MAINTENANCE
Ignition System
The engine is equipped with an electronic ignition system. Only the spark plug requires maintenance.
For recommended spark plug, see Technical Data.
1.Remove the ignition cable boot and clean around the spark plug.
2.Remove the spark plug with a spark plug socket wrench.
3.Check the spark plug. Replace the spark plug if fouled, the electrodes are burned and if the insulation is cracked or damaged. Clean the spark plug with a steel brush if it is to be reused.
4.Measure the electrode gap with a gapping tool. The gap should be .030” (0.75 mm). Adjust as necessary by bending the side electrode.
5.Reinsert the spark plug, turning by hand to avoid damaging the threads.
6.After the spark plug is seated, tighten it using a spark plug wrench so that the washer is compressed. A used spark plug should be turned 1/8 of a turn from the seated position. A new spark plug should be turned 1/4 a turn from the seated position.
7.Replace the ignition cable.
IMPORTANT INFORMATION
Fitting the wrong spark plug type can damage the engine.
Inadequately tightened spark plug can cause overheating and damage the engine. Tightening the spark plug too hard can damage the threads in the cylinder head.
Measure the electrode gap