Poulan PB22H46YT manual Tractor, Brake Operation, Tires, Blade Care, Battery

Page 15

MAINTENANCE

TRACTOR

Always observe safety rules when performing any main- tenance.

BRAKE OPERATION

If tractor requires more than five (5) feet to stop at highest speed in highest gear on a level, dry concrete or paved surface, then brake must be serviced. (See “TO CHECK BRAKE” in the Service and Adjustments section of this manual).

TIRES

Maintain proper air pressure in all tires (See PSI on tires).

Keep tires free of gasoline, oil, or insect control chemi- cals which can harm rubber.

Avoid stumps, stones, deep ruts, sharp objects and other hazards that may cause tire damage.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

OPERATOR PRESENCE SYSTEM AND REVERSE OP- ERATION SYSTEM (ROS)

Be sure operator presence and reverse operation systems are working properly. If your tractor does not function as described, repair the problem immediately.

The engine should not start unless the brake pedal is fully depressed, and the attachment clutch control is in the disengaged position.

CHECK OPERATOR PRESENCE SYSTEM

When the engine is running, any attempt by the operator to leave the seat without first setting the parking brake should shut off the engine.

When the engine is running and the attachment clutch is engaged, any attempt by the operator to leave the seat should shut off the engine.

The attachment clutch should never operate unless the operator is in the seat.

ROS "ON" Position

Engine "ON" Position

(Normal Operating)

 

02828

CHECK REVERSE OPERATION (ROS) SYSTEM

When the engine is running with the ignition switch in the engine "ON" position and the attachment clutch engaged, any attempt by the operator to shift into reverse should shut off the engine.

When the engine is running with the ignition switch in the ROS "ON" position and the attachment clutch en- gaged, any attempt by the operator to shift into reverse should NOT shut off the engine.

BLADE CARE

For best results mower blades must be sharp. Replace worn, bent or damaged blades.

CAUTION: Useonlyareplacementblade approved by the manufacturer of your tractor. Using a blade not approved by the manufacturer of your tractor is hazardous, could damage your tractor and void your warranty.

BLADE REMOVAL (See Fig. 13)

Raise mower to highest position to allow access to blades.

NOTE: Protect your hands with gloves and/or wrap blade with heavy cloth.

Remove blade bolt by turning counterclockwise.

Install new blade with stamped "GRASS SIDE" facing the ground.

IMPORTANT: To ensure proper assembly, center hole in blade must align with star on mandrel assembly.

Install and tighten blade bolt securely (45-55 Ft. Lbs. torque).

IMPORTANT: Special blade bolt is heat treated.

BLADE

 

 

MANDREL

 

 

 

ASSEMBLY

 

CENTER

 

 

 

HOLE

 

 

BLADE BOLT

 

 

 

(SPECIAL)

0

2

544

 

 

 

 

 

 

 

 

 

STAR

FIG. 13

BATTERY

Your tractor has a battery charging system which is sufficient for normal use. However, periodic charging of the battery with an automotive charger will extend its life.

Keep battery and terminals clean.

Keep battery bolts tight.

Keep small vent holes open.

Recharge at 6-10 amperes for 1 hour.

NOTE: The original equipment battery on your tractor is maintenance free. Do not attempt to open or remove caps or covers. Adding or checking level of electrolyte is not necessary.

TO CLEAN BATTERY AND TERMINALS

Corrosion and dirt on the battery and terminals can cause the battery to “leak” power.

Remove terminal guard.

Disconnect BLACK battery cable first then RED bat- tery cable and remove battery from tractor.

