Poulan PO175H42STA manual HOW to SET UP Your Tractor, Install Seat See Fig, Check Battery See Fig

Page 7

ASSEMBLY

HOW TO SET UP YOUR TRACTOR

INSTALL SEAT (See Fig. 2)

Adjust seat before tightening adjustment bolt.

Remove adjustment bolt, lock washer and flat washer securing seat to cardboard packing and set aside for assembly of seat to tractor.

Pivot seat upward and remove from the cardboard pack- ing. Remove the cardboard packing and discard.

Place seat on seat pan so head of shoulder bolt is positioned over large slotted hole in pan.

Push down on seat to engage shoulder bolt in slot and pull seat towards rear of tractor.

Pivot seat and pan forward and assemble adjust- ment bolt, lockwasher and flat washer loosely. Do not tighten

Lower seat into operating position and sit on seat.

Slide seat until a comfortable position is reached which allows you to press clutch/brake pedal all the way down.

Get off seat without moving its adjusted position.

Raise seat and tighten adjustment bolt securely.

SEAT

SEAT PAN

SHOULDER

BOLT

02466

FLAT WASHER

LOCK WASHER

02465

ADJUSTMENT

BOLT

FIG. 2

CHECK BATTERY (See Fig. 3)

Lift seat pan to raised position.

If this battery is put into service after month and year indicated on label (label located between terminals) charge battery for minimum of one hour at 6-10 amps. (See "BATTERY" in MAINTENANCE section of this manual for charging instructions).

SEAT PAN

LABEL

FIG. 3

NOTE: You may now roll or drive your tractor off the skid. Follow the appropriate instruction below to remove the tractor from the skid.

TO ROLL TRACTOR OFF SKID (See Op- eration section for location and function of controls)

Press lift lever plunger and raise attachment lift lever to its highest position.

Release parking brake by depressing clutch/brake pedal.

Place freewheel control in "transmission disengaged position" (See “TO TRANSPORT” in the Operation section of this manual).

Roll tractor forward off skid.

Remove banding holding the deflector shield up against tractor.

TO DRIVE TRACTOR OFF SKID (See Op- eration section for location and function of controls)

WARNING: Before starting, read, understand and follow all instructions in the Operation section of this manual. Be sure tractor is in a well-ventilated area. Be sure the area in front of tractor is clear of other people and objects.

Be sure all the above assembly steps have been com- pleted.

Check engine oil level and fill fuel tank with gasoline.

Place freewheel control in "transmission engaged" position (see "TO TRANSPORT" in Operation section of this manual).

Sit on seat in operating position, depress clutch/brake pedal and set the parking brake.

Place motion control lever in neutral (N) position.

Press lift lever plunger and raise attachment lift lever to its highest position.

Start the engine.After engine has started, move throttle control to idle position.

Release parking brake.

Slowly move the motion control lever forward and slowly drive tractor off skid.

Apply brake to stop tractor, set parking brake and place motion control lever in neutral position.

Turn ignition key to "STOP" position.

Continue with the instructions that follow.

7

Image 7
Contents Model NO. PO175H42STA Safety Rules Safety Rules Table of Contents Slope Sheet Unassembled PartsSteering Wheel Seat KeyBefore Removing Tractor from Skid AssemblyTools Required for Assembly To Remove Tractor from CartonInstall Seat See Fig HOW to SET UP Your TractorCheck Battery See Fig Check Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor HOW to USE Your Tractor To Operate on Hills Before Starting the EngineTo Operate Mower See Fig To Transport See FigsAutomatic Transmission Warm UP ADD GasolineTo Start Engine See Fig Purge TransmissionMowing Tips Before Each USE MaintenanceLubrication Chart General RecommendationsTractor Engine Spark Plugs CleaningAIR Filter MufflerTo Remove Mower See Fig Service and AdjustmentsTo Install Mower See Fig To Level Mower HousingTo Replace Mower Blade Drive Belt See Fig Belt InstallationBelt Removal To Replace Motion Drive Belt See Fig To Check and Adjust Brake See FigTransaxle Motion Control Lever Neutral Adjustment See Fig To Adjust BrakeTo Adjust Steering Wheel Alignment Transmission REMOVAL/REPLACEMENTFront Wheel TOE-IN/CAMBER To Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorEngine OIL StorageOther Fuel SystemProblem Cause Correction Troubleshooting PointsWith attachment clutch Limited Warranty Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe Operation

PO175H42STA specifications

The Poulan PO175H42STA is a robust and reliable riding lawn mower designed to provide efficient mowing for homeowners with medium to large-sized lawns. This lawn tractor boasts a variety of features and technologies that enhance its performance, comfort, and ease of use.

One of the standout features of the PO175H42STA is its powerful 17.5 horsepower Briggs & Stratton engine. This reliable engine ensures efficient cutting, even in thicker grass. The engine is designed for easy starting and smooth operation, allowing for a hassle-free mowing experience.

The cutting deck of the Poulan PO175H42STA measures 42 inches, making it ideal for tackling larger areas in a shorter amount of time. The deck's design includes a reinforced frame for added durability, and it offers an adjustable cutting height, allowing users to customize the mowing experience according to their lawn's needs. With six different height settings, ranging from 1.5 inches to 4 inches, users can achieve the perfect cut for their specific grass type and desired look.

The ergonomic design of the Poulan mower also contributes to user comfort. The adjustable high-back seat provides ample support during long mowing sessions, while the soft-touch steering wheel reduces vibrations, enhancing the overall mowing experience. Additionally, the foot-operated deck lift feature allows for seamless adjustments of the cutting height without having to leave the seat, making it highly convenient.

This riding mower is equipped with an automatic transmission, providing a smooth and effortless driving experience. The user-friendly controls make it easy for individuals of all skill levels to operate the mower effectively. The front headlights improve visibility while mowing early in the morning or later in the evening, ensuring that mowing can occur at any time of the day.

In terms of maintenance, the Poulan PO175H42STA includes features that simplify upkeep. The deck wash port makes it easy to clean the underside of the mowing deck, preventing grass clippings from building up and affecting performance. Additionally, its sturdy construction promises longevity, making it a worthwhile investment for those looking to maintain a pristine lawn.

Overall, the Poulan PO175H42STA riding lawn mower combines power, comfort, and user-friendly features, making it a top choice for homeowners who value efficiency and performance in their lawn care routine.