Poulan PK1942LT manual Troubleshooting Points, Problem, Cause, Correction

Page 25
TROUBLESHOOTING POINTS

TROUBLESHOOTING POINTS

PROBLEM

CAUSE

CORRECTION

 

 

 

 

 

 

Will not start

1.

Out of fuel.

1.

Fill fuel tank.

 

2.

Engine not “CHOKED” properly.

2.

See “TO START ENGINE” in Operation section.

 

3.

Engine flooded.

3.

Wait several minutes before attempting to start.

 

4.

Bad spark plug.

4.

Replace spark plug.

 

5.

Dirty air filter.

5.

Clean/replace air filter.

 

6.

Dirty fuel filter.

6.

Replace fuel filter.

 

7.

Water in fuel.

7.

Empty fuel tank and carburetor, refill tank with fresh

 

 

 

 

gasoline and replace fuel filter.

 

8.

Loose or damaged wiring.

8.

Check all wiring.

 

9.

Carburetor out of adjustment.

9.

See “To Adjust Carburetor” in Service Adjustments

 

 

 

 

section.

 

10.

Engine valves out of adjustment.

10.

Contact an authorized service center/department.

 

 

 

 

 

 

Hard to start

1.

Dirty air filter.

1.

Clean/replace air filter.

 

2.

Bad spark plug.

2.

Replace spark plug.

 

3.

Weak or dead battery.

3.

Recharge or replace battery.

 

4.

Dirty fuel filter.

4.

Replace fuel filter.

 

5.

Stale or dirty fuel.

5.

Empty fuel tank and refill tank with fresh, clean gasoline.

 

6.

Loose or damaged wiring.

6.

Check all wiring.

 

7.

Carburetor out of adjustment.

7.

See “To Adjust Carburetor” in Service Adjustments

 

 

 

 

section.

 

8.

Engine valves out of adjustment.

8.

Contact an authorized service center/department.

 

 

 

 

 

 

Engine will not turn over

1.

Clutch/brake pedal not depressed.

1.

Depress clutch/brake pedal.

 

2.

Attachment clutch is engaged.

2.

Disengage attachment clutch.

 

3.

Weak or dead battery.

3.

Recharge or replace battery.

 

4.

Blown fuse.

4.

Replace fuse.

 

5.

Corroded battery terminals.

5.

Clean battery terminals.

 

6.

Loose or damaged wiring.

6.

Check all wiring.

 

7.

Faulty ignition switch.

7.

Check/replace ignition switch.

 

8.

Faulty solenoid or starter.

8.

Check/replace solenoid or starter.

 

9.

Faulty operator presence switch(es).

9.

Contact an authorized service center/department.

 

 

 

 

 

 

Engine clicks but will not

1.

Weak or dead battery.

1.

Recharge or replace battery.

start

2.

Corroded battery terminals.

2.

Clean battery terminals.

 

3.

Loose or damaged wiring.

3.

Check all wiring.

 

4.

Faulty solenoid or starter.

4.

Check/replace solenoid or starter.

 

 

 

 

 

 

Loss of power

1.

Cutting too much grass/too fast.

1.

Raise cutting height/reduce speed.

 

2.

Throttle in “CHOKE” position.

2.

Adjust throttle control.

 

3.

Build-up of grass, leaves and trash under mower.

3.

Clean underside of mower housing.

 

4.

Dirty air filter.

4.

Clean/replace air filter.

 

5.

Low oil level/dirty oil.

5.

Check oil level/change oil.

 

6.

Faulty spark plug.

6.

Clean and regap or change spark plug.

 

7.

Dirty fuel filter.

7.

Replace fuel filter.

 

8.

Stale or dirty fuel.

8.

Empty fuel tank and refill tank with fresh, clean gasoline.

 

9.

Water in fuel.

9.

Empty fuel tank and carburetor, refill tank with fresh

 

 

 

 

gasoline and replace fuel filter.

 

10.

Spark plug wire loose.

10.

Connect and tighten spark plug wire.

 

11.

Dirty engine air screen/fins.

