Poulan PB22H46YT manual To Adjust Mower Cutting Height See Fig, To Adjust Gauge Wheels See Fig

Page 10

OPERATION

J

K

L

FIG. 7

SYSTEM CHARACTERISTICS

The cruise control should only be used while mowing or transporting on relatively smooth, straight surfaces. Other conditions such as trimming at slow speeds may cause the cruise control to disengage. Do not use the cruise control on slopes, rough terrian or while trimmimg or turning.

•With forward drive pedal depressed to desired speed, pull cruise control lever (J) up and hold while lifting your foot off the pedal, then release the lever.

To disengage the cruise control, depress the brake pedal or tap on forward drive pedal.

TO ADJUST MOWER CUTTING HEIGHT (See Fig. 8)

The position of the attachment lift lever (A) determines the cutting height.

A

T

FIG. 8

•Put attachment lift lever in desired cutting height slot.

•Slide pointer tab (T) to desired cutting height as a reminder for next time you mow.

The cutting height range is approximately 1" to 4". The heights are measured from the ground to the blade tip with the engine not running. These heights are approximate and may vary depending upon soil conditions, height of grass and types of grass being mowed.

•The average lawn should be cut to approximately 2-1/2 inches during the cool season and to over 3 inches during hot months. For healthier and better looking lawns, mow often and after moderate growth.

•For best cutting performance, grass over 6 inches in height should be mowed twice. Make the first cut relatively high; the second to desired height.

TO ADJUST GAUGE WHEELS (See Fig. 9)

Gauge wheels are properly adjusted when they are slightly off the ground when mower is at the desired cutting height in operating position. Gauge wheels then keep the deck in proper position to help prevent scalping in most terrain conditions.

NOTE: Adjust gauge wheels with tractor on a flat level surface.

•Adjust mower to desired cutting height (See “TO AD- JUST MOWER CUTTING HEIGHT” in this section of manual).

•With mower in desired height of cut position, gauge wheels should be assembled so they are slightly off the ground. Install gauge wheel in appropriate hole. Tighten securely.

•Repeat for all, installing gauge wheel in same adjust- ment hole.

FIG.9

TO OPERATE MOWER

Your tractor is equipped with an operator presence sensing switch. Any attempt by the operator to leave the seat with the engine running and the attachment clutch engaged will shut off the engine. You must remain fully and centrally positioned in the seat to prevent the engine from hesitating or cutting off when operating your equipment on rough, rolling terrain or hills.

•Select desired height of cut with attachment lift lever.

•Start mower blades by engaging attachment clutch control.

TO STOP MOWER BLADES - disengage attachment clutch control.

CAUTION: Do not operate the mower without either the entire grass catcher, on mowers so equipped, or the deflector shield (S) in place.

