Poulan PC14542D To Remove Wheel for Repairs See Fig, To Start Engine with a Weak Battery See Fig

Page 22

SERVICE AND ADJUSTMENTS

TO REMOVE WHEEL FOR REPAIRS (See Fig. 25)

•Block up axle securely.

•Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not lose).

•Repair tire and reassemble.

•On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.

•Replace washers and snap retaining ring securely in axle groove.

•Replace axle cover.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

WASHERS

RETAINING

RING

AXLE COVER

SQUARE KEY (REAR

 

WHEEL ONLY)

 

FIG. 25

TO START ENGINE WITH A WEAK BATTERY (See Fig. 26)

CAUTION: Lead-acid batteries generate explosive gases. Keep sparks, flame and smoking materials away from bat- teries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the Customer Responsibili- ties section of this manual).

If “jumper cables” are used for emergency starting, follow this procedure:

IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT NEGATIVE GROUNDED SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT NEGATIVE GROUNDED SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.

TO ATTACH JUMPER CABLES -

•Connect each end of the RED cable to the POSITIVE (+) terminal of each battery, taking care not to short against chassis.

•Connect one end of the BLACK cable to the NEGATIVE (-) terminal of fully charged battery.

•Connect the other end of the BLACK cable to good CHASSIS GROUND, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

•BLACK cable first from chassis and then from the fully charged battery.

• RED cable last from both batteries.

22

POSITIVE TERMINAL

 

NEGATIVE TERMINAL

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

CHASSIS

 

 

CABLES

POSITIVE

NEGATIVE

TERMINAL

TERMINAL

CHARGED

 

BATTERY

FIG. 26

REPLACING BATTERY (See Figs. 27 and 28)

CAUTION: Do not short battery termi- nals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands, rings, etc.

Positive terminal must be connected first to prevent sparking from acciden- tal grounding.

•Lift seat pan to raised position and open battery box door.

•Disconnect BLACK battery cable first then RED battery cable and carefully remove battery from tractor.

•Install new battery with terminals in same position as old battery.

•First connect RED battery cable to positive (+) terminal with hex bolt and keps nut as shown. Tighten securely.

•Connect BLACK grounding cable to negative (-) terminal with remaining hex bolt and keps nut. Tighten securely.

•Close battery box door.

SEAT PAN

BATTERY

BOX DOOR

FIG. 27

Page 21 Page 23
Image 22
Page 21 Page 23
Contents Model NO. PC14542D General Operation IV. ServiceSafe Operation Practices for Ride-On Mowers III. ChildrenTable of Contents Product Specifications Customer ResponsibilitiesKeys Unassembled PartsSteering Wheel Seat Slope SheetTo Remove Tractor from Carton AssemblyTools Required for Assembly Before Removing Tractor from SkidCheck Battery See Fig HOW to SET UP Your TractorInstall Seat See Fig Check for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To Transport Before Starting the EngineTo Operate on Hills Towing Carts and Other ATTACH- MentsADD Gasoline Mowing TipsTo Start Engine See Fig General Recommendations Customer ResponsibilitiesBefore Each USE Tires TractorBrake Operation Operator Presence SystemBelts BatteryEngine Transaxle CoolingTo Service Cartridge Clean AIR ScreenTo Service PRE-CLEANER Engine Cooling Fins See FigSpark Plugs CleaningMuffler IN-LINE Fuel Filter See FigTo Install Mower See Fig Service and AdjustmentsTo Remove Mower See Fig To Replace Mower Blade Drive Belt See Fig To Level Mower HousingBelt Installation Belt RemovalTo Adjust Steering Wheel Alignment To Adjust Brake See FigTransaxle Gear Shift Lever Neutral Adjustment See Fig To Replace Motion Drive Belt See FigTo Remove Wheel for Repairs See Fig To Start Engine with a Weak Battery See FigReplacing Battery See Figs To Attach Jumper CablesInterlocks and Relays To Adjust CarburetorTo Replace Headlight Bulb To Replace FuseFuel System StorageOther Engine OILTroubleshooting Points OFF Schematic Tractor - Model Number PC14542DElectrical KEY Part NO. NO. Description Chassis and Enclosures KEY Part Description Drive 178394 Steering Assembly KEY Part NO. NO. Description Engine KEY Part Description Seat Assembly Decals Wheels & TiresMower Lift Nut Lock w/Wsh 1/2-13 Unc Mower Deck 179292 Service Notes Limited Warranty Limited Warranties ForCUT This OUT Dotted Lines Slope

PC14542D specifications

The Poulan PC14542D is a robust and reliable lawn tractor designed for homeowners who need a powerful and efficient machine for maintaining their lawns. With its 14.5 horsepower Briggs & Stratton engine, this tractor is well-equipped to handle a variety of mowing tasks, making it a versatile choice for users of all experience levels.

One of the standout features of the PC14542D is its 42-inch cutting deck, which allows users to cover a larger area in less time. The deck is constructed with strengthened steel, ensuring durability and a consistent cut quality. The mower deck is adjustable, providing users with the capability to set cutting heights from 1 to 4 inches. This versatility makes it easier to adapt to different grass types and growing conditions.

The Poulan PC14542D features a foot-controlled hydrostatic transmission, offering a seamless and effortless driving experience. This technology enables smooth speed changes, which is particularly beneficial when navigating around obstacles or changing terrain at a moment's notice. The hydrostatic system eliminates the need for manual gear shifts, making this tractor user-friendly, especially for beginners.

Additionally, the PC14542D is equipped with a comfortable, adjustable seat that provides excellent back support during extended periods of mowing. The ergonomic design of the tractor also ensures that users can easily access all controls without straining, enhancing overall comfort and convenience.

Another notable characteristic is the easy-access maintenance points, designed for quick and straightforward upkeep. The tractor has a durable and reliable build, with protective features such as a front bumper that safeguards against potential impacts.

This model also prides itself on its excellent maneuverability, thanks to its compact size and a tight turning radius. This makes it easier to navigate around flower beds, trees, and other obstacles in your yard, enhancing overall mowing efficiency.

The Poulan PC14542D combines power, comfort, and ease of use, making it an ideal choice for homeowners seeking to maintain a lush and healthy lawn. Whether tackling large areas or simply giving the yard a quick trim, this lawn tractor proves to be a dependable companion for all mowing needs. With its blend of features and technologies, the PC14542D stands out as an excellent investment for lawn care enthusiasts.
Top Page Image Contents