11.

Clean engine air screen/fins.

 

12.

Dirty/clogged muffler.

12.

Clean/replace muffler.

 

13.

Loose or damaged wiring.

13.

Check all wiring.

 

14.

Carburetor out of adjustment.

14.

See “To Adjust Carburetor” in Service Adjustments

 

 

 

 

section.

 

15.

Engine valves out of adjustment.

15.

Contact an authorized service center/department.

 

 

 

 

 

 

Excessive vibration

1.

Worn, bent or loose blade.

1.

Replace blade. Tighten blade bolt.

 

2.

Bent blade mandrel.

2.

Replace blade mandrel.

 

3.

Loose/damaged part(s).

3.

Tighten loose part(s). Replace damaged parts.

 

 

 

 

 

 

25

Image 25
Contents IMPORTANT MANUAL MODELOPERATORS MANUAL LAWN TRACTORSafe Operation Practices for Ride-OnMowers SAFETY RULESI. GENERAL OPERATION II. SLOPE OPERATIONIII. CHILDREN V. SERVICEIV. TOWING GENERAL SERVICEPRODUCT SPECIFICATIONS TABLE OF CONTENTSCUSTOMER RESPONSIBILITIES 9-14Steering Wheel CONTENTS OF HARDWARE PACKSeat Slope SheetTOOLS REQUIRED FOR ASSEMBLY ASSEMBLYINSTALL SEAT See Fig TO REMOVE TRACTOR FROM CARTONASSEMBLE GAUGE WHEELS TO MOWER DECK See Fig CHECK BATTERY See Fig.CHECK DECK LEVELNESS CHECK TIRE PRESSURECHECK FOR PROPER POSITION OF ALL BELTS CHECK BRAKE SYSTEMOPERATION KNOW YOUR TRACTOR TO ADJUST MOWER CUTTING HEIGHT See Fig HOW TO USE YOUR TRACTORTO SET PARKING BRAKE See Fig TO USE THROTTLE CONTROL See FigREVERSE OPERATION SYSTEM ROS TO ADJUST GAUGE WHEELS See FigTO OPERATE MOWER See Fig USING THE REVERSE OPERATION SYSTEMTO OPERATE ON HILLS BEFORE STARTING THE ENGINETO TRANSPORT TOWING CARTS AND OTHER ATTACH- MENTSMOWING TIPS LUBRICATION CHART MAINTENANCEGENERAL RECOMMENDATIONS BEFORE EACH USEBLADE REMOVAL See Fig TRACTORTO SHARPEN BLADE See Fig BRAKE OPERATIONENGINE BATTERYV-BELTS TRANSAXLE COOLINGCLEAN AIR SCREEN CLEANINGAIR FILTER ENGINE OIL FILTERTO INSTALL MOWER See Fig SERVICE AND ADJUSTMENTSTO REMOVE MOWER See Fig Place gearshift lever in neutral N positionTO REPLACE MOWER BLADE DRIVE BELT See Fig TO LEVEL MOWER HOUSINGTO REPLACE MOTION DRIVE BELT See Fig TO CHECK AND ADJUST BRAKE See FigTO START ENGINE WITH A WEAK BATTERY See Fig TO ADJUST STEERING WHEEL ALIGN- MENTFRONT WHEEL TOE-IN/CAMBER TO REMOVE WHEEL FOR REPAIRS See FigTO REMOVE HOOD AND GRILL ASSEMBLY See Fig. REPLACING BATTERY See Figs. 26 andTO ADJUST THROTTLE CONTROL CABLE TO ADJUST CHOKE CONTROLOTHER STORAGEFUEL SYSTEM ENGINE OILPROBLEM TROUBLESHOOTING POINTSCAUSE CORRECTIONEngine dies when LIMITED WARRANTY LIMITED WARRANTIES FOR NEW PEERLESS GEAR POWER TRAIN COMPONENTSSERVICE WARRANTY15 DEGREES MAX ONLY RIDE UP AND DOWN HILL NOT ACROSS HILLPARTS AND SERVICE