrication

Page 16

CUSTOMER RESPONSIBILITIES

BATTERY

Your tractor has a battery charging system which is suffi- cient for normal use. However, periodic charging of the battery with an automotive charger will extend its life.

•Keep battery and terminals clean.

•Keep battery bolts tight.

•Keep small vent holes open.

•Recharge at 6-10 amperes for 1 hour.

NOTE: The original equipment battery on your tractor is maintenance free. Do not attempt to open or remove caps or covers. Adding or checking level of electrolyte is not necessary.

TO CLEAN BATTERY AND TERMINALS

Corrosion and dirt on the battery and terminals can cause the battery to “leak” power.

•Open battery box door.

•Disconnect BLACK battery cable first then RED battery cable and remove battery from tractor.

•Rinse the battery with plain water and dry.

•Clean terminals and battery cable ends with wire brush until bright.

•Coat terminals with grease or petroleum jelly.

•Reinstall battery (See “REPLACING BATTERY” in the Service and Adjustments section of this manual).

V-BELTS

Check V-belts for deterioration and wear after 100 hours of operation and replace if necessary. The belts are not adjustable. Replace belts if they begin to slip from wear.

TRANSAXLE COOLING

Keep transaxle free from build-up of dirt and chaff which can restrict cooling.

ENGINE

LUBRICATION

Only use high quality detergent oil rated with API service classification SF-SJ. Select the oil’s SAE viscosity grade according to your expected operating temperature.

SAE VISCOSITY GRADES

 

 

 

 

 

 

 

 

 

 

SAE 30

 

 

 

 

 

 

5W-30

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

F

-20

0

 

 

30 32 40

 

60

80

100

C

-30

-20

-10

0

10

20

30

40

TEMPERATURE RANGE ANTICIPATED BEFORE NEXT OIL CHANGE

FIG. 11

NOTE: Although multi-viscosity oils (5W30, 10W30 etc.) improve starting in cold weather, these multi-viscosity oils will result in increased oil consumption when used above 32°F. Check your engine oil level more frequently to avoid possible engine damage from running low on oil.

Change the oil after every 25 hours of operation or at least once a year if the tractor is not used for 25 hours in one year.

Check the crankcase oil level before starting the engine and after each eight (8) hours of operation. Tighten oil fill cap/ dipstick securely each time you check the oil level.

TO CHANGE ENGINE OIL (See Figs. 11 and 12)

Determine temperature range expected before oil change. All oil must meet API service classification SF-SJ.

•Be sure tractor is on level surface.

•Oil will drain more freely when warm.

•Catch oil in a suitable container.

•Remove oil fill cap/dipstick. Be careful not to allow dirt to enter the engine when changing oil.

•Remove cap from bottom fitting of drain valve and install the drain tube onto the fitting.

•Unlock drain valve by pushing inward and turning coun- terclockwise.

•To open, pull out on the drain valve.

•After oil has drained completely, close and lock the drain valve by pushing inward and turning clockwise until the pin is in the locked position as shown.

•Remove the drain tube and replace the cap onto to the bottom fitting of the drain valve.

•Refill engine with oil through oil fill dipstick tube. Pour slowly. Do not overfill. For approximate capacity see “PRODUCT SPECIFICATIONS” section of this manual.

•Use gauge on oil fill cap/dipstick for checking level. Be sure dipstick cap is tightened securely for accurate reading. Keep oil at “FULL” line on dipstick.

 

OIL DRAIN VALVE

CLOSED

 

AND

 

LOCKED

 

POSITION

 

CAP

DRAIN

 

 

TUBE

FIG. 12

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Model NO. PC14542D IV. Service Safe Operation Practices for Ride-On MowersGeneral Operation III. ChildrenTable of Contents Product Specifications Customer ResponsibilitiesUnassembled Parts Steering Wheel SeatKeys Slope SheetAssembly Tools Required for AssemblyTo Remove Tractor from Carton Before Removing Tractor from SkidCheck Battery See Fig HOW to SET UP Your TractorInstall Seat See Fig Check Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor Before Starting the Engine To Operate on HillsTo Transport Towing Carts and Other ATTACH- MentsADD Gasoline Mowing TipsTo Start Engine See Fig General Recommendations Customer ResponsibilitiesBefore Each USE Tractor Brake OperationTires Operator Presence SystemBattery EngineBelts Transaxle CoolingClean AIR Screen To Service PRE-CLEANERTo Service Cartridge Engine Cooling Fins See FigCleaning MufflerSpark Plugs IN-LINE Fuel Filter See FigTo Install Mower See Fig Service and AdjustmentsTo Remove Mower See Fig To Level Mower Housing Belt InstallationTo Replace Mower Blade Drive Belt See Fig Belt RemovalTo Adjust Brake See Fig Transaxle Gear Shift Lever Neutral Adjustment See FigTo Adjust Steering Wheel Alignment To Replace Motion Drive Belt See FigTo Start Engine with a Weak Battery See Fig Replacing Battery See FigsTo Remove Wheel for Repairs See Fig To Attach Jumper CablesTo Adjust Carburetor To Replace Headlight BulbInterlocks and Relays To Replace FuseStorage OtherFuel System Engine OILTroubleshooting Points OFF Schematic Tractor - Model Number PC14542DElectrical KEY Part NO. NO. Description Chassis and Enclosures KEY Part Description Drive 178394 Steering Assembly KEY Part NO. NO. Description Engine KEY Part Description Seat Assembly Decals Wheels & TiresMower Lift Nut Lock w/Wsh 1/2-13 Unc Mower Deck 179292 Service Notes Limited Warranty Limited Warranties ForCUT This OUT Dotted Lines Slope

PC14542D specifications

The Poulan PC14542D is a robust and reliable lawn tractor designed for homeowners who need a powerful and efficient machine for maintaining their lawns. With its 14.5 horsepower Briggs & Stratton engine, this tractor is well-equipped to handle a variety of mowing tasks, making it a versatile choice for users of all experience levels.

One of the standout features of the PC14542D is its 42-inch cutting deck, which allows users to cover a larger area in less time. The deck is constructed with strengthened steel, ensuring durability and a consistent cut quality. The mower deck is adjustable, providing users with the capability to set cutting heights from 1 to 4 inches. This versatility makes it easier to adapt to different grass types and growing conditions.

The Poulan PC14542D features a foot-controlled hydrostatic transmission, offering a seamless and effortless driving experience. This technology enables smooth speed changes, which is particularly beneficial when navigating around obstacles or changing terrain at a moment's notice. The hydrostatic system eliminates the need for manual gear shifts, making this tractor user-friendly, especially for beginners.

Additionally, the PC14542D is equipped with a comfortable, adjustable seat that provides excellent back support during extended periods of mowing. The ergonomic design of the tractor also ensures that users can easily access all controls without straining, enhancing overall comfort and convenience.

Another notable characteristic is the easy-access maintenance points, designed for quick and straightforward upkeep. The tractor has a durable and reliable build, with protective features such as a front bumper that safeguards against potential impacts.

This model also prides itself on its excellent maneuverability, thanks to its compact size and a tight turning radius. This makes it easier to navigate around flower beds, trees, and other obstacles in your yard, enhancing overall mowing efficiency.

The Poulan PC14542D combines power, comfort, and ease of use, making it an ideal choice for homeowners seeking to maintain a lush and healthy lawn. Whether tackling large areas or simply giving the yard a quick trim, this lawn tractor proves to be a dependable companion for all mowing needs. With its blend of features and technologies, the PC14542D stands out as an excellent investment for lawn care enthusiasts.
Top Page Image Contents