Poulan PR17542STC owner manual Before Starting the Engine

Page 12

OPERATION

•With mower in desired height of cut position, gauge wheels should be assembled so they are slightly off the ground. Install gauge wheel in appropriate hole with shoulder bolt, 3/8 washer, and 3/8-16 locknut and tighten securely.

•Repeat for opposite side installing gauge wheel in same adjustment hole.

3/8-16

LOCKNUT

GAUGE WHEEL

MOUNTING

BRACKET

3/8 WASHER

SHOULDER

GAUGE WHEEL

BOLT

 

FIG. 6B

TO OPERATE MOWER (See Fig. 7)

Your tractor is equipped with an operator presence sensing switch. Any attempt by the operator to leave the seat with the engine running and the attachment clutch engaged will shut off the engine.

•Select desired height of cut.

•Lower mower with attachment lift control.

•Start mower blades by engaging attachment clutch control.

•TO STOP MOWER BLADES - disengage attachment clutch control.

CAUTION: Do not operate the mower without either the entire grass catcher, on mowers so equipped, or the deflector shield in place.

"ENGAGED" POSITION

 

ATTACHMENT

 

LIFT LEVER

 

HIGH POSITION

 

LOW

 

POSITION

ATTACHMENT

DEFLECTOR

CLUTCH LEVER

SHIELD

"DISENGAGED"

 

POSITION

 

FIG. 7

TO OPERATE ON HILLS

CAUTION: Do not drive up or down hills with slopes greater than 15° and do not drive across any slope.

•Choose the slowest speed before starting up or down hills.

•Avoid stopping or changing speed on hills.

•If slowing is necessary, move throttle control lever to slower position.

•If stopping is absolutely necessary, push clutch/brake pedal quickly to brake position and engage parking brake.

•Move gearshift lever to 1st gear. Be sure you have allowed room for tractor to roll slightly as you restart movement.

•To restart movement, slowly release parking brake and clutch/brake pedal.

•Make all turns slowly.

TO TRANSPORT

•Raise attachment lift to highest position with attachment lift control.

•When pushing or towing your tractor, be sure gearshift lever is in neutral (N) position.

•Do not push or tow tractor at more than five (5) MPH. NOTE: To protect hood from damage when transporting your tractor on a truck or a trailer, be sure hood is closed and secured to tractor. Use an appropriate means of tying hood to tractor (rope, cord, etc.).

TOWING CARTS AND OTHER ATTACH- MENTS

Tow only the attachments that are recommended by and comply with specifications of the manufacturer of your tractor. Use common sense when towing. Too heavy of a load, while on a slope, is dangerous. Tires can lose traction with the ground and cause you to lose control of your tractor.

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL

•The engine in your tractor has been shipped, from the factory, already filled with summer weight oil.

•Check engine oil with tractor on level ground.

•Remove oil fill cap/dipstick and wipe clean, reinsert the dipstick and screw cap tight, wait for a few seconds, remove and read oil level. If necessary, add oil until “FULL” mark on dipstick is reached. Do not overfill.

•For cold weather operation you should change oil for easier starting (See “OIL VISCOSITY CHART” in the Customer Responsibilities section of this manual).

•To change engine oil, see the Customer Responsibilities section in this manual.

ADD GASOLINE

•Fill fuel tank to bottom of filler neck. Do not overfill. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness.

CAUTION: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

IMPORTANT: WHEN OPERATING IN TEMPERATURES BELOW32°F(0°C), USE FRESH, CLEAN WINTER GRADE GASOLINE TO HELP INSURE GOOD COLD WEATHER STARTING.

CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to sepa- ration and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

12

Page 11 Page 13
Image 12
Page 11 Page 13
Contents PR17542STC Safety Rules IV. ServiceGeneral Operation II. Slope OperationSafety Rules Safe Operation Practices for Ride-On MowersTable of Contents Unassembled Hardware Steering WheelSeat Keys Slope SheetAssembly Tools Required for AssemblyHOW to SET UP Your Tractor To Remove Tractor from CartonInstall Seat See Fig To SET UP Your Mower for Mulching To Convert to Bagging or DischargingCheck Tire Pressure Check Deck LevelnessOperation Know Your Tractor HOW to USE Your Tractor Before Starting the Engine Mowing Tips To Start Engine See FigMulching Mowing Tips General Recommendations Lubrication Chart Service DatesCustomer Responsibilities Before Each USETractor Engine Cleaning Engine OIL FilterMuffler Spark PlugsService and Adjustments To Install Mower see FIGTo Remove Mower see FIG To Level Mower Housing FRONT-TO-BACK Adjustment See FigsTo Adjust Brake See Fig Belt InstallationTo Replace Mower Blade Drive Belt See Fig To Replace Motion Drive Belt See FigTransaxle Gear Shift Lever Neutral Adjustment See Fig To Adjust Steering Wheel AlignmentTo Start Engine with a Weak Battery See Fig Front Wheel TOE-IN/CAMBERReplacing Battery See Figs To Remove Hood and Grill Assembly See FigTo Replace Headlight Bulb Interlocks and RelaysTo Adjust Throttle Control Cable See Fig To Adjust Choke Control See FigTo Adjust Carburetor Storage OtherFuel System Engine OILTroubleshooting Points Problem Cause CorrectionWhen operator leaves Schematic Tractor - Model Number PR17542STC, Product Number 954 56Electrical KEY Part NO. NO. Description Chassis and Enclosures KEY Part Description Drive Repair Parts Steering Assembly Adaptor Wheel Strg Seat Assembly Decals Wheels and TiresEngine 170771 Control Th/ch Flag Mower Deck Repair Parts Mower Lift 159460 Wire Asm Inner/Sprg W/plunger LT Page Limited Warranty Policy Fold Along This Dotted Line Degree Only Ride UP and Down Hill Not Across Hill Degrees MAXParts and Service

PR17542STC specifications

The Poulan PR17542STC is a robust and efficient riding lawn mower designed to provide superior lawn care for homeowners with medium to large-sized yards. Known for its durability and performance, this model combines modern technology with user-friendly features, making it an excellent choice for both novice and experienced gardeners.

One of the standout characteristics of the PR17542STC is its powerful 17.5 HP Briggs & Stratton engine. This reliable engine ensures ample power to tackle various lawn types and terrains, providing a smooth and consistent mowing experience. Its automatic transmission allows for easy maneuverability, enabling the user to change speeds without the hassle of shifting gears manually. This feature is particularly beneficial when navigating around obstacles and tight corners.

The mower features a 42-inch cutting deck, which is optimal for achieving a clean and even cut across your lawn. The cutting deck comes equipped with three separate blades, allowing for efficient grass distribution and reducing the need for extensive clean-up afterward. Additionally, the cutting height can be easily adjusted to meet the specific needs of your lawn, offering a customizable mowing experience.

Comfort is prioritized in the design of the PR17542STC, as illustrated by its cushioned seat and ergonomic steering wheel. This ensures that users can enjoy longer mowing sessions without discomfort. The mower also includes a convenient dashboard that displays essential information, such as fuel levels and speed, keeping the user informed at all times.

Technologically advanced features such as a mulching kit are available, allowing homeowners to recycle grass clippings into nutrient-rich mulch. This not only promotes a healthier lawn but also helps reduce waste. Furthermore, the mower’s easy-to-access maintenance points make routine upkeep simple and straightforward, ensuring it remains in excellent condition for many seasons.

Overall, the Poulan PR17542STC stands out as a reliable and efficient riding lawn mower, thanks to its powerful engine, user-friendly features, and advanced technology. Whether you're maintaining a pristine lawn or managing challenging terrain, this mower offers the performance and comfort necessary to achieve your gardening goals, making it a valuable addition to any homeowner's lawn maintenance arsenal.
Top Page Image Contents