Poulan PB19H42LTS Service and Adjustments, To Remove Mower See Fig, To Install Mower See Fig

Page 19

SERVICE AND ADJUSTMENTS

WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUST- MENTS:

•Depress clutch/brake pedal fully and set parking brake.

•Place motion control lever in neutral (N) position.

•Place attachment clutch in “DISENGAGED” position.

•Turn ignition key to “STOP” and remove key.

•Make sure the blades and all moving parts have completely stopped.

•Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.

TRACTOR

TO REMOVE MOWER (See Fig. 15)

Mower will be easier to remove from the right side of trac- tor.

•Place attachment clutch in “DISENGAGED” position.

•Move attachment lift lever forward to lower mower to its lowest position.

•Roll belt off engine pulley.

•Remove small retainer spring, and remove clutch spring off pulley bolt.

•Remove large retainer spring, slide collar off and push housing guide out of bracket.

•Disconnect anti-swaybar from chassis bracket by re- moving retainer spring.

•Disconnect suspension arms from rear deck brackets by removing retainer springs.

•Disconnect front links from deck by removing retainer springs.

•Raise lift lever to raise suspension arms. Slide mower out from under tractor.

IMPORTANT: IF AN ATTACHMENT OTHERTHANTHE MOWER DECK IS TO BE MOUNTED ON THE TRACTOR, REMOVE THE FRONTLINKSANDHOOKTHECLUTCHSPRINGINTOSQUARE HOLE IN FRAME.

TO INSTALL MOWER (See Fig. 15)

•Raise attachment lift lever to its highest position.

•Slide mower under tractor with defl ector shield to right side of tractor.

•Lower lift lever to its lowest position.

•Connect front links to mower deck and secure with retainer springs..

•Connect suspension arms to rear deck brackets and secure with retainer springs.

•Connect anti-swaybar to chassis bracket and secure with retainer spring.

•Push clutch cable housing guide into bracket, slide col- lar onto guide and secure with large retainer spring.

•Place fl at washer and clutch spring on idler pulley bolt and secure with small retainer spring.

•Install belt onto engine pulley.

TO LEVEL MOWER HOUSING

Adjust the mower while tractor is parked on level ground or driveway. Make sure tires are properly infl ated (See “PRODUCT SPECIFICATIONS” section of this manual). If tires are over or underinfl ated, you will not properly adjust your mower.

 

SMALL RETAINER SPRING

 

 

 

 

CLUTCH SPRING

 

 

 

 

FLAT WASHER

 

 

SQUARE HOLE

SMALL RETAINER SPRING

 

SUSPENSION

ENGINE PULLEY

 

 

 

ARMS

 

 

 

 

CLUTCH SPRING

 

 

 

 

 

 

 

FRONT LINK

RETAINER SPRING

 

 

 

 

ANTI-SWAY BAR

 

 

 

 

 

 

 

 

RETAINER SPRINGS

COLLAR

 

 

 

(BOTH SIDES)

HOUSING GUIDE

LARGE RETAINER

 

 

 

SPRING

BRACKET

 

DEFLECTOR SHIELD

 

 

 

 

 

 

 

FIG. 15

19

Page 18 Page 20
Image 19
Page 18 Page 20
Contents Always Wear EYE Protection During Operation PB19H42LTSII. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationIV. Towing ServiceGeneral Service III. ChildrenTable of Contents Steering Wheel Seat Unassembled PartsSlope Sheet Before Removing Tractor from Skid AssemblyTools Required for Assembly To Remove Tractor from CartonCheck Battery See Fig Check Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor HOW to USE Your Tractor Reverse Operation System ROS To Adjust Gauge Wheels See FigUsing the Reverse Operation System To Operate Mower See FigADD Gasoline Before Starting the EngineTo Transport See Figs Check Engine OIL LevelPurge Transmission Mowing TipsAutomatic Transmission Warm UP Before Each USE MaintenanceLubrication Chart General RecommendationsBlade Removal See Fig TractorTo Sharpen Blade See Fig Engine Cleaning To Remove Mower See Fig Service and AdjustmentsTo Install Mower See Fig To Level Mower HousingTo Replace Mower Blade Drive Belt See Fig Belt InstallationBelt Removal To Replace Motion Drive Belt See Fig To Check and Adjust Brake See FigTransaxle Motion Control Lever Neutral Adjustment See Fig To Adjust BrakeFront Wheel TOE-IN/CAMBER Transmission REMOVAL/REPLACEMENTTo Adjust Steering Wheel ALIGN- Ment To Start Engine with a Weak Battery See FigTo Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorEngine OIL StorageOther Fuel SystemProblem Cause Correction Troubleshooting PointsEngine dies when Limited Warranty Service Notes Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationParts and Service

PB19H42LTS specifications

The Poulan PB19H42LTS is a robust and reliable lawn tractor designed to meet the needs of both homeowners and property managers. This lawn tractor combines power, efficiency, and user-friendly features, making yard maintenance simpler and more enjoyable.

One of the standout features of the PB19H42LTS is its powerful 19 horsepower Briggs & Stratton engine. This engine provides ample power for cutting through thick grass and handling various terrains. With a reliable overhead valve design, it ensures better fuel efficiency and lower emissions, making it an eco-friendly option for lawn care.

The tractor boasts a 42-inch cutting deck, which is ideal for maneuvering through smaller yards while still covering a broad area. This size strikes a balance between providing efficient cutting capabilities and maintaining ease of operation. The cutting deck is equipped with three adjustable blades, allowing users to choose their desired cutting height with ease. The height of the deck can be adjusted from 1 to 4 inches, providing versatility for different lawn conditions.

The PB19H42LTS features a rugged and durable chassis, made to withstand the rigors of frequent use. Its sturdy frame supports stability and a smooth ride, even on uneven terrain. The rear-wheel drive enhances traction, giving users confidence when mowing on inclines or wet grass.

User comfort is prioritized with an ergonomic seating arrangement. The adjustable high-back seat is designed for long-term comfort, reducing fatigue during extended mowing sessions. The steering wheel is easy to grip and maneuver, facilitating precision handling.

Another key technology integrated into the Poulan PB19H42LTS is its automatic transmission. This allows for seamless speed adjustments while driving and mowing, facilitating a smooth user experience. The foot-operated pedal system enables users to control speed without taking their hands off the wheel, making it easier to navigate around obstacles.

Safety is also a priority in the design of this lawn tractor. It includes features such as a safety key to prevent accidental starts and an automatic shut-off system that engages whenever the operator leaves the seat.

In summary, the Poulan PB19H42LTS is a feature-rich lawn tractor that brings power, efficiency, and comfort to your yard care routine. With its robust engine, adjustable cutting deck, user-friendly design, and safety features, the PB19H42LTS stands out as a reliable choice for anyone looking to maintain their lawn effectively. Whether you're tackling a small yard or a larger property, this lawn tractor provides the tools you need to achieve a beautifully manicured lawn with ease.
Top Page Image Contents