Poulan PB22H46YT manual ADD Gasoline, To Start Engine See Fig, Purge Transmission, Running

Page 12

OPERATION

ADD GASOLINE

•Fill fuel tank to bottom of filler neck. Do not overfill. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness.

CAUTION: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

IMPORTANT: WHEN OPERATING IN TEMPERATURES BELOW32°F(0°C), USE FRESH, CLEAN WINTER GRADE GASOLINE TO HELP INSURE GOOD COLD WEATHER STARTING.

CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

TO START ENGINE (See Fig. 3)

When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.

•Be sure freewheel control is in the transmission engaged position.

•Sit on seat in operating position, depress clutch/brake pedal and set parking brake.

•Place motion control lever in neutral (N) position.

•Move attachment clutch to “DISENGAGED” position.

•Move throttle control to fast position

•Pull choke control out for a cold engine start attempt. For a warm engine start attempt the choke control may not be needed.

NOTE: Before starting, read the warm and cold starting procedures below.

•Insert key into ignition and turn key clockwise to “START” position and release key as soon as engine starts. Do not run starter continuously for more than fifteen seconds per minute. If the engine does not start after several attempts, push choke control in, wait a few minutes and try again. If engine still does not start, pull the choke control out and retry.

WARM WEATHER STARTING (50° F and above)

•When engine starts, slowly push choke control in until the engine begins to run smoothly. If the engine starts to run roughly, pull the choke control out slightly for a few seconds and then continue to push the control in

slowly.

•The attachments and ground drive can now be used. If the engine does not accept the load, restart the engine and allow it to warm up for one minute using the choke as described above.

COLD WEATHER STARTING (50° F and below)

•When engine starts, slowly push choke control in until the engine begins to run smoothly. Continue to push the choke control in small steps allowing the engine to accept small changes in speed and load, until the choke control is fully in. If the engine starts to run roughly, pull the choke control out slightly for a few seconds and then continue to push the control in slowly. This may require an engine warm-up period from several seconds to several minutes, depending on the temperature.

AUTOMATIC TRANSMISSION WARM UP

•Before driving the unit in cold weather, the transmission should be warmed up as follows:

•Be sure the tractor is on level ground.

•Place the motion control lever in neutral. Release the parking brake and let the clutch/brake slowly return to operating position.

•Allow one minute for transmission to warm up. This can be done during the engine warm up period.

•The attachments can be used during the engine warm-up period after the transmission has been warmed up and may require the choke control be pulled out slightly.

NOTE: If at a high altitude (above 3000 feet) or in cold temperatures (below 32 F) the carburetor fuel mixture may need to be adjusted for best engine performance. See “TO ADJUST CARBURETOR” in the Service and Adjustments section of this manual.

PURGE TRANSMISSION

CAUTION: Never engage or disengage freewheel lever while the engine is

running.

To ensure proper operation and performance, it is recom- mended that the transmission be purged before operating tractor for the first time. This procedure will remove any trapped air inside the transmission which may have de- veloped during shipping of your tractor.

IMPORTANT: SHOULD YOUR TRANSMISSION REQUIRE REMOVAL FOR SERVICE OR REPLACEMENT, IT SHOULD BE PURGED AFTER REINSTALLATION BEFORE OPERATING THE TRACTOR.

1.Place tractor safely on a level surface - that is clear and open - with engine off and parking brake set.

2.Disengage transmission by placing freewheel control in disengaged position (See “TO TRANSPORT” in this section of manual).

3.Sitting in the tractor seat, start engine. After the en- gine is running, move throttle control to slow position. Disengage parking brake

