Poulan PB19H42LTS manual Transmission REMOVAL/REPLACEMENT, To Adjust Steering Wheel ALIGN- Ment

Page 22

SERVICE AND ADJUSTMENTS

•While holding motion control lever in place, loosen the adjustment bolt.

•Move motion control lever to the neutral (N) (lock gate) position.

•Tighten adjustment bolt securely.

NOTE: If additional clearance is needed to get to adjustment bolt, move mower deck height to the lowest position.

After above adjustment is made, if the tractor still creeps forward or backward while motion control lever is in neutral position, follow these steps:

•Loosen the adjustment bolt.

•Move the motion control lever 1/4 to 1/2 inch in the direction it is trying to creep.

•Tighten adjustment bolt securely.

•Start engine and test.

•If tractor still creeps, repeat above steps until satis- fied.

MOTION CONTROL

NEUTRAL

LEVER

LOCK GATE

 

ADJUSTMENT

BOLT

FIG. 23

TRANSMISSION REMOVAL/REPLACEMENT

Should your transmission require removal for service or replacement, it should be purged after reinstallation and before operating the tractor. See“PURGETRANSMISSION” in the Operation section of this manual.

TO ADJUST STEERING WHEEL ALIGN- MENT

If steering wheel crossbars are not horizontal (left to right) when wheels are positioned straight forward, remove steer- ing wheel and reassemble per instructions in the Assembly section of this manual.

FRONT WHEEL TOE-IN/CAMBER

The front wheel toe-in and camber are not adjustable on your tractor.If damage has occurred to affect the front wheel toe-in or camber, contact your nearest authorized service center/department.

TO REMOVE WHEEL FOR REPAIRS (See Fig. 24)

NOTE: To seal tire punctures and prevent fl at tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

WASHERS

RETAINING

RING

AXLE COVER

SQUARE KEY (REAR

WHEEL ONLY)

FIG. 24

TO START ENGINE WITH A WEAK BATTERY (See Fig. 25)

WARNING: Lead-acid batteries gen- erate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the MAINTENANCE sec- tion of this manual).

If “jumper cables” are used for emergency starting, follow this procedure:

IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.

TO ATTACH JUMPER CABLES -

•Connect one end of the RED cable to the POSITIVE

(+)terminal of each battery(A-B), taking care not to short against tractor chassis.

•Connect one end of the BLACK cable to the NEGATIVE (-) terminal (C) of fully charged battery.

•Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

•BLACK cable first from chassis and then from the fully charged battery.

•RED cable last from both batteries.

•Block up axle securely.

•Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not lose).

•Repair tire and reassemble.

•On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.

•Replace washers and snap retaining ring securely in axle groove.

•Replace axle cover.

WEAK OR DEAD BATTERY

FULLY CHARGED

BATTERY

FIG. 25

22

Page 21 Page 23
Image 22
Page 21 Page 23
Contents PB19H42LTS Always Wear EYE Protection During OperationGeneral Operation Safety RulesSafe Operation Practices for Ride-On Mowers II. Slope OperationIII. Children ServiceGeneral Service IV. TowingTable of Contents Steering Wheel Seat Unassembled PartsSlope Sheet To Remove Tractor from Carton AssemblyTools Required for Assembly Before Removing Tractor from SkidCheck Battery See Fig Check for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To Operate Mower See Fig To Adjust Gauge Wheels See FigUsing the Reverse Operation System Reverse Operation System ROSCheck Engine OIL Level Before Starting the EngineTo Transport See Figs ADD GasolinePurge Transmission Mowing TipsAutomatic Transmission Warm UP General Recommendations MaintenanceLubrication Chart Before Each USEBlade Removal See Fig TractorTo Sharpen Blade See Fig Engine Cleaning To Level Mower Housing Service and AdjustmentsTo Install Mower See Fig To Remove Mower See FigTo Replace Mower Blade Drive Belt See Fig Belt InstallationBelt Removal To Adjust Brake To Check and Adjust Brake See FigTransaxle Motion Control Lever Neutral Adjustment See Fig To Replace Motion Drive Belt See FigTo Start Engine with a Weak Battery See Fig Transmission REMOVAL/REPLACEMENTTo Adjust Steering Wheel ALIGN- Ment Front Wheel TOE-IN/CAMBERTo Adjust Carburetor To Adjust Throttle Control CableTo Adjust Choke Control To Replace Headlight BulbFuel System StorageOther Engine OILTroubleshooting Points Problem Cause CorrectionEngine dies when Limited Warranty Service Notes Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAXParts and Service

PB19H42LTS specifications

The Poulan PB19H42LTS is a robust and reliable lawn tractor designed to meet the needs of both homeowners and property managers. This lawn tractor combines power, efficiency, and user-friendly features, making yard maintenance simpler and more enjoyable.

One of the standout features of the PB19H42LTS is its powerful 19 horsepower Briggs & Stratton engine. This engine provides ample power for cutting through thick grass and handling various terrains. With a reliable overhead valve design, it ensures better fuel efficiency and lower emissions, making it an eco-friendly option for lawn care.

The tractor boasts a 42-inch cutting deck, which is ideal for maneuvering through smaller yards while still covering a broad area. This size strikes a balance between providing efficient cutting capabilities and maintaining ease of operation. The cutting deck is equipped with three adjustable blades, allowing users to choose their desired cutting height with ease. The height of the deck can be adjusted from 1 to 4 inches, providing versatility for different lawn conditions.

The PB19H42LTS features a rugged and durable chassis, made to withstand the rigors of frequent use. Its sturdy frame supports stability and a smooth ride, even on uneven terrain. The rear-wheel drive enhances traction, giving users confidence when mowing on inclines or wet grass.

User comfort is prioritized with an ergonomic seating arrangement. The adjustable high-back seat is designed for long-term comfort, reducing fatigue during extended mowing sessions. The steering wheel is easy to grip and maneuver, facilitating precision handling.

Another key technology integrated into the Poulan PB19H42LTS is its automatic transmission. This allows for seamless speed adjustments while driving and mowing, facilitating a smooth user experience. The foot-operated pedal system enables users to control speed without taking their hands off the wheel, making it easier to navigate around obstacles.

Safety is also a priority in the design of this lawn tractor. It includes features such as a safety key to prevent accidental starts and an automatic shut-off system that engages whenever the operator leaves the seat.

In summary, the Poulan PB19H42LTS is a feature-rich lawn tractor that brings power, efficiency, and comfort to your yard care routine. With its robust engine, adjustable cutting deck, user-friendly design, and safety features, the PB19H42LTS stands out as a reliable choice for anyone looking to maintain their lawn effectively. Whether you're tackling a small yard or a larger property, this lawn tractor provides the tools you need to achieve a beautifully manicured lawn with ease.
Top Page Image Contents