Poulan PO1742STB To Level Mower Housing, To Replace Mower Blade Drive Belt See Fig, Belt Removal

Page 19

SERVICE AND ADJUSTMENTS

TO LEVEL MOWER HOUSING

Adjust the mower while tractor is parked on level ground or driveway. Make sure tires are properly inflated (See “PRODUCT SPECIFICATIONS” section of this manual). If tires are over or underinflated, you will not properly adjust your mower.

SIDE-TO-SIDE ADJUSTMENT (See Figs. 16 and 17)

•Raise mower to its highest position.

•At the midpoint of both sides of mower, measure height from bottom edge of mower to ground. Distance “A” on both sides of mower should be the same or within 1/4" of each other.

•If adjustment is necessary, make adjustment on one side of mower only.

•To raise one side of mower, tighten lift link adjustment nut on that side.

•To lower one side of mower, loosen lift link adjustment nut on that side.

NOTE: Each full turn of adjustment nut will change mower height about 1/8".

•Recheck measurements after adjusting.

BOTTOM EDGE

 

BOTTOM EDGE

OF MOWER TO

 

OF MOWER TO

GROUND

 

GROUND

A

GROUND LINE

A

FIG. 16

SUSPENSION ARM

LIFT LINK

ADJUSTMENT NUT

FIG. 17

FRONT-TO-BACK ADJUSTMENT (See Figs. 18and 19)

IMPORTANT: DECK MUST BE LEVEL SIDE-TO-SIDE. IF THE FOLLOWING FRONT-TO-BACK ADJUSTMENT IS NECESSARY, BE SURE TO ADJUST BOTH FRONT LINKS EQUALLY SO MOWER WILL STAY LEVEL SIDE-TO-SIDE.

To obtain the best cutting results, the mower housing should be adjusted so that the front is approximately 1/8" to 1/2" lower than the rear when the mower is in its high- est position.

Check adjustment on right side of tractor. Measure distance “D” directly in front and behind the mandrel at bottom edge of mower housing as shown.

•Before making any necessary adjustments, check that both front links are equal in length.

•If links are not equal in length, adjust one link to same length as other link.

•To lower front of mower loosen nut “E” on both front links an equal number of turns.

•When distance “D” is 1/8" to 1/2" lower at front than rear, tighten nuts “F” against trunnion on both front links.

•To raise front of mower, loosen nut “F” from trunnion on both front links. Tighten nut “E” on both front links an equal number of turns. The two front links must remain equal in length.

•When distance “D” is 1/8" to 1/2" lower at front than rear, tighten nut “F” against trunnion on both front links.

•Recheck side-to-side adjustment.

MANDREL

“D”

“D”

FIG. 18

BOTH FRONT LINKS MUST BE EQUAL IN LENGTH

NUT “F”

NUT “E”

TRUNNION

FRONT LINKS

FIG. 19

TO REPLACE MOWER BLADE DRIVE BELT (See Fig. 20)

The mower blade drive belt may be replaced without tools. Park the tractor on level surface. Engage parking brake.

BELT REMOVAL -

•Remove mower from tractor (See “TO REMOVE MOWER” in this section of this manual).

•Work belt off both mandrel pulleys and idler pulleys.

•Pull belt away from mower.

BELT INSTALLATION -

•Install new belt in reverse order of removal.

•Make sure belt is in all pulley grooves and inside all belt guides.

•Install mower in reverse order of removal instruc- tions.

19

Page 18 Page 20
Image 19
Page 18 Page 20
Contents Model NO. PO1742STB Safety Rules Safety Rules Table of Contents Contents of Hardware Pack Before Removing Tractor from Skid AssemblyTools Required for Assembly To Remove Tractor from CartonInstall Seat See Fig HOW to SET UP Your TractorCheck Battery See Fig Check Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor HOW to USE Your Tractor Before Starting the Engine To Start Engine See Fig Mowing TipsBefore Each USE MaintenanceLubrication Chart General RecommendationsTractor Transaxle Cooling Clean AIR ScreenEngine BeltsSpark Plugs CleaningEngine Cooling Fins See Fig MufflerTo Install Mower See Fig Service and AdjustmentsTo Remove Mower See Fig Belt Removal To Level Mower HousingBelt Installation To Replace Mower Blade Drive Belt See FigTo Replace Motion Drive Belt See Fig To Check and Adjust Brake See FigTransaxle Gear Shift Lever NEUTRAL- Adjustment See Fig To Adjust BrakeTo Attach Jumper Cables To Adjust Steering Wheel ALIGN- MentReplacing Battery See Figs Front Wheel TOE-IN/CAMBERTo Replace Fuse To Adjust CarburetorTo Replace Headlight Bulb Interlocks and RelaysEngine OIL StorageOther Fuel SystemTroubleshooting Points OFF Service Notes Tractor - Model Number PO1742STB SchematicElectrical KEY Part Description Chassis and Enclosures 179101 170 173937 DriveSteering Assembly 186737 Optional Equipment EngineSeatlt.bolt1 Seat AssemblyWheels & Tires DecalsMower Lift Mower Deck 153535 Limited Warranty Policy Suggested Guide for Sighting Slopes for Safe Operation

PO1742STB specifications

The Poulan PO1742STB is a versatile and powerful lawn tractor, designed to provide efficient performance for homeowners seeking to maintain their lawns with ease. Equipped with a robust 17.5-horsepower Briggs & Stratton engine, the PO1742STB delivers reliable starting and ample power for tackling a variety of yard tasks. This engine is engineered for durability and efficiency, ensuring that users can depend on it season after season.

One of the standout features of the Poulan PO1742STB is its 42-inch cutting deck. This mid-size deck is perfect for a range of lawn sizes, allowing for efficient mowing without compromising on maneuverability. The cutting height can be easily adjusted with a convenient lever, providing users the flexibility to choose the optimal grass length for their lawns. The deck is designed with durable materials to withstand wear and tear, ensuring longevity and consistent performance.

In terms of technology, the PO1742STB is equipped with an automatic transmission system, allowing for smooth transitions between speeds. This feature enables users to focus on their mowing without the distraction of manually shifting gears, enhancing the overall mowing experience. The consumer-friendly layout of the controls makes it accessible for lawn care enthusiasts of all skill levels.

Another noteworthy characteristic of the Poulan PO1742STB is its ergonomic design. The seat is cushioned and adjustable, providing comfort during extended mowing sessions. Additionally, the placement of the controls is thoughtfully engineered to reduce strain on the operator, making lawn maintenance less of a chore.

For added convenience, the PO1742STB also highlights a large grass catcher attachment. This accessory aids in collecting grass clippings and debris, making cleanup a breeze and contributing to a neat and polished lawn appearance.

Overall, the Poulan PO1742STB combines power, efficiency, and user-friendly features, making it an excellent choice for homeowners looking to invest in a reliable lawn tractor. With its innovative technologies and thoughtful design, it ensures that lawn care is manageable and effective, allowing users to enjoy their outdoor spaces to the fullest.
Top Page Image Contents