Poulan 413420, 96042003401 owner manual Before Starting the Engine

Page 13

OPERATION

TO OPERATE ON HILLS

WARNING: Do not drive up or down hills with slopes greater than 15° and do not drive across any slope.

•Choose the slowest speed before starting up or down hills.

•Avoid stopping or changing speed on hills.

•If stopping is absolutely necessary, push clutch/brake pedal quickly to brake position and engage parking brake.

•Move gearshift lever to 1st gear. Be sure you have allowed room for tractor to roll slightly as you restart movement.

•To restart movement, slowly release parking brake and clutch/brake pedal.

•Make all turns slowly.

TO TRANSPORT

•Raise attachment lift to highest position with attachment lift control.

•When pushing or towing your tractor, be sure gearshift lever is in neutral (N) position.

•Do not push or tow tractor at more than five (5) MPH.

NOTE: To protect hood from damage when transporting your tractor on a truck or a trailer, be sure hood is closed and secured to tractor. Use an appropriate means of tying hood to tractor (rope, cord, etc.).

TOWING CARTS AND OTHER ATTACH- MENTS

Tow only the attachments that are recommended by and comply with specifications of the manufacturer of your trac- tor. Use common sense when towing. Too heavy of a load, while on a slope, is dangerous. Tires can lose traction with the ground and cause you to lose control of your tractor.

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL

The engine in your tractor has been shipped, from the factory, already filled with summer weight oil.

•Check engine oil with tractor on level ground.

•Remove oil fill cap/dipstick and wipe clean, reinsert the dipstick and screw cap tight, wait for a few seconds, remove and read oil level. If necessary, add oil until “FULL” mark on dipstick is reached. Do not overfill.

•For cold weather operation you should change oil for easier starting (See “OIL VISCOSITY CHART” in the Maintenance section of this manual).

•To change engine oil, see the Maintenance section in this manual.

ADD GASOLINE

•Fill fuel tank to bottom of filler neck. Do not overfill. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness.

CAUTION: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

IMPORTANT: WHEN OPERATING IN TEMPERATURES BELOW32°F(0°C), USE FRESH, CLEAN WINTER GRADE GASOLINE TO HELP INSURE GOOD COLD WEATHER STARTING.

CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can at- tract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

TO START ENGINE (See Fig. 5)

When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.

•Sit on seat in operating position, depress clutch/brake pedal and set parking brake.

•Place gear shift lever in neutral (N) position.

•Move attachment clutch to “DISENGAGED” position.

•Move throttle control to choke () position.

NOTE: Before starting, read the warm and cold starting procedures below.

•Insert key into ignition and turn key clockwise to “START” position and release key as soon as engine starts. Do not run starter continuously for more than fifteen seconds per minute. If the engine does not start after several attempts, move throttle control to fast position, wait a few minutes and try again. If engine still does not start, move the throttle control back to the choke ( ) position and retry.

WARM WEATHER STARTING (50° F and above)

•When engine starts, move the throttle control to the fast position.

•The attachments and ground drive can now be used. If the engine does not accept the load, restart the engine and allow it to warm up for one minute using the choke as described above.

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents PB19542LT Safe Operation Practices for Ride-On Mowers Safety RulesGeneral Operation II. Slope OperationGeneral Service ServiceIII. Children IV. TowingTable of Contents Contents of Hardware Pack Tools Required for Assembly AssemblyTo Remove Tractor from Carton Before Removing Tractor from SkidCheck Battery See Fig Install Seat See FigsCheck Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor Reverse Operation System ROS Using the Reverse Operation SystemTo Operate Mower See Fig Before Starting the Engine Mowing Tips Lubrication Chart MaintenanceBlade Removal See Fig TractorTo Sharpen Blade See Fig Engine BatteryBelts Transaxle CoolingCleaning To Install Mower See Fig Service and AdjustmentsTo Remove Mower See Fig Install belt on engine pulley M, in belt keepers G To Level Mower To Check Brake To Replace Mower Drive Belt See FigTo Replace Motion Belt Drive See Fig To Start Engine with a Weak Battery See Fig Transaxle Gear Shift Lever NEUTRAL- Adjustment See FigTo Adjust Steering Wheel ALIGN- Ment Front Wheel TOE-IN/CAMBERTo Adjust Choke Control To Adjust Throttle Control CableTo Adjust Carburetor To Replace Headlight BulbOther StorageFuel System Engine OILProblem Cause Correction Troubleshooting PointsEngine dies when Decals Tractor - Model Number PB19542LT 96042003401, Product no 42Wheels and Tires KEY Part DescriptionFuse SchematicElectrical 197802 ElectricalChassis 194263 Drawbar Drive Repair Parts Engine Engine Power Rating Information Steering Repair Parts Mower Deck Repair Parts Seat 9098 100 Mower LiftService Notes Service Notes Service Notes Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationLimited Warranty

413420, 96042003401 specifications

The Poulan 96042003401,413420 is a powerful and versatile equipment designed for both homeowners and professionals seeking high-performance tools for lawn care and maintenance. This model stands out in the market for its robust features, advanced technologies, and user-friendly characteristics.

One of the main features of the Poulan 96042003401,413420 is its efficient engine. The equipment is equipped with a reliable gas engine that provides ample power while ensuring smooth operation. This allows users to tackle various tasks such as trimming, edging, and cutting grass with ease. The engine's design emphasizes fuel efficiency, which helps users save on refueling costs over time.

In addition to its powerful engine, the Poulan 96042003401,413420 incorporates a user-friendly starting system. The easy start feature minimizes the effort required to get the machine up and running. This is particularly beneficial for users who may not be experienced with starting gas-powered equipment.

The design of the Poulan 96042003401,413420 places a strong emphasis on ergonomics. The equipment features comfortable grips that minimize strain during extended use, allowing for better maneuverability and control. This thoughtful design helps to reduce fatigue, making it easier for users to complete yard work efficiently.

The cutting technology employed in the Poulan 96042003401,413420 ensures precise and clean cuts. With an adjustable cutting height, users can customize the length of their grass to suit specific preferences or seasonal needs. This versatility makes the equipment suitable for various types of lawns and landscaping designs.

Durability is another key characteristic of the Poulan 96042003401,413420. Constructed from high-quality materials, this equipment is built to withstand the rigors of outdoor use. Users can depend on this model to perform consistently over time, even under challenging conditions.

Maintenance is simplified with this model as well. The Poulan 96042003401,413420 features easy-access components, allowing users to perform routine checks and maintenance tasks without difficulty. This ensures the longevity of the equipment and helps maintain optimal performance.

Overall, the Poulan 96042003401,413420 appeals to a wide range of users due to its powerful engine, ergonomic design, advanced cutting technology, durability, and ease of maintenance. Whether for a small garden or a larger landscape, this equipment is designed to meet various lawn care needs efficiently.
Top Page Image Contents