Poulan CO185H42STC Transaxle Motion Control LE- VER Neutral Adjustment, Front Wheel TOE-IN/CAMBER

Page 23

4.Install belt through stationary idler and clutching idler.

5.Reinstall clutch locator and tighten nut securely.

6.Reconnect clutch harness.

7.Make sure belt is in all pulley grooves and inside all belt guides and keepers.

8.Install mower (See “TO INSTALL MOWER” in this section of manual).

Electric

Clutch Clutch

Locator

Clutching

Idler

Stationary

Idler

Center Span

 

Keeper

Clutch

Transmission

Wire

Harness

Input Pulley

 

01511

TRANSAXLE MOTION CONTROL LE- VER NEUTRAL ADJUSTMENT

The motion control lever has been preset at the factory and adjustment should not be necessary.

1.Loosen adjustment bolt in front of the right rear wheel, and lightly tighten.

2.Start engine and move motion con- trol lever until tractor does not move forward or backward.

3.Hold motion control lever in that posi- tion and turn engine off.

4.While holding motion control lever in place, loosen the adjustment bolt.

5.Move motion control lever to the neu- tral (N) (lock gate) position.

6.Tighten adjustment bolt securely. NOTE: If additional clearance is needed to get to adjustment bolt, move mower deck height to the lowest position.

After above adjustment is made, if the tractor still creeps forward or backward while motion control lever is in neutral position, follow these steps:

1.Loosen the adjustment bolt.

2.Move the motion control lever 1/4 to 1/2 inch in the direction it is trying to creep.

3.Tighten adjustment bolt securely.

4.Start engine and test.

5.If tractor still creeps, repeat above steps until satisfied.

Motion Control Lever

02239

Neutral

Lock

Adjustment Bolt

 

Gate

TO ADJUST STEERING WHEEL ALIGN- MENT

If steering wheel crossbars are not

horizontal (left to right) when wheels are positioned straight forward, remove steer- ing wheel and reassemble with crossbars horizontal. Tighten securely.

FRONT WHEEL TOE-IN/CAMBER

The front wheel toe-in and camber are not adjustable on your tractor. If damage has occurred to affect the front wheel toe-in or camber, contact your nearest authorized service center/department.

TO REMOVE WHEEL FOR REPAIRS

1.Block up axle securely.

2.Remove axle cover, retaining ring and washers to allow wheel removal (rear wheels have a square key - Do not lose).

3.Repair tire and reassemble.

NOTE: On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.

4.Replace washers and snap retaining ring securely in axle groove.

5.Replace axle cover.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

Retaining Washers

Ring

Axle

 

Cover

 

Square Key

00663

(Rear Wheel Only)

 

TO START ENGINE WITH A WEAK BATTERY

WARNING: Lead-acid batteries gen- erate explosive gases. Keep sparks, flame and smoking materials away from bat- teries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the MAINTENANCE section of this manual). If “jumper cables” are used for emergency starting, follow this procedure:

23

Image 23
Contents Model NO. CO185H42STC Warranty Table of ContentsII. Slope Operation Safety RulesGeneral Operation Do not IV. ServiceIII. Children Safety Rules API-SG-SL Product SpecificationsCustomer Responsibilities Unassembled Parts Before Removing Tractor from Skid Tools Required for AssemblyTo Remove Tractor from Carton Install Mulcher Plate If previously removed Check Tire Pressure ChecklistTo Convert to Bagging or Discharging Reposition Right Rear Gauge WheelOperation Know Your Tractor HOW to USE Your Tractor To Transport To Operate MowerTo Operate on Hills Check Engine OIL Level Before Starting the EngineTo Start Engine Towing Carts and Other ATTACH- MentsAutomatic Transmission Warm UP Mowing TipsMulching Mowing Tips Before Each USE MaintenanceGeneral Recommendations Tractor Engine Cleaning Service and AdjustmentsFRONT-TO-BACK Adjustment To Install MowerTo Level Mower Housing SIDE-TO-SIDE AdjustmentTo Replace Motion Drive Belt To Check and Adjust BrakeTo Replace Mower Blade Drive Belt Front Wheel TOE-IN/CAMBER Transaxle Motion Control LE- VER Neutral AdjustmentTo Adjust Steering Wheel ALIGN- Ment To Start Engine with a Weak BatteryTo Adjust Carburetor Engine OIL BatteryOther Fuel SystemProblem Cause Correction Troubleshooting ChartExcessive Poor grass Suggested Guide for Sighting Slopes for Safe Operation

CO185H42STC specifications

The Poulan CO185H42STC is a robust and versatile lawn tractor that has become a favored choice for homeowners seeking an efficient and reliable grass-cutting machine. With its powerful engine and efficient design, the CO185H42STC is equipped to handle both small and large lawns with ease.

One of the standout features of the Poulan CO185H42STC is its reliable engine. Powered by an 18.5 horsepower Briggs & Stratton engine, this lawn tractor is built for performance. The engine design ensures optimal power delivery, allowing for smooth operation while navigating various terrains. The automatic choke system further enhances user convenience, ensuring that the lawn tractor starts easily in all weather conditions.

The cutting deck of the CO185H42STC spans an impressive 42 inches, which allows users to cover large areas in a shorter amount of time. The deck is constructed using durable materials that can withstand wear and tear, ensuring longevity. The tractor also features an adjustable cutting height, offering six different positions between 1.5 inches to 4 inches, providing flexibility to achieve the desired lawn finish.

A notable technology included in this model is the hydrostatic transmission system. Unlike the traditional gear system, this advanced transmission allows for smooth speed changes without the need for gear shifting, enabling a more enjoyable driving experience. This feature is especially beneficial when navigating around obstacles or when mowing uneven terrain.

Comfort is another key aspect of the Poulan CO185H42STC. The tractor is equipped with a high-back seat that provides excellent support during extended mowing sessions. The ergonomic steering wheel maximizes maneuverability and is designed to minimize operator fatigue, ensuring a comfortable ride.

The CO185H42STC also includes a convenient bagging attachment, which allows for easy collection of clippings, making yard cleanup quick and efficient. Additionally, its rugged construction means it can handle challenging mowing tasks without the risk of damage.

In summary, the Poulan CO185H42STC is a highly capable lawn tractor that combines power, technology, and user-friendly features. Ideal for homeowners looking to maintain a pristine lawn, it stands out with its powerful engine, adjustable cutting deck, hydrostatic transmission, and focus on operator comfort. This lawn tractor offers a perfect blend of performance and convenience, making it a noteworthy addition to any lawn care toolkit.