Poulan PPH25K54 manual Table of Contents

Page 4

PRODUCT SPECIFICATIONS

Gasoline Capacity

4 Gallons

 

and type:

Unleaded Regular

Oil Type (API-SG-SL): SAE 30 (above 32°F)

 

SAE 5W-30 (below 32°F)

Oil Capacity:

W/ Filter:

64 oz

 

 

Spark Plug:

Champion RC12YC

 

(Gap: .030")

Ground Speed (MPH): Forward:

0 - 5.2

 

Reverse:

0 - 2.9

Charging System:

15 Amp @ 3600 RPM

 

 

 

Battery:

AMP/HR:

28

 

MIN. CCA:

230

 

Case Size: U1R

Blade Bolt Torque:

45-55 FT. LBS.

 

 

 

CONGRATULATIONS on your purchase of a new tractor. It has been designed, engineered and manufactured to give you the best possible dependability and performance.

Should you experience any problem you cannot easily rem- edy, please contact your nearest authorized servicecenter/ department We have competent, well-trained technicians and the proper tools to service or repair this tractor.

Please read and retain this manual. The instructions will enable you to assemble and maintain your tractor properly. Always observe the “SAFETY RULES”.

CUSTOMER RESPONSIBILITIES

•Read and observe the safety rules.

•Follow a regular schedule in maintaining, caring for and using your tractor.

•Follow the instructions under “Maintenance” and “Stor- age” sections of this owner’s manual.

WARNING: This tractor is equipped with an internal com- bustion engine and should not be used on or near any un- improved forest-covered, brush-covered or grass-covered land unless the engine’s exhaust system is equipped with a spark arrester meeting applicable local or state laws (if any). If a spark arrester is used, it should be maintained in effective working order by the operator.

In the state of California the above is required by law (Section 4442 of the California Public Resources Code). Other states may have similar laws. Federal laws apply on federal lands.

A spark arrester for the muffler is available through your nearest authorized service center/department (See REPAIR PARTS section of this manual).

