Poulan 96012008800 Reverse Operation System ROS, To Operate Mower See Fig, To Operate on Hills

Page 12

OPERATION

REVERSE OPERATION SYSTEM (ROS)

Your tractor is equipped with a Reverse Operation System (ROS). Any attempt by the operator to travel in the reverse direction with the attachment clutch engaged will shut off the engine unless ignition key is placed in the ROS "ON" position.

WARNING: Backing up with the attachment clutch en- gaged while mowing is strongly discouraged. Turning the ROS "ON", to allow reverse operation with the attachment clutch engaged, should only be done when the operator decides it is necessary to reposition the machine with the attachment engaged. Do not mow in reverse unless absolutely necessary.

USING THE REVERSE OPERATION SYSTEM -

•Depress clutch/brake pedal all the way down and hold.

•With engine running, turn ignition key counterclockwise to ROS "ON" position.

•Look down and behind before backing.

•Move gear shift lever to reverse (R) position and slowly release clutch/brake pedal to start movement.

•When use of the ROS is no longer needed, turn the ignition key clockwise to engine "ON" position.

ROS "ON" POSITION

ENGINE "ON" POSITION

 

(NORMAL OPERATING)

02828

TO OPERATE MOWER (See Fig. 6)

Your tractor is equipped with an operator presence sensing switch. Any attempt by the operator to leave the seat with the engine running and the attachment clutch engaged will shut off the engine. You must remain fully and centrally positioned in the seat to prevent the engine from hesitating or cutting off when operating your equipment on rough, rolling terrain or hills.

•Select desired height of cut.

•Start mower blades by engaging attachment clutch control.

•TO STOP MOWER BLADES - disengage attachment clutch control.

CAUTION: Do not operate the mower without either the entire grass catcher, on mowers so equipped, or the deflector shield in place.

"ENGAGED" POSITION

ATTACHMENT

LIFT LEVER HIGH POSITION

LOW

POSITION

ATTACHMENT CLUTCH LEVER "DISENGAGED" POSITION

DEFLECTOR

SHIELD

FIG. 6

TO OPERATE ON HILLS

WARNING: Do not drive up or down hills with slopes greater than 15° and do not drive across any slope.

•Choose the slowest speed before starting up or down hills.

•Avoid stopping or changing speed on hills.

•If slowing is necessary, move throttle control lever to slower position.

•If stopping is absolutely necessary, push clutch/brake pedal quickly to brake position and engage parking brake.

•Move gearshift lever to 1st gear. Be sure you have allowed room for tractor to roll slightly as you restart movement.

•To restart movement, slowly release parking brake and clutch/brake pedal.

•Make all turns slowly.

TO TRANSPORT

•Raise attachment lift to highest position with attachment lift control.

•When pushing or towing your tractor, be sure gearshift lever is in neutral (N) position.

•Do not push or tow tractor at more than five (5) MPH.

NOTE: To protect hood from damage when transporting your tractor on a truck or a trailer, be sure hood is closed and secured to tractor. Use an appropriate means of tying hood to tractor (rope, cord, etc.).

TOWING CARTS AND OTHER ATTACH- MENTS

Tow only the attachments that are recommended by and comply with specifications of the manufacturer of your trac- tor. Use common sense when towing. Too heavy of a load, while on a slope, is dangerous. Tires can lose traction with the ground and cause you to lose control of your tractor.

