Poulan PB20H42LT manual To Replace Headlight Bulb, Interlocks and Relays, To Replace Fuse

Page 24

SERVICE AND ADJUSTMENTS

WEAK OR DEAD BATTERY

FULLY CHARGED

BATTERY

TO REPLACE HEADLIGHT BULB

Raise hood.

Pull bulb holder out of the hole in the backside of the grill.

Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

• Check wiring. See electrical wiring diagram in the

Repair Parts section.

FIG. 28

REPLACING BATTERY (See Figs. 29 and 30)

WARNING: Do not short battery terminals by allowing a wrench or any other object to contact both terminals at the same time. Before connect- ing battery, remove metal bracelets, wristwatch bands, rings, etc. Positive terminal must be connected first to prevent sparking from acci- dental grounding.

Lift seat pan to raised position.

Disconnect BLACK battery cable first then RED battery cable and carefully remove battery from tractor.

Install new battery with terminals in same position as old battery.

First connect RED battery cable to positive (+) terminal with hex bolt and keps nut as shown. Tighten securely. Slide terminal cover over terminal.

Connect BLACK grounding cable to negative (-) ter- minal with remaining hex bolt and keps nut. Tighten securely.

TO REPLACE FUSE

Replace with 20 amp automotive-type plug-in fuse. The fuse holder is located behind the dash.

TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 31)

Raise hood.

Unsnap headlight wire connector.

Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.

To replace, reverse above procedure.

HOOD

HEADLIGHT WIRE

CONNECTOR

01536

SEAT PAN

HEX

BOLT

 

FIG. 29

 

 

TERMINAL

KEPS NUT

COVER

 

POSITIVE (RED) CABLE

NEGATIVE (BLACK) CABLE

 

 

 

FIG. 30

FIG. 31

ENGINE

TO ADJUST THROTTLE CONTROL CABLE

The throttle control has been preset at the factory and adjustment should not be necessary. If adjustment is nec- essary, see engine manual.

TO ADJUST CHOKE CONTROL

The choke control has been preset at the factory and ad- justment should not be necessary. If adjustment is neces- sary, see engne manual.

TO ADJUST CARBURETOR

Your carburetor is not adjustable. If your engine does not operate properly due to suspected carburetor problems, take your tractor to an authorized service center for repair

24and/or adjustment.

Image 24
Contents PB20H42LT Safe Operation Practices for Ride-On Mowers General OperationII. Slope Operation Service III. ChildrenIV. Towing Table of Contents Contents of Hardware Pack Tools Required for Assembly To Remove Tractor fromCarton Before Removing Tractor from SkidCheck Battery See Fig Check Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor Using the Reverse Operation System Reverse Operation System ROSTo Operate on Hills To Operate Mower See FigBefore Starting the Engine To TransportTowing Carts and Other ATTACH- Ments Check Engine OIL LevelMowing Tips Purge TransmissionAutomatic Transmission Warm UP Maintenance Tractor Blade Removal See FigTo Sharpen Blade See Fig Check Operator Presence SystemBattery EngineBelts Transaxle CoolingCleaning To Install Mower See Fig To Remove Mower See FigInstall belt on engine pulley M, in belt keepers G Precision SIDE-TO-SIDE Adjustment To Level MowerBelt Installation To Replace Mower Drive Belt See FigTo Replace Motion Belt Drive See Fig To Check BrakeTransaxle Motion Control Lever Neutral Adjustment See Fig To Adjust Steering Wheel ALIGN- MentTo Start Engine with a Weak Battery See Fig Front Wheel TOE-IN/CAMBERTo Adjust Throttle Control Cable To Adjust Choke ControlTo Adjust Carburetor To Replace Headlight BulbOther Fuel SystemEngine OIL CylindersTroubleshooting Points Engine dies when Limited Warranty Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAXService Notes Service Notes Page Page Dentretien Remarques Dentretien Remarques UNE Autorisé Garantie cette de exclus sont normal l’entretien etInitiale d’achat date la de compter à jours 90 dix Dépannage DE Guide Endommagé ou lâche est câblage LeRalenti Starter DU Commande LA Régler Pour GAZ DES Commande LA DE Câble LE Régler PourEntreposage Carburateur LE Régler PourRéglages ET Révision Carrossage AVANT/ Roues DES Convergence DirectionLA DE L’ALIGNEMENT Régler Pour 27 .FIGCourroie Acer Rempl Pour ’ENTRAÎNEMENTFreins LES Vérifier Pour 25 .FIGTondeuse LA Niveau LE Ajuster Pour 23 .FIG21 .FIG 22 .FIG19 .FIG 17 .FIG 18 .FIG16 .FIG Coin le Soulevez C Arrières Bielles LES AttachezCourroie LA ET Tondeuse LA Installer Reglages ET RevisionTondeuse LA Enlever Pour Ligne EN Installé D’ESSENCE Filtre Entretien’ALLUMAGE Bougie AIR À FiltreTrapézoïdales Courroies Transmission LA DE RefroidissementBatterie LubrificationROS Arrière Marche EN Fonctionnement DE Système ETLubrification DE Tableau Utilisation Chaque Avant’utilisateur complète, garantie une conserver Pour Utilisation Transmission LA PurgerTonte DE Conseils TiqueAccessoires Autres Moteur LE Démarrer Pour’ESSENCE Réservoir LE Remplir Moteur DU D’HUILE Niveau LE VérifierMAR EN Fonctionnement DE Système Tondeuse LA Utiliser PourROS Arrière CHE Tondeuse DE Lames LES Arrêter PourGAZ DES Commande LA Utiliser Pour Tionsta DE Frein LE Engager PourReculer Pour ET Avancer Pour EntraînementTracteur Votre Connaissez Propriété la de lendommagement Montage Place ENCorrectement Sont Courroies LES Toutes SI Vérifier Toutes SI Vérifier’assemblage phase toute terminé d’avoir Sassurer LA DE Tracteur LE Retirer PourRouler faisant le en palette la de tracteur le Retirez Direction DE Volant LE Installer Rectiondi DE Volant LE FixerCarton LE Deballer Direction DEMontar SIN Piezas U1R Dimension SommaireCCA .MIN AMP/HR SL-SG-APIGénéral Entretien ’ESSENCE DE Sûre Manipulation’opérateur que autre responsable, adulte d’un supervision Solidement serrez et place en gaz deDes ou fossés des ravins, des proximité à jamais tondez Ne Jamais descendant, en et montant en pentes les TondezAUX Imprimé