15

Image 15
Contents Model PB22H46YTII. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationService III. ChildrenIV. Towing Table of Contents Unpack Carton AssemblyUnassembled Parts To Remove Tractor from CartonCheck Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor Ignition Switch Used for starting and stopping the engineHOW to USE Your Tractor To Operate Mower To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig System CharacteristicsTo Operate on Hills Service REMINDER/HOUR MeterBefore Starting the Engine Reverse Operation System ROSAutomatic Transmission Warm UP ADD GasolineTo Start Engine See Fig Purge TransmissionMowing Tips Schedule MaintenanceMaintenance General RecommendationsTires BatteryTractor Brake OperationEngine Spark Plugs CleaningEngine OIL Filter MufflerService and Adjustments To Install Mower See FigTo Remove Mower See Fig Install belt on engine pulley M, in belt keepers G To Level Mower To Check Brake To Check and Adjust Brake See FigTo Adjust Brake To Replace Mower Drive BeltTo Remove Wheel for Repairs See Fig To Start Engine with a Weak Battery See FigTo Replace Motion Drive Belt See Fig Front Wheel TOE-IN/CAMBERTo Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorEngine OIL StorageOther Fuel SystemProblem Cause Correction Troubleshooting PointsEngine dies when L5V 3E4 Limited WarrantyService Notes Fold Along This Dotted Line Degree Slope Only Ride UP and Down Hill Not Across Hill Degrees MAXParts and Service Changere DE Pièces LES ET L’ENTRETIEN UNE Pliez EST Ceci Degrés Suivant LESRemarque Autorisé Garantie cette de exclus sont normal l’entretien etInitiale d’achat date la de compter à jours 90 dix Connexions les et interrupteurs les câblage, le Vérifiez Dépannage DE GuideLame de mandrin le Remplacez Tordu est lame de mandrin Un Entreposage Fig la Voir Batterie LA Replacer GAZ DES CommandeReglages ET Revision Carburateur LE Régler Pour29 .FIG Fig la Voir Tionsraparé LES Pour Roues LES Enlever PourAvant Roue LA DE PINCEMENT/CARROSSAGE Fig la Voir D’ENTRAÎNEMENT Courroie LA Remplacer Pour’EN Courroie LA Remplacer Pour Réglages ET RévisionFig la Voir Frein LE Régler ET Contrôler Pour23 .FIG Tondeuse LA Niveau LE Ajuster Pour25 .FIG 24 .FIGPlace en bien est courroie la que vous-Assurez Important 21 .FIG 19 .FIG20 .FIG 18 .FIGTondeuse LA Enlever Pour Courroie LA ET Tondeuse LA InstallerFigs Voir D’ENTRAÎNEMENT Fig VoirMoteur DE D’HUILE Filtre Ligne EN Installe Dessence FiltreEntretien ’ALLUMAGE BougieMoteur EN Fonctionnement DE Système ET Fig la Voir Lame LA EnleverUtilisation Chaque Avant Lubrification DE Tableau12 .FIG Avant ET Réinstallation LA Après Purgée ÊtreUtilisation Transmission LA PurgerQuetimaauto R R a M É D’ESSENCE Réservoir LE Remplir Moteur DU D’HUILE Niveau LE VérifierPentes LES Dans Utiliser Pour Accessoires Autres ET Charrettes DES Remorquer Pour’ENTRETIEN/HOROMÈTRE Indicateur 11 et 3 .Fig les VoirJauge DE Roues LES Régler Pour VitessDE Régulateur LE Utiliser Comment Tondeuse LA Utiliser PourFig la Voir Arrêter Pour 4 .FIG GAZ DES Commande LA Utiliser PourLétrangleur Utiliser Pour Fig la Voir Mentnetionsta DE Frein LE Engager PourMoteur de vitesse la commander de permet GAZ DES Commande D Froid moteur un démarrer de permet Détrangleur Commande N’EMBRAYAGE PA LA DE Tracteur LE Retirer Pour MontageDesmancom des tionfonc la et Tionsec la Voir Conduisant LE EN TeletToncar DU Tracteur LE Sortir Pour Montées NON PiécesSommaire ’ESSENCE DE Sûre Manipulation Général EntretienTracteurs des sécurité toute En l’utilisation pour ConseilsPentes LES Dans FonctionnementTracteurs des sécurité toute en l’utilisation pour Conseils Pelouse DE Tracteur PB22H46YT Modèle Lopérateur DE Manuel
Related manuals
Manual 18 pages 370 b Manual 28 pages 58.08 Kb

PB22H46YT specifications

The Poulan PB22H46YT is a robust riding lawn mower designed for homeowners seeking reliability and efficiency in their lawn care routine. This model stands out with its powerful engine and user-friendly features, making it an excellent choice for maintaining medium to large-sized lawns.

One of the key features of the PB22H46YT is its 22 HP Briggs & Stratton engine. This engine offers ample power to tackle thick grass and uneven terrain with ease. The reliable performance ensures that the mower can handle various mowing tasks without hesitation, allowing you to complete your lawn care efficiently.

The Poulan PB22H46YT also comes equipped with a 46-inch cutting deck. This wide cutting deck allows for a larger cutting path, which means fewer passes over your lawn and a quicker mowing process. The cutting deck is made from durable materials to withstand the rigors of regular use, and it features adjustable height settings, allowing users to customize the grass length to their preference.

Another notable technology incorporated into the PB22H46YT is its hydrostatic transmission system. This allows for smooth and seamless acceleration without the need for manual shifting. Users can easily control the speed and direction, making maneuvering around flower beds, trees, and other obstacles much simpler.

The mower provides a comfortable seating experience with an adjustable high-back seat, reducing fatigue during longer mowing sessions. The ergonomic steering wheel and easy-access controls further enhance the user experience, making it straightforward to operate even for less experienced users.

Additionally, the Poulan PB22H46YT features a convenient integrated grass collection system. The grass clippings can either be discharged to the side, mulched, or collected, depending on user preference. This versatility allows homeowners to choose the most suitable method for managing grass clippings.

Lastly, the durable construction of the PB22H46YT ensures longevity and reliability. With a solid build and quality components, this mower promises to deliver consistent performance season after season. Overall, the Poulan PB22H46YT combines power, efficiency, and user-friendly features to make lawn maintenance a more enjoyable task.