CDR-882Primary Features, Safety Guidelines

Introduction

CDR-882 Primary Features

•Two shock-mounted recordable disc drives

•64x128 pixel backlit dot matrix LCD display

•11-segment dual LED bargraph meters with PPM characteristics

•Separate LED indication of drive status and headphone source

•Balanced (+4dBu) and unbalanced (-10dBu) analogue inputs and outputs

•24-bit A/D conversion with dither on recording

•S/PDIF digital input and output (coaxial and optical TOSlink), with full DAT track ID and PQ-code recognition/ transmission, and SCMS defeat

•AES/EBU digital input and output

•Switchable dither on digital inputs

•Word clock input

•Built-in sample-rate conversion (32-96kHz) on inputs

•DiscSpan mode - continuous recording across two or more discs, with automatic fade-in/fade-out and definable overlap period and track ID point on each disc

•Manual change-over operation available with DiscSpan

•DualBurn mode - simultaneous recording onto both drives

•Multi-Machine modes for longer unattended recording time and/or multiple disc (>2) recording

•CD copy function with track editing option

•Fast auto-finalise modes - one disc finalises while other disc records

•Parallel remote control port with user-defined functionality

•2 x RS232 serial remote control ports (for master and slave operation)

•10 second RAM shock buffer

•Accepts all blank CD-R media (HHB CDR80HS recommended)

•Analogue and digital input level controls

•Front panel headphone output with level control

•Comprehensive infra-red remote control handset (RC-882)

•Full SCMS control on recordings

•CD Text support

•Front and rear PS/2 keyboard inputs (for text input)

•2U 19” rack mount chassis

•Universal power supply

Cautions and guidance on installation

Safety Guidelines

•Operate only on a secure and level surface or securely fastened into a rack, noting the precautions below

•This equipment must be earthed (grounded)

•This equipment must be powered from a polarised AC supply

•Only suitably trained personnel should service this equipment

•Please read and take note of all warning and informative labels

•Before starting any servicing operation, this equipment must be isolated from the AC supply (mains) by removing the incoming IEC mains connector

•Fuses should only be replaced with ones of the same type and rating as that indicated

•Operate only in a clean, dry and pollutant-free environment

•Do not operate in an explosive atmosphere

•Do not allow any liquid or solid objects to enter the equipment. Should this accidentally occur then immediately switch off the unit and contact your service agent

Installation

If the CDR-882 is being installed in a rack, care should be taken not to block the ventilation slots on the rear, top and left-hand side. Although the CDR-882 itself does not generate a significant degree of heat, it should never be installed immediately above or below another piece of equipment that does, such as a power amplifier. It is good practice in any case to fit vent blanks of at least 1U above and below such equipment in a rack (unless they short-circuit that equipments’ own fan-cooling, in which case plain blanks should be fitted).

Care with ventilation should similarly be taken if the unit is free- standing; never stack it on top of or underneath another piece of equipment which generates a significant amount of heat.

Take care when routing cables around the unit; never drape cables across the front panel of the CDR-882 as they may obstruct the disc tray eject mechanisms.

Do not install or use the CDR-882 in a position where it is in direct sunlight or high-intensity artificial light. Never attempt to move the unit while it is in operation.

CDR-882 User Manual Version 1.0