12

Page 11 Page 13
Image 12
Page 11 Page 13
Contents PB22H46YT ModelSafety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationService III. ChildrenIV. Towing Table of Contents Assembly Unassembled PartsTo Remove Tractor from Carton Unpack CartonCheck Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Ignition Switch Used for starting and stopping the engine Know Your TractorHOW to USE Your Tractor To Adjust Mower Cutting Height See Fig To Adjust Gauge Wheels See FigSystem Characteristics To Operate MowerService REMINDER/HOUR Meter Before Starting the EngineReverse Operation System ROS To Operate on HillsADD Gasoline To Start Engine See FigPurge Transmission Automatic Transmission Warm UPMowing Tips Maintenance MaintenanceGeneral Recommendations ScheduleBattery TractorBrake Operation TiresEngine Cleaning Engine OIL FilterMuffler Spark PlugsService and Adjustments To Install Mower See FigTo Remove Mower See Fig Install belt on engine pulley M, in belt keepers G To Level Mower To Check and Adjust Brake See Fig To Adjust BrakeTo Replace Mower Drive Belt To Check BrakeTo Start Engine with a Weak Battery See Fig To Replace Motion Drive Belt See FigFront Wheel TOE-IN/CAMBER To Remove Wheel for Repairs See FigTo Adjust Throttle Control Cable To Adjust Choke ControlTo Adjust Carburetor To Replace Headlight BulbStorage OtherFuel System Engine OILTroubleshooting Points Problem Cause CorrectionEngine dies when Limited Warranty L5V 3E4Service Notes Only Ride UP and Down Hill Not Across Hill Degrees MAX Fold Along This Dotted Line Degree SlopeParts and Service Changere DE Pièces LES ET L’ENTRETIEN Degrés Suivant LES UNE Pliez EST CeciRemarque Autorisé Garantie cette de exclus sont normal l’entretien etInitiale d’achat date la de compter à jours 90 dix Dépannage DE Guide Connexions les et interrupteurs les câblage, le VérifiezLame de mandrin le Remplacez Tordu est lame de mandrin Un Entreposage GAZ DES Commande Reglages ET RevisionCarburateur LE Régler Pour Fig la Voir Batterie LA ReplacerFig la Voir Tionsraparé LES Pour Roues LES Enlever Pour Avant Roue LA DE PINCEMENT/CARROSSAGEFig la Voir D’ENTRAÎNEMENT Courroie LA Remplacer Pour 29 .FIGRéglages ET Révision Fig la VoirFrein LE Régler ET Contrôler Pour ’EN Courroie LA Remplacer PourTondeuse LA Niveau LE Ajuster Pour 25 .FIG24 .FIG 23 .FIG21 .FIG 19 .FIG 20 .FIG18 .FIG Place en bien est courroie la que vous-Assurez ImportantCourroie LA ET Tondeuse LA Installer Figs Voir D’ENTRAÎNEMENTFig Voir Tondeuse LA Enlever PourLigne EN Installe Dessence Filtre Entretien’ALLUMAGE Bougie Moteur DE D’HUILE FiltreMoteur Fig la Voir Lame LA Enlever EN Fonctionnement DE Système ETLubrification DE Tableau Utilisation Chaque AvantAvant ET Réinstallation LA Après Purgée Être UtilisationTransmission LA Purger 12 .FIGR R a M É D ’ESSENCE Réservoir LE RemplirMoteur DU D’HUILE Niveau LE Vérifier QuetimaautoAccessoires Autres ET Charrettes DES Remorquer Pour ’ENTRETIEN/HOROMÈTRE Indicateur11 et 3 .Fig les Voir Pentes LES Dans Utiliser PourVitess DE Régulateur LE Utiliser CommentTondeuse LA Utiliser Pour Jauge DE Roues LES Régler PourGAZ DES Commande LA Utiliser Pour Létrangleur Utiliser PourFig la Voir Mentnetionsta DE Frein LE Engager Pour Fig la Voir Arrêter Pour 4 .FIGFroid moteur un démarrer de permet Détrangleur Commande N Moteur de vitesse la commander de permet GAZ DES Commande D’EMBRAYAGE Montage Desmancom des tionfonc la etTionsec la Voir Conduisant LE EN Telet PA LA DE Tracteur LE Retirer PourMontées NON Piéces Toncar DU Tracteur LE Sortir PourSommaire Général Entretien Tracteurs des sécurité touteEn l’utilisation pour Conseils ’ESSENCE DE Sûre ManipulationPentes LES Dans FonctionnementTracteurs des sécurité toute en l’utilisation pour Conseils Pelouse DE Tracteur PB22H46YT Modèle Lopérateur DE Manuel
Related manuals
Manual 18 pages 370 b Manual 28 pages 58.08 Kb

PB22H46YT specifications

The Poulan PB22H46YT is a robust riding lawn mower designed for homeowners seeking reliability and efficiency in their lawn care routine. This model stands out with its powerful engine and user-friendly features, making it an excellent choice for maintaining medium to large-sized lawns.

One of the key features of the PB22H46YT is its 22 HP Briggs & Stratton engine. This engine offers ample power to tackle thick grass and uneven terrain with ease. The reliable performance ensures that the mower can handle various mowing tasks without hesitation, allowing you to complete your lawn care efficiently.

The Poulan PB22H46YT also comes equipped with a 46-inch cutting deck. This wide cutting deck allows for a larger cutting path, which means fewer passes over your lawn and a quicker mowing process. The cutting deck is made from durable materials to withstand the rigors of regular use, and it features adjustable height settings, allowing users to customize the grass length to their preference.

Another notable technology incorporated into the PB22H46YT is its hydrostatic transmission system. This allows for smooth and seamless acceleration without the need for manual shifting. Users can easily control the speed and direction, making maneuvering around flower beds, trees, and other obstacles much simpler.

The mower provides a comfortable seating experience with an adjustable high-back seat, reducing fatigue during longer mowing sessions. The ergonomic steering wheel and easy-access controls further enhance the user experience, making it straightforward to operate even for less experienced users.

Additionally, the Poulan PB22H46YT features a convenient integrated grass collection system. The grass clippings can either be discharged to the side, mulched, or collected, depending on user preference. This versatility allows homeowners to choose the most suitable method for managing grass clippings.

Lastly, the durable construction of the PB22H46YT ensures longevity and reliability. With a solid build and quality components, this mower promises to deliver consistent performance season after season. Overall, the Poulan PB22H46YT combines power, efficiency, and user-friendly features to make lawn maintenance a more enjoyable task.
Top Page Image Contents