HHB comm CDR-882 Care & cleaning, Installing the Remote Control batteries, Introduction

Introduction

Care & cleaning	Installing the Remote Control batteries
Always switch off and disconnect the unit from the mains before	To insert the batteries in the infra-red remote control handset:
cleaning. The outside surfaces of the unit may be cleaned with	• Slide off the battery compartment lid on the rear of the
a soft dry cloth. For stubborn marks (such as from a liquid
spillage), a soft damp cloth may be used in conjunction with a	handset
mild detergent solution (dilute a household detergent cleaner 5:1	• Insert two AA batteries, taking care to orientate them
with water). Wipe thoroughly dry with a dry cloth after. NEVER
	the correct way (refer to markings within the battery
use solvent cleaners of any kind.
	compartment)
Always switch the unit off and disconnect it from the AC supply	• Slide battery compartment lid back on
before moving it. NEVER move the unit while it is in use, as
this may permanently damage the disc(s) and/or the laser
mechanisms.
CDs should ALWAYS be handled with care. Hold discs only by
the edge or the centre hole. Never put discs “face down” on any
surface as they can scratch easily. Smudges and fingerprints
may be removed from a disc’s playing surface by wiping it gently
with a soft, lint-free cloth “across” the disc radius. Never rub
circumferentially. Stubborn marks can be removed by applying
a small amount of isopropyl alcohol (distilled water is often as
effective), again with a soft, lint-free cloth. Alternatively, use
a commercially available CD cleaning kit. NEVER use solvent
cleaners of any kind.

Important! Please observe the following guidelines when replacing batteries:

• Always change both batteries at the same time

• Always use two batteries of the same brand and type

• Dispose of the old batteries in a responsible manner

– always observe local environmental guidelines

 www.hhb.co.uk CDR-882 User Manual Version 1.0