12

Page 11 Page 13
Image 12
Page 11 Page 13
Contents PO18542LT ModelSafe Operation Practices for Ride-On Mowers General OperationII. Slope Operation Service III. ChildrenIV. Towing Table of Contents Contents of Hardware Pack Tools Required for Assembly To Remove Tractor from CartonBefore Removing Tractor from Skid Unpack CartonCheck Battery See Fig Check Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor Reverse Operation System ROS To Operate Mower See FigTo Operate on Hills To TransportBefore Starting the Engine Check Engine OIL LevelADD Gasoline To Start Engine See FigMowing Tips Maintenance Schedule Lubrication ChartGeneral Recommendations Before Each USETractor Blade Removal See FigCheck Operator Presence System Check Reverse Operation ROS SystemBattery EngineBelts Transaxle CoolingCleaning Clean AIR ScreenAIR Filter MufflerTo Install Mower See Fig To Remove Mower See FigTo Level Mower Housing FRONT-TO-BACK Adjustment See FigsBelt Installation To Replace Mower Blade Drive Belt See FigTo Check Brake To Replace Motion Drive Belt See FigTransaxle Gear Shift Lever NEUTRAL- Adjustment See Fig To Adjust Steering Wheel ALIGN- MentTo Start Engine with a Weak Battery See Fig Front Wheel TOE-IN/CAMBERTo Adjust Throttle Control Cable To Adjust Choke ControlTo Adjust Carburetor To Replace Headlight BulbOther Fuel SystemEngine OIL CylindersTroubleshooting Points Problem Cause CorrectionEngine dies when Limited Warranty PoulanService Notes Only Ride UP and Down Hill Not Across Hill Degrees MAX Fold Along This Dotted Line Degree SlopeParts and Service Changere DE Pièces LES ET L’ENTRETIEN Degrés MAX Dentretien Notes Limitée Garantie Dépannage DE Guide Défectueux estRalenti Entreposage MoteurRéglages ET Révision MoteurCarrossage AVANT/ Roues DES Convergence Tionrec -DI LA DE L’ALIGNEMENT Régler Pour19 .Fig Chan DE Levier DU Neutre AU RéglageFig la Voir ’EN Courroie LA Remplacer PourCourroie Acer Rempl Pour DE Boîtier LE Niveau DE Mettre Pour SedeutonFig la Voir Tondeuse LA Installer Pour Reglages ET RevisionTracteur Tondeuse LA Enlever PourEntretien Transmission LA DE Refroidissement LubrificationTrapézoïdales Courroies 10 .FIGFig la Voir Lame LA Enlever EN Fonctionnement DE Système ETRecommandations LES GénéralesLubrification DE Tableau Utilisation Chaque AvantUtilisation Tonte DE ConseilsMoteur LE Démarrer DE Avant Moteur LE Démarrer Pour’ESSENCE Réservoir LE Remplir Moteur DU D’HUILE Niveau LE VérifierAccessoires Autres ET Charrettes DES Remorquer PourTracteur LE Transporter Pour Pentes LES Dans Utiliser PourGAZ DES Commande LA Utiliser Pour T O S I L I T UTeurtrac Reculer Pour ET Avancer Pour02829 Moteur Montage Correctement Sont Courroies LESToutes SI Vérifier Toutes SI Vérifier NI DE EST Tondeuse LA SI VérifierFig la Voir Batterie LA Vérifier Desmancom des fonction la etPalet LA DE Tracteur LE Retirer Pour DU Tracteur LE Sortir Pour LE Pour Exigés Outils LESPalette LA ToncarMontar SIN Piezas Sommaire Client DU ResponsabilitésProduit DE Spécifications Entretien RemorquageEnfants Général EntretienPentes LES Dans FonctionnementGénéral Fonctionnement Tracteurs des sécurité toute en l’utilisation pour ConseilsAUX Imprimé

96012008800, 425182 specifications

The Poulan 425182,96012008800 is a highly regarded handheld leaf blower that serves the needs of both homeowners and professionals seeking efficient yard cleanup solutions. Known for its lightweight design and user-friendly features, this leaf blower is designed to make yard work less of a chore while enhancing productivity.

One of the standout features of the Poulan 425182 is its powerful engine. Equipped with a robust 25cc two-stroke engine, it delivers impressive airflow and speed, allowing users to tackle even the most stubborn leaves and debris with ease. The engine is designed for efficient fuel consumption, which means longer run times and less frequent refueling, a crucial factor for those tackling larger yards or extended jobs.

The ergonomic design of the Poulan 425182 means that it is comfortable to hold and operate for extended periods. Weighing in at just under ten pounds, it reduces user fatigue and allows for better maneuverability while working. This is particularly beneficial for those looking to clear large areas or navigate around obstacles like flower beds, trees, and outdoor furniture.

Another significant aspect of the Poulan 425182 is its variable speed control. This feature enables users to adjust the blower's power to suit the specific job at hand, whether it's light debris around flower beds or heavy leaf accumulation in corners of the yard. The variable speed not only enhances efficiency but also contributes to more precise cleaning.

The blower also incorporates a convenient cruise control feature that allows users to maintain a consistent airflow without needing to keep their finger on the throttle trigger. This adds to user comfort and provides a more enjoyable experience during lengthy tasks.

In terms of maintenance, the Poulan 425182 offers easy access to air filters and spark plugs, making it simpler to perform routine checks and ensure optimal performance. The two-stroke engine simplifies fuel mixing, and the reduced emissions technology helps to minimize environmental impact while still delivering the power needed for effective yard care.

In summary, the Poulan 425182,96012008800 leaf blower is a reliable tool that combines power, efficiency, and ease of use. Its lightweight design, ergonomic features, variable speed control, and low emissions technology make it a top choice for anyone looking to maintain their outdoor spaces effortlessly. For versatile and effective yard cleanup, this leaf blower stands out in the competitive market of outdoor power equipment.
Top Page Image Contents