TABLE OF CONTENTS

SAFETY RULES

2

PRODUCT SPECIFICATIONS

4

CUSTOMER RESPONSIBILITIES

4

ASSEMBLY

6-9

OPERATION

10-16

MAINTENANCE SCHEDULE

17

MAINTENANCE

17-20

SERVICE AND ADJUSTMENTS

21-25

STORAGE

26

TROUBLESHOOTING

27-28

4

Page 3 Page 5
Image 4
Page 3 Page 5
Contents PPH25K54 Safety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationService General ServiceIII. Children IV. TowingTable of Contents Mower Unassembled PartsSlope Sheet Assembly Tools Required for AssemblyTo Remove Tractor from Carton Before Removing Tractor from SkidTo Install Mower See Figs To Adjust Seat See FigAssemble Front Wheel to Mower See Fig First Install ANTI-SWAY BAR S Mower Drive Belt Installation Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor AqjkHOW to USE Your Tractor To SET Parking Brake See FigStopping See Fig To USE Throttle Control D See FigTo Adjust Mower Cutting Height See Fig To Adjust Gauge Wheels See FigTo Move Forward and Backward See Fig To USE Cruise Control J See FigService REMINDER/HOUR Meter Reverse Operation System ROSTowing Carts and Other Attachments To Operate MowerBefore Starting the Engine Check Engine OIL LevelADD Gasoline To Start Engine See FigMowing Tips Purge TransmissionMaintenance Lubrication ChartBattery TractorBlade Care Blade Removal See FigEngine Cleaning Clean AIR ScreenAIR Filter MufflerService and Adjustments To Install MowerTo Remove Mower See Fig To Replace Mower Blade Drive Belt See FigVisual SIDE-TO-SIDE Adjustment See Fig Precision SIDE-TO-SIDE Adjustment See FigTo Level Mower Turn nut right Turn nut left To raise mowerTo Adjust Steering Wheel Alignment To Check BrakeTo Replace Motion Drive Belt See Fig Front Wheel TOE-IN/CAMBERTo Start Engine with a Weak Battery See Fig Replacing Battery See FigTo Attach Jumper Cables To Remove CABLES, Reverse OrderTransmission Storage OtherFuel System Engine OILTroubleshooting Problem Cause CorrectionTo run when oper Battery will notFires when turn Engine continuesSuggested Guide for Sighting Slopes for Safe Operation Parts and Service Changere DE Pièces LES ET L’ENTRETIEN Degrés MAX Dépannage DE Guide Correction Cause ProblèmePuissance de Manque moteur LePas démarre Ne moteur le maisEntreposage Moteur Reglages ET RevisionSionmistrans Fig la Voir Batterie LA Replacer Rossage -AVANT/CAR Roues DES ConvergenceTionrecdi LA DE L’ALIGNEMENT Régler Pour 41 .FigFig la Voir Tionsrapa Fig la Voir D’ENTRAÎNEMENTCourroie Acer Rempl Pour RÉ LES Pour Roues LES Enlever PourTondeuse LA Niveau LE Ajuster Pour 37 .Fig36 .Fig 35 .FigTondeuse LA Installer Pour 33 .Fig32 .Fig Réglages OU SionsEntretien Fig La Voir Coupe DE Plateau DU Lavage DE Raccord’ALLUMAGE Bougie ’AIR Tamis LE Nettoyer29 et 28 .Fig la Voir Sionmistrans LA DE Moteur FluideFig la Voir Lame LA Enlever Lames DES EntretienPneus Frein DU FonctionnementUtilisation Chaque Avant Lubrification DE TableauGaz plein à gaz des commande la avec toujours Tondez UtilisationTransmission LA Purger 25 .Fig’ESSENCE Réservoir LE Remplir Moteur DU D’HUILE Niveau LE VérifierQueti Maauto Transmission LA DE RéchauffementAccessoires Autres ET Charrettes DES Remorquer Pour ROS Arrière Marche EN Fonctionnement DE SystèmeTracteur LE Transporter Pour Pentes LES Dans Utiliser PourJauge DE Roues LES Régler Pour Fig la Voir J Vitesse DE Régulateur LE Utiliser CommentTondeuse DE Lames LES Arrêter Pour Tondeuse LA Utiliser PourGAZ DES Commande LA Utiliser Pour 18 .FigFig la Voir Mentnetionsta DE Frein LE Embrayée Pour Moteur15 .Fig ’EMBRAYAGE Montage 12 .Fig 11 .Fig 10 .FigCourroie LA ET Tondeuse LA Installer LA DE Avant Roue LA AssemblezTionrecdi DE Volant LE Fixer Et 3 .Figs les Voir Siège LE AjustezCarton LE Deballer Assemblé PAS Pièces Pente-GuideUtilisation Entreposage MontageClient DU Responsabilités Produit DE SpécificationsSécurité DE Règles Tracteurs des sécurité touteEnfants En l’utilisation pour ConseilsAvertissement Pentes LES Dans FonctionnementTracteurs des sécurité toute en l’utilisation pour Conseils Général FonctionnementU the in Printed SR/AP 09.20.02 Avertissement

PPH25K54 specifications

The Poulan PPH25K54 is a standout model in the lawn care industry, designed specifically for homeowners who seek a reliable and powerful performing lawn mower. This machine is equipped with a potent 25 horsepower engine that delivers ample power for tackling thick grass and uneven terrain. Its robust design ensures durability, making it suitable for various lawn sizes and conditions.

A key feature of the Poulan PPH25K54 is its cutting width of 54 inches, allowing users to cover more ground in fewer passes. This is particularly beneficial for larger yards, reducing mowing time while maintaining a professional-looking lawn. The mower's cutting height is adjustable, offering a range of settings from 1.5 inches to 4 inches. This feature enables users to customize their mowing experience according to grass type and treatment preferences.

The PPH25K54 incorporates advanced technologies that enhance its performance and efficiency. The machine is equipped with a hydrostatic transmission system, allowing for smooth and seamless speed adjustments without the need for shifting gears. This feature not only improves ease of operation but also provides better control, especially on slopes and hilly terrain.

Safety is also a priority in the design of the Poulan PPH25K54. The mower is outfitted with a seat safety switch that prevents operation unless the operator is securely seated, significantly reducing the risk of accidents. Additionally, the durable steel frame adds stability during operation, ensuring users can maneuver the mower confidently.

Maintenance is simplified with the PPH25K54, featuring an easy-to-access oil filter and a spring-assisted deck lift for easier adjustments. This convenience allows homeowners to perform routine maintenance without extensive mechanical knowledge, promoting longevity and optimal performance.

In summary, the Poulan PPH25K54 combines power, efficiency, and user-friendly features that deliver an exceptional mowing experience. Its impressive engine, adjustable cutting height, and hydrostatic transmission make it an ideal choice for those looking to maintain their lawns with ease and precision. With its focus on safety and maintenance ease, this model is designed to meet the demands of any homeowner seeking a reliable and efficient lawn care solution.
Top Page Image Contents