Poulan PC14542D To Level Mower Housing, To Replace Mower Blade Drive Belt See Fig, Belt Removal

Page 20

SERVICE AND ADJUSTMENTS

TO LEVEL MOWER HOUSING

Adjust the mower while tractor is parked on level ground or driveway. Make sure tires are properly inflated (See “PROD- UCT SPECIFICATIONS” section of this manual). If tires are over or underinflated, you will not properly adjust your mower.

SIDE-TO-SIDE ADJUSTMENT (See Figs. 17 and 18)

•Raise mower to its highest position.

•At the midpoint of both sides of mower, measure height from bottom edge of mower to ground. Distance “A” on both sides of mower should be the same or within 1/4" of each other.

•If adjustment is necessary, make adjustment on one side of mower only.

•To raise one side of mower, tighten lift link adjustment nut on that side.

•To lower one side of mower, loosen lift link adjustment nut on that side.

NOTE: Three full turns of adjustment nut will change mower height about 1/8".

•Recheck measurements after adjusting.

BOTTOM EDGE

BOTTOM EDGE

OF MOWER

OF MOWER

TO GROUND

TO GROUND

“A”

“A”

 

GROUND LINE

FIG. 17

•When distance “D” is 1/8" to 1/2" lower at front than rear, tighten nuts “F” against trunnion on both front links.

•To raise front of mower, loosen nut “F” from trunnion on both front links. Tighten nut “E” on both front links an equal number of turns.

•When distance “D” is 1/8" to 1/2" lower at front than rear, tighten nut “F” against trunnion on both front links.

•Recheck side-to-side adjustment.

MANDREL

"D"

"D"

FIG. 19

BOTH FRONT LINKS MUST BE EQUAL IN LENGTH

NUT "F"

NUT "E"

TRUNNION

FRONT LINKS

SUSPENSION ARM

LIFT LINK

ADJUSTMENT

NUT

FIG. 18

FRONT-TO-BACK ADJUSTMENT (See Figs. 19 and 20)

IMPORTANT: DECK MUST BE LEVEL SIDE-TO-SIDE. IF THE FOLLOWING FRONT-TO-BACK ADJUSTMENT IS NECESSARY, BE SURE TO ADJUST BOTH FRONT LINKS EQUALLY SO MOWER WILL STAY LEVEL SIDE-TO- SIDE.

To obtain the best cutting results, the mower housing should be adjusted so that the front is approximately 1/8" to 1/2" lower than the rear when the mower is in its highest position.

Check adjustment on right side of tractor. Measure distance “D” directly in front and behind the mandrel at bottom edge of mower housing as shown.

• Before making any necessary adjustments, check that both front links are equal in length.

• If links are not equal in length, adjust one link to same length as other link.

• To lower front of mower loosen nut “E” on both front links

FIG. 20

TO REPLACE MOWER BLADE DRIVE BELT (See Fig. 21)

The mower blade drive belt may be replaced without tools. Park the tractor on level surface. Engage parking brake.

BELT REMOVAL -

•Remove mower from tractor (See “TO REMOVE MOWER” in this section of this manual).

•Work belt off both mandrel pulleys and idler pulleys.

•Pull belt away from mower.

BELT INSTALLATION -

•Install new belt in reverse order of removal.

•Make sure belt is in all pulley grooves and inside all belt guides.

•Install mower in reverse order of removal instructions.

MANDREL

IDLER

PULLEY

PULLEYS

 

MANDREL

PULLEY

an equal number of turns.

20

FIG. 21

Page 19 Page 21
Image 20
Page 19 Page 21
Contents Model NO. PC14542D IV. Service Safe Operation Practices for Ride-On MowersGeneral Operation III. ChildrenTable of Contents Product Specifications Customer ResponsibilitiesUnassembled Parts Steering Wheel SeatKeys Slope SheetAssembly Tools Required for AssemblyTo Remove Tractor from Carton Before Removing Tractor from SkidInstall Seat See Fig HOW to SET UP Your TractorCheck Battery See Fig Check Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor Before Starting the Engine To Operate on HillsTo Transport Towing Carts and Other ATTACH- MentsTo Start Engine See Fig Mowing TipsADD Gasoline Before Each USE Customer ResponsibilitiesGeneral Recommendations Tractor Brake OperationTires Operator Presence SystemBattery EngineBelts Transaxle CoolingClean AIR Screen To Service PRE-CLEANERTo Service Cartridge Engine Cooling Fins See FigCleaning MufflerSpark Plugs IN-LINE Fuel Filter See FigTo Remove Mower See Fig Service and AdjustmentsTo Install Mower See Fig To Level Mower Housing Belt InstallationTo Replace Mower Blade Drive Belt See Fig Belt RemovalTo Adjust Brake See Fig Transaxle Gear Shift Lever Neutral Adjustment See FigTo Adjust Steering Wheel Alignment To Replace Motion Drive Belt See FigTo Start Engine with a Weak Battery See Fig Replacing Battery See FigsTo Remove Wheel for Repairs See Fig To Attach Jumper CablesTo Adjust Carburetor To Replace Headlight BulbInterlocks and Relays To Replace FuseStorage OtherFuel System Engine OILTroubleshooting Points OFF Schematic Tractor - Model Number PC14542DElectrical KEY Part NO. NO. Description Chassis and Enclosures KEY Part Description Drive 178394 Steering Assembly KEY Part NO. NO. Description Engine KEY Part Description Seat Assembly Decals Wheels & TiresMower Lift Nut Lock w/Wsh 1/2-13 Unc Mower Deck 179292 Service Notes Limited Warranty Limited Warranties ForCUT This OUT Dotted Lines Slope

PC14542D specifications

The Poulan PC14542D is a robust and reliable lawn tractor designed for homeowners who need a powerful and efficient machine for maintaining their lawns. With its 14.5 horsepower Briggs & Stratton engine, this tractor is well-equipped to handle a variety of mowing tasks, making it a versatile choice for users of all experience levels.

One of the standout features of the PC14542D is its 42-inch cutting deck, which allows users to cover a larger area in less time. The deck is constructed with strengthened steel, ensuring durability and a consistent cut quality. The mower deck is adjustable, providing users with the capability to set cutting heights from 1 to 4 inches. This versatility makes it easier to adapt to different grass types and growing conditions.

The Poulan PC14542D features a foot-controlled hydrostatic transmission, offering a seamless and effortless driving experience. This technology enables smooth speed changes, which is particularly beneficial when navigating around obstacles or changing terrain at a moment's notice. The hydrostatic system eliminates the need for manual gear shifts, making this tractor user-friendly, especially for beginners.

Additionally, the PC14542D is equipped with a comfortable, adjustable seat that provides excellent back support during extended periods of mowing. The ergonomic design of the tractor also ensures that users can easily access all controls without straining, enhancing overall comfort and convenience.

Another notable characteristic is the easy-access maintenance points, designed for quick and straightforward upkeep. The tractor has a durable and reliable build, with protective features such as a front bumper that safeguards against potential impacts.

This model also prides itself on its excellent maneuverability, thanks to its compact size and a tight turning radius. This makes it easier to navigate around flower beds, trees, and other obstacles in your yard, enhancing overall mowing efficiency.

The Poulan PC14542D combines power, comfort, and ease of use, making it an ideal choice for homeowners seeking to maintain a lush and healthy lawn. Whether tackling large areas or simply giving the yard a quick trim, this lawn tractor proves to be a dependable companion for all mowing needs. With its blend of features and technologies, the PC14542D stands out as an excellent investment for lawn care enthusiasts.
Top Page Image Contents