Poulan PD24PH48ST manual Before Starting the Engine, To Operate on Hills, Check Engine OIL Level

Page 13

OPERATION

TO OPERATE ON HILLS

WARNING: Do not drive up or down hills with slopes greater than 15° and do not drive across any slope.

•Choose the slowest speed before starting up or down hills.

•Avoid stopping or changing speed on hills.

•If stopping is absolutely necessary, push brake pedal quickly to brake position and engage parking brake.

•To restart movement, slowly release parking brake and brake pedal.

•Slowly depress appropriate drive pedal to slowest set- ting.

•Make all turns slowly.

TO TRANSPORT (See Figs. 5 and 9)

When pushing or towing your tractor, be sure to disengage transmission by placing freewheel control in freewheeling position. Free wheel control is located at the rear drawbar of tractor.

•Raise attachment lift to highest position with attachment lift control.

•Pull freewheel control out and into the slot and release so it is held in the disengaged position.

•Do not push or tow tractor at more than two (2) MPH.

•To reengage transmission, reverse above procedure.

NOTE: To protect hood from damage when transporting your tractor on a truck or a trailer, be sure hood is closed and secured to tractor. Use an appropriate means of tying hood to tractor (rope, cord, etc.).

02219

FIG. 9

TOWING CARTS AND OTHER ATTACH- MENTS

Tow only the attachments that are recommended by and comply with specifications of the manufacturer of your trac- tor. Use common sense when towing. Too heavy of a load, while on a slope, is dangerous. Tires can lose traction with the ground and cause you to lose control of your tractor.

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL

The engine in your tractor has been shipped, from the factory, already filled with summer weight oil.

•Check engine oil with tractor on level ground.

•Remove oil fill cap/dipstick and wipe clean, reinsert the dipstick and screw cap tight, wait for a few seconds, remove and read oil level. If necessary, add oil until “FULL” mark on dipstick is reached. Do not overfill.

•For cold weather operation you should change oil for easier starting (See “OIL VISCOSITY CHART” in the Maintenance section of this manual).

•To change engine oil, see the Maintenance section in this manual.

ADD GASOLINE

•Fill fuel tank to bottom of filler neck. Do not overfill. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness.

CAUTION: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

IMPORTANT: WHEN OPERATING IN TEMPERATURES BELOW32°F(0°C), USE FRESH, CLEAN WINTER GRADE GASOLINE TO HELP INSURE GOOD COLD WEATHER STARTING.

CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract mois- ture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents PD24PH48ST Safe Operation Practices for Ride-On Mowers Safety RulesGeneral Operation II. Slope OperationGeneral Service ServiceIII. Children IV. TowingTable of Contents Steering Wheel Unassembled PartsSeat Slope SheetTools Required for Assembly AssemblyTo Remove Tractor from Carton Before Removing Tractor from SkidInstall Seat See Fig Check Tire Pressure To Convert to Bagging or DischargingCheck Mower Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor HOW to USE Your Tractor Using the Reverse Operation System To Adjust Gauge Wheels See FigTo Operate Mower See Fig Reverse Operation System ROSTo Operate on Hills Before Starting the EngineTowing Carts and Other ATTACH- Ments Check Engine OIL LevelPurge Transmission To Start Engine See FigAutomatic Transmission Warm UP Mulching Mowing Tips Mowing TipsLubrication Chart MaintenanceGeneral Recommendations Before Each USEBlade Removal See Fig TractorTo Sharpen Blade See Fig Engine Cleaning To Install Mower See Fig Service and AdjustmentsTo Remove Mower See Fig Recheck side-to-side adjustment To Level Mower HousingTo Replace Mower Blade Drive Belt See Fig To Check and Adjust Brake See FigTo Adjust Steering Wheel ALIGN- Ment Transmission REMOVAL/REPLACEMENTTo Replace Motion Drive Belt See Fig Front Wheel TOE-IN/CAMBERReplacing Battery See Fig To Start Engine with a Weak Battery See FigTo Attach Jumper Cables To Remove CABLES, Reverse OrderTo Adjust Choke Control To Adjust Throttle Control CableTo Adjust Carburetor To Replace Headlight BulbOther StorageFuel System Engine OILProblem Cause Correction Troubleshooting PointsEngine dies when Service Notes Limited Warranty Suggested Guide for Sighting Slopes for Safe Operation Parts and Service

PD24PH48ST specifications

The Poulan PD24PH48ST is a robust and versatile lawn tractor designed to tackle a variety of outdoor tasks with ease and efficiency. This model stands out for its powerful performance, innovative features, and user-friendly design, making it an excellent choice for homeowners looking to maintain their lawns and gardens without hassle.

One of the key features of the Poulan PD24PH48ST is its impressive 24 horsepower engine. This powerful engine delivers the necessary torque and speed to handle even the toughest mowing conditions. The tractor is equipped with a reliable hydrostatic transmission system, which allows for effortless speed control and smooth operation. With no gears to shift, users can simply press the pedal to accelerate or decelerate, making it easy to navigate through tight spaces and maneuver around obstacles.

The Poulan PD24PH48ST boasts a 48-inch cutting deck, which allows for efficient mowing over larger areas. The cutting deck features adjustable cutting heights, enabling users to select the desired grass length for their specific lawn type. This flexibility ensures an even cut and promotes healthy grass growth. Additionally, the deck is designed for easy clean-up, which is essential for maintaining optimal performance over time.

Another notable characteristic of the PD24PH48ST is its comfort-oriented design. The tractor is fitted with a high-back seat, providing essential lumbar support for extended periods of mowing. The easy-to-use dashboard and controls allow operators to adjust settings and monitor performance without taking their eyes off the task at hand. The tractor also features a tight turning radius, which makes it easy to maneuver around flower beds, trees, and other landscaping elements.

The Poulan PD24PH48ST incorporates several advanced technologies to enhance its functionality. The tractor features a durable steel frame for increased stability and lifetime performance. Its rugged tires provide excellent traction on various terrains, allowing users to tackle both flat and hilly landscapes with confidence. The tractor is also compatible with a range of attachments, including snow blowers, baggers, and plows, enhancing its versatility throughout the year.

In summary, the Poulan PD24PH48ST stands out as a reliable and efficient lawn tractor equipped with a powerful engine, a versatile cutting deck, and user-friendly features. Its combination of technology and comfort makes lawn care a breeze, ensuring homeowners can achieve the perfect lawn with minimal effort. This tractor is an excellent investment for anyone serious about maintaining their outdoor spaces.
Top Page Image Contents