Poulan PB19H42LTS manual Mowing Tips, Purge Transmission, Automatic Transmission Warm UP

Page 14

OPERATION

•The attachments and ground drive can now be used. If the engine does not accept the load, restart the engine and allow it to warm up for one minute using the choke as described above.

COLD WEATHER STARTING ( 50° F and below)

•When engine starts, allow engine to run with the throttle control in the choke position until the engine runs roughly, then move throttle control to fast posi- tion. This may require an engine warm-up period from several seconds to several minutes, depending on the temperature.

AUTOMATIC TRANSMISSION WARM UP

•Before driving the unit in cold weather, the transmission should be warmed up as follows:

•Be sure the tractor is on level ground.

•Place the motion control lever in neutral. Release the parking brake and let the clutch/brake slowly return to operating position.

•Allow one minute for transmission to warm up.This can be done during the engine warm up period.

•The attachments can also be used during the engine warm-up period after the transmission has been warmed up.

NOTE: If at a high altitude (above 3000 feet) or in cold temperatures (below 32 F) the carburetor fuel mixture may need to be adjusted for best engine performance. See “TO ADJUST CARBURETOR” in the Service and Adjustments section of this manual.

PURGE TRANSMISSION

CAUTION: Never engage or disengage freewheel lever while the engine is run-

ning.

To ensure proper operation and performance, it is recom- mended that the transmission be purged before operating tractor for the fi rst time. This procedure will remove any trapped air inside the transmission which may have de- veloped during shipping of your tractor.

IMPORTANT: SHOULD YOUR TRANSMISSION REQUIRE REMOVAL FOR SERVICE OR REPLACEMENT, IT SHOULD BE PURGED AFTER REINSTALLATION BEFORE OPERATING THE TRACTOR.

1.Place tractor safely on a level surface - that is clear and open - with engine off and parking brake set.

2.Disengage transmission by placing freewheel control in freewheeling position (See “TOTRANSPORT” in this section of manual).

3.Sitting in the tractor seat, start engine. After the engine is running, move throttle control to slow position. With motion control lever in neutral (N) position, slowly dis- engage clutch/brake pedal.

CAUTION: At any time, during step 4, there may be movement of the drive wheels.

4.Move motion control lever to full forward position and hold for fi ve (5) seconds. Move lever to full reverse position and hold for fi ve (5) seconds. Repeat this procedure three (3) times.

5.Move motion control lever to neutral (N) position. Shut- off engine and set parking brake.

6.Engage transmission by placing freewheel control in engaged position (See “TO TRANSPORT” in this sec- tion of manual).

7.Sitting in the tractor seat, start engine. After the engine is running, move throttle control to half (1/2) speed. With motion control lever in neutral (N) position, slowly disengage clutch/brake pedal.

8.Slowly move motion control lever forward, after the tractor moves approximately five (5) feet, slowly move motion control lever to reverse position. After the trac- tor moves approximately five (5) feet return the mo- tion control lever to the neutral (N) position. Repeat this procedure with the motion control lever three (3) times.

Your transmission is now purged and now ready for normal operation.

MOWING TIPS

•Mower should be properly leveled for best mowing per- formance. See “TO LEVEL MOWER HOUSING” in the Service and Adjustments section of this manual.

•The left hand side of mower should be used for trim- ming.

•Drive so that clippings are discharged onto the area that has been cut. Have the cut area to the right of the machine. This will result in a more even distribution of clippings and more uniform cutting.

•When mowing large areas, start by turning to the right so that clippings will discharge away from shrubs, fences, driveways, etc. After one or two rounds, mow in the opposite direction making left hand turns until fi nished (See Fig. 9).

FIG. 9

•If grass is extremely tall, it should be mowed twice to reduce load and possible fi re hazard from dried clip- pings. Make first cut relatively high; the second to the desired height.

•Do not mow grass when it is wet. Wet grass will plug mower and leave undesirable clumps. Allow grass to dry before mowing.

•Always operate engine at full throttle when mow- ing to assure better mowing performance and proper discharge of material. Regulate ground speed by se- lecting a low enough gear to give the mower cutting performance as well as the quality of cut desired.

