Poulan PO1742STB manual To Adjust Steering Wheel ALIGN- Ment, Front Wheel TOE-IN/CAMBER

Page 21

SERVICE AND ADJUSTMENTS

•Loosen adjustment bolt in front of the right rear wheel.

•Position the gear shift lever in the neutral (N) posi- tion.

•Tighten adjustment bolt securely.

NOTE: If additional clearance is needed to get to adjustment bolt, move mower deck height to the lowest position.

NEUTRAL

LOCK GATE

GEARSHIFT LEVER

ADJUSTMENT

BOLT

FIG. 23

TO ADJUST STEERING WHEEL ALIGN- MENT

If steering wheel crossbars are not horizontal (left to right) when wheels are positioned straight forward, remove steer- ing wheel and reassemble per instructions in the Assembly section of this manual.

FRONT WHEEL TOE-IN/CAMBER

The front wheel toe-in and camber are not adjustable on your tractor. If damage has occurred to affect the front wheel toe-in or camber, contact your nearest authorized service center/department.

TO REMOVE WHEEL FOR REPAIRS (See Fig. 24)

TO START ENGINE WITH A WEAK BATTERY (See Fig. 25)

WARNING: Lead-acid batteries gen- erate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the Maintenance section of this manual).

If “jumper cables” are used for emergency starting, follow this procedure:

IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.

TO ATTACH JUMPER CABLES -

•Connect one end of the RED cable to the POSITIVE

(+)terminal of each battery(A-B), taking care not to short against tractor chassis.

•Connect one end of the BLACK cable to the NEGATIVE (-) terminal (C) of fully charged battery.

•Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

•BLACK cable first from chassis and then from the fully charged battery.

•RED cable last from both batteries.

•Block up axle securely.

•Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not lose).

•Repair tire and reassemble.

•On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.

WEAK OR DEAD BATTERY

FULLY CHARGED

BATTERY

•Replace washers and snap retaining ring securely in axle groove.

•Replace axle cover.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

RETAINING WASHERS

RING

AXLE

COVER

SQUARE KEY (REAR

WHEEL ONLY)

FIG. 24

21

FIG. 25

REPLACING BATTERY (See Figs. 26 and 27)

WARNING: Do not short battery terminals by allowing a wrench or any other object to contact both terminals at the same time. Before connect- ing battery, remove metal bracelets, wristwatch bands, rings, etc.

Positive terminal must be connected first to prevent sparking from acci- dental grounding.

•Lift seat pan to raised position.

•Disconnect BLACK battery cable first then RED battery cable and carefully remove battery from tractor.

•Install new battery with terminals in same position as old battery.

Page 20 Page 22
Image 21
Page 20 Page 22
Contents Model NO. PO1742STB Safety Rules Safety Rules Table of Contents Contents of Hardware Pack Tools Required for Assembly AssemblyTo Remove Tractor from Carton Before Removing Tractor from SkidHOW to SET UP Your Tractor Install Seat See FigCheck Battery See Fig Check Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor Before Starting the Engine To Start Engine See Fig Mowing TipsLubrication Chart MaintenanceGeneral Recommendations Before Each USETractor Engine Clean AIR ScreenBelts Transaxle CoolingEngine Cooling Fins See Fig CleaningMuffler Spark PlugsService and Adjustments To Install Mower See FigTo Remove Mower See Fig Belt Installation To Level Mower HousingTo Replace Mower Blade Drive Belt See Fig Belt RemovalTransaxle Gear Shift Lever NEUTRAL- Adjustment See Fig To Check and Adjust Brake See FigTo Adjust Brake To Replace Motion Drive Belt See FigReplacing Battery See Figs To Adjust Steering Wheel ALIGN- MentFront Wheel TOE-IN/CAMBER To Attach Jumper CablesTo Replace Headlight Bulb To Adjust CarburetorInterlocks and Relays To Replace FuseOther StorageFuel System Engine OILTroubleshooting Points OFF Service Notes Tractor - Model Number PO1742STB SchematicElectrical KEY Part Description Chassis and Enclosures 179101 170 173937 DriveSteering Assembly 186737 Optional Equipment EngineSeatlt.bolt1 Seat AssemblyWheels & Tires DecalsMower Lift Mower Deck 153535 Limited Warranty Policy Suggested Guide for Sighting Slopes for Safe Operation

PO1742STB specifications

The Poulan PO1742STB is a versatile and powerful lawn tractor, designed to provide efficient performance for homeowners seeking to maintain their lawns with ease. Equipped with a robust 17.5-horsepower Briggs & Stratton engine, the PO1742STB delivers reliable starting and ample power for tackling a variety of yard tasks. This engine is engineered for durability and efficiency, ensuring that users can depend on it season after season.

One of the standout features of the Poulan PO1742STB is its 42-inch cutting deck. This mid-size deck is perfect for a range of lawn sizes, allowing for efficient mowing without compromising on maneuverability. The cutting height can be easily adjusted with a convenient lever, providing users the flexibility to choose the optimal grass length for their lawns. The deck is designed with durable materials to withstand wear and tear, ensuring longevity and consistent performance.

In terms of technology, the PO1742STB is equipped with an automatic transmission system, allowing for smooth transitions between speeds. This feature enables users to focus on their mowing without the distraction of manually shifting gears, enhancing the overall mowing experience. The consumer-friendly layout of the controls makes it accessible for lawn care enthusiasts of all skill levels.

Another noteworthy characteristic of the Poulan PO1742STB is its ergonomic design. The seat is cushioned and adjustable, providing comfort during extended mowing sessions. Additionally, the placement of the controls is thoughtfully engineered to reduce strain on the operator, making lawn maintenance less of a chore.

For added convenience, the PO1742STB also highlights a large grass catcher attachment. This accessory aids in collecting grass clippings and debris, making cleanup a breeze and contributing to a neat and polished lawn appearance.

Overall, the Poulan PO1742STB combines power, efficiency, and user-friendly features, making it an excellent choice for homeowners looking to invest in a reliable lawn tractor. With its innovative technologies and thoughtful design, it ensures that lawn care is manageable and effective, allowing users to enjoy their outdoor spaces to the fullest.
Top Page Image Contents