Poulan PK1942YT manual TO CHECK AND ADJUST BRAKE See Fig, TO REPLACE MOTION DRIVE BELT See Fig

Page 21
TO CHECK AND ADJUST BRAKE (See Fig. 21)

SERVICE AND ADJUSTMENTS

IDLER PULLEYS

MANDREL PULLEYS

FIG. 20

TO CHECK AND ADJUST BRAKE (See Fig. 21)

Your tractor is equipped with an adjustable brake system which is mounted on the right side of the transaxle.

If tractor requires more than five (5) feet to stop at highest speed in highest gear on a level, dry concrete or paved surface, then brake must be checked and adjusted.

TO CHECK BRAKE

•Park tractor on a level, dry concrete or paved surface, depress clutch/brake pedal all the way down and en- gage parking brake.

•Place gear shift lever in neutral (N) position.

The rear wheels must lock and skid when you try to manually push the tractor forward. If the rear wheels rotate, the brake needs to be adjusted or the pads need to be replaced.

TO ADJUST BRAKE

•Depress clutch/brake pedal all the way down and en- gage parking brake.

•Measure distance between brake operating arm and nut “A” on brake rod.

•If distance is other than 1-1/2", loosen jam nut and turn nut “A” until distance becomes 1-1/2". Retighten jam nut against nut “A”.

•Road test tractor for proper stopping distance as stated above. Readjust if necessary. If stopping distance is still greater than five (5) feet in highest gear, further maintenance is necessary. Replace brake pads or contact a qualified service center.

WITH PARKING BRAKE “ENGAGED”

1-1/2"

NUT “A”

JAM NUT

OPERATING ARM

TO REPLACE MOTION DRIVE BELT (See Fig. 22)

Park the tractor on level surface. Engage parking brake. For assistance, there is a belt installation guide decal on bottom side of left footrest.

BELT REMOVAL -

•Remove mower (See “TO REMOVE MOWER” in this section of manual).

NOTE: Observe entire motion drive belt and position of all belt guides and keepers.

•Remove belt from stationary idler and clutching idler.

•Remove belt downward from around engine pulley.

•Pull belt slack toward rear of tractor. Remove belt upwards from transaxle pulley by deflecting belt keep- ers.

•Remove belt from center span keeper and pull belt away from tractor.

BELT INSTALLATION -

•Carefully work new belt down between transaxle belt keepers and onto the input pulley.

•Slide belt into the center span keeper.

•Pull belt toward front of tractor and roll around the top groove of engine pulley.

•Install belt through stationary idler and clutching idler.

•Make sure belt is in all pulley grooves and inside all belt guides and keepers.

•Install mower (See “TO INSTALL MOWER” in this sec- tion of manual).

ENGINE

PULLEY

CLUTCHING

IDLER

STATIONARY

IDLER

CENTER SPAN

KEEPER

TRANSAXLE

PULLEY

FIG. 22

FIG. 21

21

Page 20 Page 22
Image 21
Page 20 Page 22
Contents IMPORTANT MANUAL MODELOPERATORS MANUAL LAWN TRACTORSafe Operation Practices for Ride-On Mowers SAFETY RULESI. GENERAL OPERATION II. SLOPE OPERATIONIII. CHILDREN V. SERVICEIV. TOWING GENERAL SERVICEPRODUCT SPECIFICATIONS TABLE OF CONTENTSCUSTOMER RESPONSIBILITIES 9-14Steering Wheel CONTENTS OF HARDWARE PACKSeat Slope SheetTOOLS REQUIRED FOR ASSEMBLY ASSEMBLYINSTALL SEAT See Fig TO REMOVE TRACTOR FROM CARTONASSEMBLE GAUGE WHEELS TO MOWER DECK See Fig CHECK BATTERY See FigCHECK DECK LEVELNESS CHECK TIRE PRESSURECHECK FOR PROPER POSITION OF ALL BELTS CHECK BRAKE SYSTEMOPERATION KNOW YOUR TRACTOR TO ADJUST MOWER CUTTING HEIGHT See Fig HOW TO USE YOUR TRACTORTO SET PARKING BRAKE See Fig TO USE THROTTLE CONTROL See FigREVERSE OPERATION SYSTEM ROS TO ADJUST GAUGE WHEELS See FigTO OPERATE MOWER See Fig USING THE REVERSE OPERATION SYSTEMTO OPERATE ON HILLS BEFORE STARTING THE ENGINETO TRANSPORT TOWING CARTS AND OTHER ATTACH- MENTSMOWING TIPS LUBRICATION CHART MAINTENANCEGENERAL RECOMMENDATIONS BEFORE EACH USEBLADE REMOVAL See Fig TRACTORTO SHARPEN BLADE See Fig BRAKE OPERATIONENGINE BATTERYV-BELTS TRANSAXLE COOLINGCLEAN AIR SCREEN CLEANINGAIR FILTER ENGINE OIL FILTERTO INSTALL MOWER See Fig SERVICE AND ADJUSTMENTSTO REMOVE MOWER See Fig Depress clutch/brake pedal fully and set parking brakeTO REPLACE MOWER BLADE DRIVE BELT See Fig TO LEVEL MOWER HOUSINGTO CHECK AND ADJUST BRAKE See Fig TO REPLACE MOTION DRIVE BELT See FigWITH PARKING BRAKE “ENGAGED” TO ADJUST STEERING WHEEL ALIGN- MENT TRANSAXLE GEAR SHIFT LEVER NEUTRAL- ADJUSTMENT See FigTO START ENGINE WITH A WEAK BATTERY See Fig FRONT WHEEL TOE-IN/CAMBERTO REMOVE HOOD AND GRILL ASSEMBLY See Fig REPLACING BATTERY See Figs. 26 andTO ADJUST THROTTLE CONTROL CABLE TO ADJUST CHOKE CONTROLOTHER STORAGEFUEL SYSTEM ENGINE OILPROBLEM TROUBLESHOOTING POINTSCAUSE CORRECTIONEngine dies when LIMITED WARRANTY SERVICE LIMITED WARRANTIES FOR NEW PEERLESS GEAR POWER TRAIN COMPONENTSWARRANTY POLICYONLY RIDE UP AND DOWN HILL NOT ACROSS HILL 15 DEGREES MAX SUGGESTED GUIDE FOR SIGHTING SLOPES FOR SAFE OPERATIONPARTS AND SERVICE
Top Page Image Contents