•When operating attachments, select a ground speed that will suit the terrain and give best performance of the attachment being used.

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents PB19H42LTS Always Wear EYE Protection During OperationGeneral Operation Safety RulesSafe Operation Practices for Ride-On Mowers II. Slope OperationIII. Children ServiceGeneral Service IV. TowingTable of Contents Slope Sheet Unassembled PartsSteering Wheel Seat To Remove Tractor from Carton AssemblyTools Required for Assembly Before Removing Tractor from SkidCheck Battery See Fig Check for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To Operate Mower See Fig To Adjust Gauge Wheels See FigUsing the Reverse Operation System Reverse Operation System ROSCheck Engine OIL Level Before Starting the EngineTo Transport See Figs ADD GasolineAutomatic Transmission Warm UP Mowing TipsPurge Transmission General Recommendations MaintenanceLubrication Chart Before Each USETo Sharpen Blade See Fig TractorBlade Removal See Fig Engine Cleaning To Level Mower Housing Service and AdjustmentsTo Install Mower See Fig To Remove Mower See FigBelt Removal Belt InstallationTo Replace Mower Blade Drive Belt See Fig To Adjust Brake To Check and Adjust Brake See FigTransaxle Motion Control Lever Neutral Adjustment See Fig To Replace Motion Drive Belt See FigTo Start Engine with a Weak Battery See Fig Transmission REMOVAL/REPLACEMENTTo Adjust Steering Wheel ALIGN- Ment Front Wheel TOE-IN/CAMBERTo Adjust Carburetor To Adjust Throttle Control CableTo Adjust Choke Control To Replace Headlight BulbFuel System StorageOther Engine OILTroubleshooting Points Problem Cause CorrectionEngine dies when Limited Warranty Service Notes Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAXParts and Service

PB19H42LTS specifications

The Poulan PB19H42LTS is a robust and reliable lawn tractor designed to meet the needs of both homeowners and property managers. This lawn tractor combines power, efficiency, and user-friendly features, making yard maintenance simpler and more enjoyable.

One of the standout features of the PB19H42LTS is its powerful 19 horsepower Briggs & Stratton engine. This engine provides ample power for cutting through thick grass and handling various terrains. With a reliable overhead valve design, it ensures better fuel efficiency and lower emissions, making it an eco-friendly option for lawn care.

The tractor boasts a 42-inch cutting deck, which is ideal for maneuvering through smaller yards while still covering a broad area. This size strikes a balance between providing efficient cutting capabilities and maintaining ease of operation. The cutting deck is equipped with three adjustable blades, allowing users to choose their desired cutting height with ease. The height of the deck can be adjusted from 1 to 4 inches, providing versatility for different lawn conditions.

The PB19H42LTS features a rugged and durable chassis, made to withstand the rigors of frequent use. Its sturdy frame supports stability and a smooth ride, even on uneven terrain. The rear-wheel drive enhances traction, giving users confidence when mowing on inclines or wet grass.

User comfort is prioritized with an ergonomic seating arrangement. The adjustable high-back seat is designed for long-term comfort, reducing fatigue during extended mowing sessions. The steering wheel is easy to grip and maneuver, facilitating precision handling.

Another key technology integrated into the Poulan PB19H42LTS is its automatic transmission. This allows for seamless speed adjustments while driving and mowing, facilitating a smooth user experience. The foot-operated pedal system enables users to control speed without taking their hands off the wheel, making it easier to navigate around obstacles.

Safety is also a priority in the design of this lawn tractor. It includes features such as a safety key to prevent accidental starts and an automatic shut-off system that engages whenever the operator leaves the seat.

In summary, the Poulan PB19H42LTS is a feature-rich lawn tractor that brings power, efficiency, and comfort to your yard care routine. With its robust engine, adjustable cutting deck, user-friendly design, and safety features, the PB19H42LTS stands out as a reliable choice for anyone looking to maintain their lawn effectively. Whether you're tackling a small yard or a larger property, this lawn tractor provides the tools you need to achieve a beautifully manicured lawn with ease.
Top Page Image Contents