S

FIG. 10

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents PB22H46YT ModelGeneral Operation Safety RulesSafe Operation Practices for Ride-On Mowers II. Slope OperationIII. Children ServiceIV. Towing Table of Contents To Remove Tractor from Carton AssemblyUnassembled Parts Unpack CartonCheck for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake SystemOperation Ignition Switch Used for starting and stopping the engine Know Your TractorHOW to USE Your Tractor System Characteristics To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig To Operate MowerReverse Operation System ROS Service REMINDER/HOUR MeterBefore Starting the Engine To Operate on HillsPurge Transmission ADD GasolineTo Start Engine See Fig Automatic Transmission Warm UPMowing Tips General Recommendations MaintenanceMaintenance ScheduleBrake Operation BatteryTractor TiresEngine Muffler CleaningEngine OIL Filter Spark PlugsTo Install Mower See Fig Service and AdjustmentsTo Remove Mower See Fig Install belt on engine pulley M, in belt keepers G To Level Mower To Replace Mower Drive Belt To Check and Adjust Brake See FigTo Adjust Brake To Check BrakeFront Wheel TOE-IN/CAMBER To Start Engine with a Weak Battery See FigTo Replace Motion Drive Belt See Fig To Remove Wheel for Repairs See FigTo Adjust Carburetor To Adjust Throttle Control CableTo Adjust Choke Control To Replace Headlight BulbFuel System StorageOther Engine OILTroubleshooting Points Problem Cause CorrectionEngine dies when Limited Warranty L5V 3E4Service Notes Only Ride UP and Down Hill Not Across Hill Degrees MAX Fold Along This Dotted Line Degree SlopeParts and Service Changere DE Pièces LES ET L’ENTRETIEN Degrés Suivant LES UNE Pliez EST CeciRemarque Garantie cette de exclus sont normal l’entretien et AutoriséInitiale d’achat date la de compter à jours 90 dix Dépannage DE Guide Connexions les et interrupteurs les câblage, le VérifiezLame de mandrin le Remplacez Tordu est lame de mandrin Un Entreposage Carburateur LE Régler Pour GAZ DES CommandeReglages ET Revision Fig la Voir Batterie LA ReplacerFig la Voir D’ENTRAÎNEMENT Courroie LA Remplacer Pour Fig la Voir Tionsraparé LES Pour Roues LES Enlever PourAvant Roue LA DE PINCEMENT/CARROSSAGE 29 .FIGFrein LE Régler ET Contrôler Pour Réglages ET RévisionFig la Voir ’EN Courroie LA Remplacer Pour24 .FIG Tondeuse LA Niveau LE Ajuster Pour25 .FIG 23 .FIG18 .FIG 21 .FIG 19 .FIG20 .FIG Place en bien est courroie la que vous-Assurez ImportantFig Voir Courroie LA ET Tondeuse LA InstallerFigs Voir D’ENTRAÎNEMENT Tondeuse LA Enlever Pour’ALLUMAGE Bougie Ligne EN Installe Dessence FiltreEntretien Moteur DE D’HUILE FiltreMoteur Fig la Voir Lame LA Enlever EN Fonctionnement DE Système ETLubrification DE Tableau Utilisation Chaque AvantTransmission LA Purger Avant ET Réinstallation LA Après Purgée ÊtreUtilisation 12 .FIGMoteur DU D’HUILE Niveau LE Vérifier R R a M É D’ESSENCE Réservoir LE Remplir Quetimaauto11 et 3 .Fig les Voir Accessoires Autres ET Charrettes DES Remorquer Pour’ENTRETIEN/HOROMÈTRE Indicateur Pentes LES Dans Utiliser PourTondeuse LA Utiliser Pour VitessDE Régulateur LE Utiliser Comment Jauge DE Roues LES Régler PourFig la Voir Mentnetionsta DE Frein LE Engager Pour GAZ DES Commande LA Utiliser PourLétrangleur Utiliser Pour Fig la Voir Arrêter Pour 4 .FIGFroid moteur un démarrer de permet Détrangleur Commande N Moteur de vitesse la commander de permet GAZ DES Commande D’EMBRAYAGE Tionsec la Voir Conduisant LE EN Telet MontageDesmancom des tionfonc la et PA LA DE Tracteur LE Retirer PourMontées NON Piéces Toncar DU Tracteur LE Sortir PourSommaire En l’utilisation pour Conseils Général EntretienTracteurs des sécurité toute ’ESSENCE DE Sûre ManipulationLES Dans Fonctionnement PentesTracteurs des sécurité toute en l’utilisation pour Conseils Pelouse DE Tracteur PB22H46YT Modèle Lopérateur DE Manuel
Related manuals
Manual 18 pages 370 b Manual 28 pages 58.08 Kb

PB22H46YT specifications

The Poulan PB22H46YT is a robust riding lawn mower designed for homeowners seeking reliability and efficiency in their lawn care routine. This model stands out with its powerful engine and user-friendly features, making it an excellent choice for maintaining medium to large-sized lawns.

One of the key features of the PB22H46YT is its 22 HP Briggs & Stratton engine. This engine offers ample power to tackle thick grass and uneven terrain with ease. The reliable performance ensures that the mower can handle various mowing tasks without hesitation, allowing you to complete your lawn care efficiently.

The Poulan PB22H46YT also comes equipped with a 46-inch cutting deck. This wide cutting deck allows for a larger cutting path, which means fewer passes over your lawn and a quicker mowing process. The cutting deck is made from durable materials to withstand the rigors of regular use, and it features adjustable height settings, allowing users to customize the grass length to their preference.

Another notable technology incorporated into the PB22H46YT is its hydrostatic transmission system. This allows for smooth and seamless acceleration without the need for manual shifting. Users can easily control the speed and direction, making maneuvering around flower beds, trees, and other obstacles much simpler.

The mower provides a comfortable seating experience with an adjustable high-back seat, reducing fatigue during longer mowing sessions. The ergonomic steering wheel and easy-access controls further enhance the user experience, making it straightforward to operate even for less experienced users.

Additionally, the Poulan PB22H46YT features a convenient integrated grass collection system. The grass clippings can either be discharged to the side, mulched, or collected, depending on user preference. This versatility allows homeowners to choose the most suitable method for managing grass clippings.

Lastly, the durable construction of the PB22H46YT ensures longevity and reliability. With a solid build and quality components, this mower promises to deliver consistent performance season after season. Overall, the Poulan PB22H46YT combines power, efficiency, and user-friendly features to make lawn maintenance a more enjoyable task.
Top Page Image Contents